Abstract: On-chip actuation and readout of mechanical motion is key to characterize mechanical resonators and exploit them for new applications. We capacitively couple a silicon nitride membrane to an off resonant radio-frequency cavity formed by a lumped element circuit. Despite a low cavity quality factor ($Q_E \approx 7.4$) and off resonant, room temperature operation, we are able to parametrize several mechanical modes and estimate their optomechanical coupling strengths. This enables real-time measurements of the membrane's driven motion and fast characterization without requiring a superconducting cavity, thereby eliminating the need for cryogenic cooling. Finally, we observe optomechanically induced transparency and absorption, crucial for a number of applications including sensitive metrology, ground state cooling of mechanical motion and slowing of light.
Introduction
Cavity optomechanics—the study of the interaction between electromagnetic fields and mechanical motion—is a cornerstone of modern precision sensing and quantum technology. Traditionally, achieving high sensitivity in the microwave regime requires coupling a mechanical resonator to a high-quality superconducting cavity, necessitating cryogenic cooling to near absolute zero. This requirement for dilution refrigerators makes the technology bulky, expensive, and difficult to scale for on-chip applications. This paper presents a method for performing high-sensitivity optomechanical characterization at room temperature using a simple, off-resonant radio-frequency (RF) circuit.
Methods
The researchers utilized a "lumped-element" approach to create an RF cavity. The resonator is a 50-nm thick, high-stress silicon nitride (SiN) membrane, partially metallized with aluminum, which acts as one plate of a variable capacitor ($C_C$). This capacitor is integrated into an on-chip LC tank circuit formed by an inductor and fixed capacitors.
The mechanical motion of the membrane modulates the capacitance $C_C$, shifting the RF cavity's resonance frequency and encoding the motion onto the RF signal. Unlike traditional experiments that operate in the "resolved sideband regime," this system operates in the unresolved sideband regime at room temperature. The broad bandwidth of the low-$Q$ cavity ($Q_E \approx 7.4$) allows for high-speed characterization and real-time tracking of the membrane's motion.
Results
The system successfully identified the fundamental mechanical mode at 78.573 kHz with a mechanical quality factor ($Q_m$) of approximately 1,600. Multiple higher-order modes were also detected and mapped. The single-photon coupling strength ($g_0/2\pi$) was measured at approximately 1.9 mHz, matching theoretical predictions for capacitive coupling.
A significant achievement of this work is the observation of Optomechanically Induced Transparency (OMIT) and Absorption (OMIA) at room temperature. These interference phenomena demonstrate that the RF field actively interacts with the mechanical motion via radiation pressure, rather than through passive heating effects. Furthermore, the system achieved a displacement sensitivity of 0.4 pm/$\sqrt{Hz}$, a tenfold improvement over previous similar room-temperature RF setups.
Discussion and Future Work
The simplicity of this room-temperature platform makes it an attractive candidate for mechanical sensing and microwave-to-optical conversion. While the current unresolved sideband operation prevents standard sideband cooling to the quantum ground state, the large bandwidth is ideal for real-time sensing applications. Future iterations could improve fabrication uniformity to eliminate observed mode splitting. Additionally, theoretical OMIT-based cooling schemes might eventually allow reaching the quantum regime even in such low-$Q$ systems at room temperature.
Conclusion
By demonstrating high-sensitivity optomechanical characterization using a simple RF lumped-element circuit, this work paves the way for easier integration of optomechanical sensors. The elimination of cryogenic requirements and the ability to resolve motion in real-time represent significant steps toward practical, on-chip mechanical sensing technologies.
Summary updated