Introduction
Solar energy presents a viable heat source for residential buildings in cold climates; however, its intermittent nature necessitates efficient storage solutions. Rock-bed (solid) heat storage systems offer a cost-effective method where air, heated by a solar collector, is circulated through a tank filled with rocks. Optimizing these systems is complex due to the transient nature of heat transfer between air and solid media. This study, published in the proceedings of the Japan Society of Mechanical Engineers, investigates these thermal dynamics through a combination of experimental validation and numerical simulation.
Experimental and Numerical Methodology
The researchers employed a dual approach to evaluate the system's performance. An experimental test rig was constructed, featuring a flat-plate air-heating solar collector, a rock-bed storage tank (0.352m diameter, 0.5196m length) filled with 0.075m diameter rocks, an axial fan, and a solar simulator using halogen lamps to ensure consistent radiation.
Complementing the physical experiments, a "Full Implicit Simulation" program was developed based on a one-dimensional (1D) heat transfer model. This model predicts the temperature of both the air and the rock media at various depths over time. The study focused on the "charging" phase, testing solar radiation intensities of 500 and 700 $W/m^2$ while varying air mass flow rates.
Key Insights and System Dynamics
The study revealed several critical factors influencing thermal performance:
- Scaling and Similarity: A "similarity" rule was identified: if the ratio of storage tank volume to collector area remains constant, doubling the tank length and air flow rate results in nearly identical temperature distributions. This finding simplifies the scaling process for larger residential applications.
- Geometric Sensitivity: Tank geometry significantly impacts efficiency. Transitioning from a long, cylindrical tank to a flatter, disk-shaped tank of equal volume leads to a decrease in overall thermal efficiency ($\eta$).
- Flow Rate Optimization: Increasing the air mass flow rate ($\dot{m}_a$) consistently enhances heat absorption efficiency across different solar radiation levels.
- Model Validation: The 1D numerical model demonstrated high accuracy, with calculated temperature curves closely matching experimental data, confirming its utility for design-phase performance prediction.
Results and Performance Analysis
The experimental results highlighted the stratified nature of heat storage within the rock bed. As the "temperature wave" moves through the medium, significant thermal gradients are established.
Key performance metrics included:
- Efficiency Gains: Increasing the simulated solar radiation from 500 $W/m^2$ to 700 $W/m^2$ improved storage efficiency ($\eta$) from approximately 54.4% to 57.1%.
- Thermal Stratification: At 700 $W/m^2$, the top layer of rocks reached nearly $80^\circ C$ after 1381 minutes, while the bottom layer lagged, demonstrating effective heat capture in the upper sections of the bed.
Conclusion and Future Directions
The research successfully validated a 1D numerical model for predicting the transient behavior of rock-bed heat storage systems. While the model is robust for the tested configurations, future work could address its limitations, such as potential "edge effects" in larger industrial tanks or non-uniform air flow. Additionally, extending the analysis to long-term heat retention (e.g., overnight discharge cycles) and integrating fluctuating environmental factors like wind speed would further enhance the model's real-world applicability.
Summary updated