Integrated Information and Energy Harvesting Receiver Architectures

This direction is merged into another direction: simultaneous wireless information and power transfer. Its last version stays readable and citable here.

Version 1 of 130 papers30 conceptsfrozen 2026-10-04

In traditional wireless communication, radio frequency (RF) signals are treated strictly as carriers of information. Any energy in the signal that isn't captured for data decoding is considered "noise" or "interference." However, as the Internet of Things (IoT) scales toward trillions of low-power devices, the "battery problem"—the logistical impossibility of manually recharging or replacing batteries in remote sensors—has forced a paradigm shift.

Researchers like Xiao Lu and Dusit Niyato argue in Wireless Networks with RF Energy Harvesting: A Contemporary Survey that RF signals should be viewed as a dual-purpose resource. This concept, known as Simultaneous Wireless Information and Power Transfer (SWIPT), allows a device to extract both data and electricity from the same electromagnetic wave.

The Receiver Architecture: Splitting the Signal

The fundamental challenge of SWIPT is that current hardware cannot decode information and harvest energy from the same signal simultaneously using the same circuit. Information decoding requires the signal to be down-converted and sampled, while energy harvesting requires the signal to be rectified into DC power. To solve this, two primary receiver architectures have emerged.

Time Switching (TS)

In a time-switching architecture, the receiver alternates between two modes. For a fraction of the time, the antenna is connected to the energy harvester; for the remainder, it is connected to the information decoder. While simple to implement, TS is often less efficient because it forces a binary choice: you are either communicating or charging, but never both.

Power Splitting (PS)

A more sophisticated approach is power splitting. Here, a passive component divides the incoming signal power into two streams. One portion (e.g., 30%) is sent to the energy harvester, while the rest (70%) goes to the decoder. Qingjiang Shi demonstrates in Joint Beamforming And Power Splitting For Multi-User MISO SWIPT System that by dynamically adjusting this splitting ratio, systems can achieve a superior trade-off between data rate and energy collection (the Rate-Energy, or R-E, region).

Turning Interference into a Resource

In conventional networks, co-channel interference is a nuisance that degrades performance. SWIPT flips this logic. If a receiver is surrounded by multiple transmitters, those "interfering" signals become additional sources of ambient energy.

Caijun Zhong and Zhiguo Ding show in Application of Smart Antenna Technologies in Simultaneous Wireless Information and Power Transfer that multi-antenna (MIMO) systems can use beamforming to "focus" energy toward specific nodes. Furthermore, Liang Liu 0003 and Rui Zhang 0006 propose a "signal splitting" technique where transmitters send a mix of a stochastic information signal and a deterministic energy signal. This allows the system to treat interference not as noise, but as a collaborative charging resource.

Energy-Harvesting Cooperative Networks

SWIPT is particularly powerful in relay networks. In a typical cooperative setup, a relay node helps forward data from a source to a destination. However, the relay often has its own energy constraints.

In Energy Harvesting Cooperative Networks: Is the Max-Min Criterion Still Diversity-Optimal?, Zhiguo Ding proves that the classic "max-min" relay selection strategy—the gold standard for decades—is actually sub-optimal for SWIPT. Because the relay's ability to transmit depends entirely on how much energy it harvests from the source, the network must prioritize the source-to-relay link strength to ensure the relay has enough "fuel" to function. This creates a "harvest-then-transmit" protocol where the relay is entirely self-sustaining, powered by the very data it is tasked to forward.

Beyond Linear Models

Early research in SWIPT assumed a "linear" energy harvesting model, where the harvested power is simply proportional to the input RF power. However, Bruno Clerckx and Rui Zhang argue in Fundamentals of Wireless Information and Power Transfer that this model is fundamentally flawed.

Real-world rectifiers (the circuits that convert RF to DC) are non-linear. They are more efficient when receiving signals with high peak-to-average power ratios (PAPR). This insight suggests that the best signals for power (like multi-sine waves) are different from the best signals for data. Modern SWIPT research focuses on designing waveforms that strike a balance, utilizing non-linearities to boost efficiency without sacrificing the integrity of the communication link.

By integrating these mechanisms—power splitting, energy-aware relaying, and non-linear signal design—SWIPT moves us toward Kun Yang's vision of Data and energy integrated communication networks (DEINs): a world where the network itself provides the energy required for its own survival.

Papers in this version

History & citationVersion 1 · 2026-10-04

Merged into another direction · Permanent link

View frozen version 1

Cite this direction

Latest version (a living page):

@misc{lacuna_integrated_information_and_energy_harves_1d53f00f,
  title = {Integrated Information and Energy Harvesting Receiver Architectures},
  author = {{Lacuna}},
  howpublished = {Lacuna research direction},
  year = {2026},
  url = {https://lacuna.tiptreesystems.com/direction/integrated-information-and-energy-harvesting-receiver-architectures/rdr_1d53f00f89cb49088b72e1bdedc19632},
  note = {Latest version of a living research direction; cite a version for a fixed text. Accessed 2026-11-21},
}

This exact version (version 1, frozen text):

@misc{lacuna_integrated_information_and_energy_harves_1d53f00f_v1,
  title = {Integrated Information and Energy Harvesting Receiver Architectures},
  author = {{Lacuna}},
  howpublished = {Lacuna research direction},
  year = {2026},
  url = {https://lacuna.tiptreesystems.com/direction/integrated-information-and-energy-harvesting-receiver-architectures/rdr_1d53f00f89cb49088b72e1bdedc19632/v/1},
  note = {Version 1, frozen 2026-10-04. Accessed 2026-11-21},
}