Abstract
The ionic species emitted from uranium dioxide ($UO_2$) on tungsten and rhenium filaments by surface ionization have been identified as $UO_2^+$, $UO^+$, and $U^+$. The ion $UO_3^+$ could not be observed in any conditions. By measuring the ionic currents of $^{238}U^{16}O_2^+$ and $^{238}U^{16}O^+$, the values of the heats of vaporization of $UO_2^+$ and $UO^+$ have been estimated. The value for $UO_2^+$ changes at about 2230 K for the tungsten filament and 2080 K for the rhenium, respectively, and the values for the higher temperature range are larger than those for the lower range, irrespective of the filament materials. The thermoelectronic properties of uranium dioxide have been studied. The work function of the filament covered with uranium dioxide changes at the specific temperature similarly to the ionic emission of $UO_2^+$. From the experimental data of the ionic emissions of $UO_2$ and $UO$, and those of the thermoelectronic emissions, the heats of vaporization of uranium dioxide and monoxide molecules from uranium dioxide on the tungsten and rhenium filaments have also been calculated.
Introduction
In the late 1960s, understanding the chemical stability of nuclear fuels like $UO_2$ was paramount for reactor safety and the development of thermoelectronic energy converters. While researchers knew $UO_2$ vaporized at high temperatures, the exact nature of the emitted ions and how the supporting metal filament (tungsten or rhenium) influenced this process remained unclear. This paper bridges the gap between mass spectrometry and thermoelectronic studies to create a more complete picture of how $UO_2$ breaks down and vaporizes in a vacuum.
Experimental Methodology
The researchers employed two distinct experimental setups:
- Mass Spectrometry: A single-focusing mass spectrometer was used to identify ionic species. $UO_2$ was prepared by applying uranyl nitrate to filaments and thermally decomposing it in situ. Ionic currents were measured as a function of temperature.
- Thermoelectronic Emission: Using a custom-built apparatus with cylindrical stainless steel electrodes, the team generated Schottky and Richardson plots. This allowed for the calculation of the work function ($\phi$)—the energy barrier electrons must overcome to leave the surface.
To link these two experimental domains, the authors used the Saha-Langmuir equation, which relates the heat of vaporization of neutral molecules ($l_0$) to that of ions ($l_+$) using the work function and the ionization potential ($I$).
Results and Discussion
Identification of Ionic Species
The mass spectrometric analysis identified $UO_2^+$, $UO^+$, and $U^+$ as the primary emitted species. Interestingly, the addition of thorium dioxide ($ThO_2$) was found to significantly boost the emission of $U^+$ ions, as shown in the comparative spectra in Figure 2. This effect is useful for isotopic analysis, allowing researchers to study uranium isotopes without interference from oxygen isotopes found in oxide peaks.
Temperature Thresholds and Surface Adsorption
A striking finding was a sharp change in the heat of vaporization for $UO_2^+$ at specific temperatures: ~2230 K for tungsten and ~2080 K for rhenium. Below these temperatures, the energy required to emit ions is significantly lower than above them. This "kink" in the emission behavior is clearly visible in the Arrhenius-style plots of ionic current.
The authors propose that at high temperatures, $UO_2$ dissociates, and the resulting metallic uranium is strongly adsorbed onto the filament. This uranium layer drastically reduces the surface work function, which in turn changes the emission rates of both ions and electrons. For $UO_2$ on tungsten, the work function ($\phi$) was observed to drop from 7.99 eV at lower temperatures to 5.38 eV at higher temperatures.
Vaporization Heats
The calculated heat of vaporization for neutral $UO_2$ molecules was approximately 6.1 eV. This value is in good agreement with previous studies using Knudsen effusion cells (~5.95 eV), validating the methodology of using ionic and electronic data to infer neutral molecular behavior.
Conclusion and Limitations
The study highlights the sensitivity of $UO_2$ emission to filament material and temperature. However, the authors acknowledge that the Saha-Langmuir equation strictly applies to uniform surfaces, whereas a filament covered in $UO_2$ is inherently "patchy" and inhomogeneous. Despite these limitations, the research provides critical data on the thermal stability and surface chemistry of a key nuclear material.
Reference: Sasaki, N., Kubo, K., Asano, M., & Magari, S. (1969). Surface Ionization and Thermoelectronic Property of Uranium Dioxide. Mass Spectroscopy, 17(3), 745-753.
Summary updated