Abstract
The harsh operating environment and non-fixed foundation pose a challenge to the power output of the floating wind turbine, so a floating platform for motion within a safe range is required. The paper analyzes the influence of wind-wave coupling, wave direction angle and rotor degree of freedom on the platform movement. It is found that the stability of the floating platform is very sensitive to the key parameters of the mooring system. The mooring system dynamic model is established, and the simulation analysis is carried out by resetting the key parameters of the mooring system. The effects of variables such as the position of the fairlead, the tensile stiffness of the anchor chain, and the mass per unit length of the anchor chain on the platform's motion stability and output power fluctuation are analyzed. It is also of great significance to balance the relationship between the platform's dynamic response and power generation.
Introduction
As wind energy moves further offshore into deeper waters, traditional fixed-bottom turbines become economically unfeasible. Floating wind turbines (FOWTs) are the solution, but they introduce a massive engineering challenge: the platform is constantly moving in six degrees of freedom (surge, sway, heave, roll, pitch, and yaw). Excessive movement, particularly "pitch" (tilting forward and backward), disrupts the aerodynamics of the rotor, leading to fluctuating power output and increased structural fatigue. While many studies focus on how wind and waves move these platforms, there is less research on how the specific design of the mooring system can be optimized to dampen these motions without exceeding structural tension limits.
Methodology
The researchers employed a high-fidelity simulation approach using the industry-standard OC4-DeepCwind semi-submersible model. The study utilized FAST (Fatigue, Aerodynamics, Structures, and Turbulence) and MATLAB Simulink to analyze the platform's 6-DOF motion in the time domain. Environmental conditions were simulated using the Jonswap spectrum (5m wave height, 10s period) and a rated wind speed of 11.4 m/s. A control variate method was used to isolate variables including wind-wave coupling, wave incident angles (0° to 60°), and rotor degrees of freedom. Sensitivity analysis focused on four fairlead positions, four levels of anchor chain tensile stiffness (EA), and four variations of chain mass per unit length (m).
Results and Discussion
Dynamic Response and Motion Hierarchy
The study identifies pitch and surge as the most critical motions due to their large amplitudes and direct impact on power generation stability. Pitch and heave are primarily driven by wave action, while roll and yaw are more influenced by wind loads.
As shown in the figures, the combined action of wind and waves creates complex oscillations. Surge amplitudes reach significant levels, necessitating robust mooring constraints. Similarly, pitch motion is highly sensitive to rotor rotation; when the rotor's degrees of freedom are unrestricted, pitch amplitude increases dramatically due to aerodynamic loads.
Mooring System Optimization and the "Mooring Paradox"
There is a fundamental trade-off in mooring design. Increasing the mass or tensile stiffness of the anchor chains helps "stiffen" the system and reduce translational motions like surge and sway. However, this comes at the cost of significantly higher tension in the chains, which increases the risk of mechanical failure.
Furthermore, fairlead depth plays a crucial role. Moving the fairlead further down the foundation column increases the amplitude of sway and surge, making the platform less stable, although it does reduce peak tension on the chains. The platform's yaw is also sensitive to wave direction, peaking at incident angles between 20° and 30° due to the symmetrical three-catenary layout.
Conclusion
The stability of floating offshore wind turbines is highly sensitive to the configuration of the mooring system. While increasing stiffness and mass can suppress critical motions like surge and pitch, it introduces risks of structural failure due to excessive tension. Future work should focus on multi-objective optimization to find the ideal balance point where platform motion is minimized to maintain steady power output without exceeding the safe load limits of the mooring lines.
Summary updated