Abstract
Co-disposal of sewage sludge in cement kilns is an economic and feasible method of resource utilization. An industrial test of co-disposal sludge was carried out at Beijing Taihangqianjing Cement Limited Company. Semi-dry sludge was introduced as a raw material into the decomposition furnace for combustion. The physical properties and mineral composition of the cement clinkers produced with and without sludge were compared. Results showed that the chemical composition and properties of the clinker were similar to untreated sludge processes. There was no significant change in specific surface area or setting time (p > 0.05). While the fineness of the clinker was slightly reduced and the standard consistency water demand ratio was lower, the 28d compressive and breaking strengths remained high, confirming that dry sludge is a feasible substitute in cement production.
Introduction
As urbanization accelerates, municipal sewage sludge has become a critical environmental challenge. Traditional disposal methods like landfilling and incineration often face space constraints or high operational costs. This research explores "co-disposal"—integrating sewage sludge into the cement manufacturing process. By utilizing sludge as both a raw material and a fuel source in a dry-process cement kiln, the industry can achieve a sustainable "two-birds-one-stone" solution that addresses waste management while reducing the demand for traditional silica-rich raw materials.
Methodology
The study was conducted at a facility with a daily production capacity of 3,200 tons of cement clinker. The experimental setup involved introducing 36 tons of semi-dry sludge (60% moisture content) per day into the decomposition furnace via bucket elevators.
Researchers compared clinker produced with sludge against a control group produced without sludge. Chemical profiles were established using fluorescence analysis, and physical properties—including fineness, specific surface area, setting time, and mechanical strength—were tested according to Chinese national standards (GB/T).
Results and Discussion
Physical Properties and Consistency
Statistical analysis indicated that the integration of sludge did not significantly alter the fundamental physical characteristics of the cement. The specific surface area remained identical at 349 m².kg⁻¹ for both samples. Setting times were also remarkably stable; the initial setting time for sludge-integrated cement was 98 minutes compared to 95 minutes for the control, both well within the standard safety margin of ≥45 minutes.
Interestingly, the fineness of the clinker was slightly reduced (from 2.0% to 1.5%) when sludge was added, and the water demand ratio for standard consistency was slightly lower (23.8% vs 24.0%). These minor shifts suggest that sludge components may influence the crystal formation of the clinker during hydration.
Mechanical Strength Performance
The mechanical integrity of the cement is the most critical metric for industrial viability. The test results showed that sludge-integrated clinker performed exceptionally well in both breaking and compressive strength tests.
At the 3-day mark, the sludge-integrated cement showed a slight improvement in both breaking strength (6.61 MPa vs 6.59 MPa) and compressive strength (33.98 MPa vs 33.79 MPa). At 28 days, the compressive strength reached 52.01 MPa. While this is marginally lower than the control's 53.06 MPa, it remains significantly above industrial requirements, proving that the structural quality of the cement is maintained during co-disposal.
Conclusion
The industrial test confirms that municipal sewage sludge is a viable substitute for traditional raw materials in a new dry-process cement kiln. The resulting clinker maintains its chemical and physical properties without compromising setting times or mechanical strength. However, future implementation must strictly monitor "adverse elements" like phosphorus, sulfur, and magnesium to prevent kiln scaling and ensure long-term operational stability. Further research into heavy metal emissions and long-term kiln maintenance is recommended to optimize this sustainable disposal method.
Summary updated