Abstract
With the rapid development of the low-rank coal chemistry industry, the production of semi-coke has ever been increasing. However, the semi-coke is difficult to burnout and the NOx generation during semi-coke combustion is high. Therefore, the co-combustion of semi-coke and bituminous coal in utility boiler is considered as a promising approach to realize the efficient utilization of the semi-coke. Here, the co-combustion features of bituminous coal and semi-coke blends were investigated in a 660 MW utility boiler. The results show that the NOx generation decreases firstly and then increases with the rises of the load and the fraction of semi-coke. The effects of load and blending ratio of semi-coke are both obvious on burnout behavior than those on NOx generation. With the rise of oxygen concentration, the NOx generation rises and the unburned carbon in fly ash decreases. The Na-bearing mineral are better-preserved with the higher oxygen concentration. The experimental results may provide guidance for the realization of the utilization of the semi-coke in the utility boiler.
Introduction
The low-rank coal chemistry industry produces a massive amount of "semi-coke" as a byproduct. While it is a potential fuel source, semi-coke has very low volatile content—often less than a third of standard coal. This characteristic makes it difficult to burn completely, leading to poor fuel efficiency and high levels of nitrogen oxides (NOx) during combustion.
Upgrading power plants to burn pure semi-coke requires expensive retrofits, such as installing circulating fluidized bed boilers. A more practical and cost-effective alternative is "co-combustion": blending semi-coke with standard bituminous coal in existing utility boilers. While laboratory studies have explored these blends, real-world data from commercial-scale operations is scarce. This study investigates the co-combustion of semi-coke and bituminous coal in a full-scale 660 MW utility boiler to establish operational guidelines for power plants utilizing these alternative fuels.
Experimental Methods
The research was conducted using a 660 MW supercritical once-through boiler. The boiler features a single-furnace "π" structure and employs wall-type tangential combustion. To mitigate NOx emissions, the system utilizes separated over-fire air (SOFA) to achieve staged combustion.
The experimental team systematically varied three key operational parameters:
- Boiler Load: Tested at 450 MW, 550 MW, and 660 MW.
- Blending Ratio of Semi-coke: Ratios of 20%, 40%, and 50% were evaluated.
- Oxygen Concentration: Adjusted between 3.2%, 3.5%, and 3.8%.
For each test case, NOx generation was measured at the air preheater outlet. Fly ash samples were collected to determine unburned carbon content—a key indicator of burnout efficiency—and to analyze chemical composition changes.
Results and Discussion
The Burnout vs. Emissions Trade-off
The study highlights a persistent trade-off between combustion efficiency and environmental impact. Parameters that improve fuel burnout (reducing unburned carbon) typically lead to higher NOx emissions. Because semi-coke lacks the volatile compounds found in coal, increasing its share in the blend weakens overall combustion stability, resulting in higher levels of unburned fuel in the ash.
Impact of Operational Parameters
- Boiler Load: Increasing the load from 450 MW to 660 MW had a profound impact on burnout, increasing unburned carbon in the fly ash by 42.92%. In contrast, NOx generation only rose by 5.31%, suggesting that load variations affect efficiency far more than emissions.
- Blending Ratio: As the semi-coke ratio increased from 20% to 50%, unburned carbon rose steadily. NOx generation followed a non-linear trend, initially decreasing before increasing at higher semi-coke fractions.
- Oxygen Concentration: Oxygen levels proved to be a critical control lever. Increasing oxygen from 3.2% to 3.5% resulted in a significant 24.12% reduction in unburned carbon, though it triggered a 19.57% spike in NOx emissions.
Ash Mineralogy
Interestingly, higher oxygen concentrations helped preserve Na-bearing (sodium) minerals in the fly ash. This indicates that combustion parameters influence not only gaseous emissions and carbon burnout but also the fundamental mineralogy of the solid waste products.
Conclusion and Future Outlook
This investigation provides practical insights for utilizing semi-coke in large-scale utility boilers. While co-combustion is feasible, operators must carefully balance load, blending ratios, and oxygen levels to manage the trade-off between burnout efficiency and NOx limits.
A limitation of this study is its focus on macroscopic performance metrics. Future research should explore micro-scale combustion kinetics and the long-term impacts of altered ash chemistry, such as potential slagging or corrosion risks associated with preserved sodium minerals. Developing optimization models based on these findings will be essential for maximizing semi-coke utilization while maintaining regulatory compliance and boiler integrity.
Summary updated