TV-PUF : A Fast Lightweight Aging-Resistant Threshold Voltage PUF

Tanujay Saha, Vikash Sehwag

This academic paper presents TV-PUF, a novel Physical Unclonable Function (PUF) design that leverages the inherent manufacturing variations in transistor threshold voltages to create secure, unique hardware "fingerprints."

TL;DR

Researchers have developed an analog PUF that is exceptionally fast, low-power, and resistant to the "aging" effects that typically degrade hardware security over time. By using a cascaded NMOS design, TV-PUF achieves near-ideal security metrics while consuming significantly less energy and area than traditional delay-based or memory-based PUFs.

What Problem Does This Paper Address?

In hardware security, Physical Unclonable Functions (PUFs) act like a digital DNA for silicon chips. They are used for device authentication and secret key generation. However, existing PUF designs face three major hurdles:

  1. Aging: Over years of use, transistors undergo physical degradation (like Hot Carrier Injection), which can change their performance and cause the PUF to "forget" its original unique key.
  2. Power and Area: Many PUFs require complex circuitry or high power consumption, making them difficult to integrate into low-power IoT devices or smart cards.
  3. Environmental Sensitivity: Changes in temperature or supply voltage can introduce noise, leading to inconsistent "responses" from the hardware.

The authors propose TV-PUF to solve these issues by focusing on the Threshold Voltage ($V_{th}$) of transistors as the primary source of randomness.

Methods

The core of the TV-PUF design is the Cascaded NMOS Pass Transistor block.

  • Signal Amplification: Instead of measuring a single transistor, the design cascades two NMOS transistors in series. This makes the output voltage roughly $V_{DD} - 2V_{th}$. This cascading effect amplifies the impact of process variations, making the unique "signature" easier to detect against background noise.
  • NMOS-Only Architecture: By using only NMOS transistors, the design completely avoids Negative-Bias Temperature Instability (NBTI), a major aging factor that primarily affects PMOS transistors.
  • Flush Transistors: The authors added "flush transistors" ($F_a$ and $F_b$) that reset the internal voltages to zero after every operation. This ensures that the PUF starts from a clean state for every new challenge, preventing "memory effects" that could lead to errors.
  • Differential Comparison: To generate a bit, the system compares the output voltages of two identical blocks using a sense amplifier.

Datasets

The authors evaluated their design using HSpice simulations with BSIM Level=54 model files. They tested the design across three different semiconductor technology nodes: 45nm, 65nm, and 90nm. To simulate manufacturing randomness, they used Monte Carlo simulations representing 100 different physical chips.

Key Insights and Ideas

  • The "Relative Stability" Insight: The most significant finding is that while individual transistors age and their threshold voltages shift (up to 50% over 5 years), the difference between two identical paths remains remarkably stable (shifting by only 0.2–0.3 mV). This allows the PUF to remain reliable for years.
  • High-Speed, Low-Latency: Because the "critical path" (the path the signal travels) only consists of two transistors, the delay is incredibly low (~100 ps). This allows the PUF to operate at clock speeds up to 1 GHz.
  • Technology Independence: Unlike many PUFs that need to be redesigned for different manufacturing processes, TV-PUF showed consistent performance across 45nm, 65nm, and 90nm nodes.

Key Results

  • Security Metrics: The design achieved a Uniqueness of ~51% and Uniformity of ~50%, both of which are nearly ideal for a PUF.
  • Efficiency: At a 1 GHz clock, the design consumes only 0.18 $\mu$W/bit.
  • Energy per Cycle: TV-PUF requires $1.81 \times 10^{-3}$ pJ per cycle, which is orders of magnitude lower than previous "Sub-threshold" PUF designs (0.047 pJ).
  • Hardware Footprint: A 1-bit generation circuit requires only 586 transistors, compared to 1,672 transistors in competing designs, representing a significant reduction in silicon area.

Limitations and Future Work

  • Sense Amplifier Dependency: The reliability of the system is highly dependent on the sensitivity of the sense amplifier. If the voltage difference between two blocks falls into a "gray zone" (less than the amplifier's sensitivity), the output becomes unpredictable.
  • Scaling Challenges: The current design uses a decoder to select blocks. For very long cryptographic keys, the hardware requirement for this decoder could grow significantly.
  • Future Directions: The authors suggest investigating different block combinations to reduce the exponential hardware growth required for larger challenge-response spaces. They also propose adding control circuits to specifically ignore "weak" challenges that fall into the sense amplifier's gray zone.

Summary updated

Abstract

Physical Unclonable Function (PUF) is the hardware analog of a one-way function which can address hardware security issues such as device authentication, generating secret keys, producing seeds for Random Number Generators, etc. Traditional silicon PUFs are based on delay (Ring Oscillator PUFs and Arbiter PUFs) or memory structures (e.g, SRAM PUFs). In this paper, we propose the design of an aging resistant, lightweight and low-power analog PUF that exploits the susceptibility of Threshold Voltage (Vth) of MOSFETs to process variations. Analysis shows improvement in power consumption, reliability over device aging along with quality metrics like uniformity, reliability and uniqueness for a 64-bit key generation. For 1 GHz clock input, this design consumes 0.18W/bit power with 50 % uniqueness and 51% uniformity along with the independence of these metrics on technology nodes. Experimental results suggest 4% variation in reliability under temperature variation from -55C to 125C and 20% variation in supply voltage. Aging analysis further projects the independence of reliability over device aging.
BibTeX
@article{saha2016tv,
  author = {Tanujay Saha and Vikash Sehwag},
  title = {{TV-PUF : A Fast Lightweight Aging-Resistant Threshold Voltage PUF}},
  journal = {IACR Cryptol. ePrint Arch.},
  year = {2016},
  url = {https://openreview.net/forum?id=p5N4tSHFjg},
}

Loading related content...

Figure