Structure, Defects and Microwave Dielectric Properties of Al-Doped and Al/Nd Co-doped Ba4Nd9.33Ti18O54 Ceramics

Weijia Guo, Zhiyu Ma, Yu Luo, Yugu Chen, Zhenxing Yue, Longtu LiResearch 2021 · DOI

Introduction

The rapid expansion of 5G communication technology necessitates the development of high-performance microwave dielectric ceramics for miniaturized components such as filters and antennas. These materials must satisfy three "golden" criteria: a high relative dielectric constant ($ε_r$) for device miniaturization, a high quality factor ($Q \times f$) for low signal loss, and a near-zero temperature coefficient of resonant frequency ($τ_f$) for thermal stability. Tungsten-bronze type ceramics, specifically the $Ba_4Nd_{9.33}Ti_{18}O_{54}$ (BNT) system, are prime candidates but often suffer from significant dielectric losses. This study explores a novel co-doping strategy to overcome these limitations.

Methodology

Researchers proposed a novel Al/Nd co-doping method to enhance the dielectric properties of BNT ceramics through structural and defect modulation. Two series of ceramics were synthesized using the solid-state reaction method for comparison:

  1. BNT-A: $Ba_4Nd_{9.33}Ti_{18-z}Al_{4z/3}O_{54}$ (simple Al-doping).
  2. BNT-AN: $Ba_4Nd_{9.33+z/3}Ti_{18-z}Al_zO_{54}$ (Al/Nd co-doping).

The co-doping approach (BNT-AN) involves substituting $Ti^{4+}$ with $Al^{3+}$ while simultaneously filling inherent A1-site vacancies with $Nd^{3+}$ to maintain charge neutrality. The materials were characterized using Rietveld refinement of X-ray diffraction (XRD) patterns, Raman spectroscopy for lattice vibration analysis, and Thermally Stimulated Depolarization Current (TSDC) to identify and quantify oxygen vacancy concentrations.

Key Insights: Structural and Defect Modulation

The research highlights two primary mechanisms for performance improvement achieved through co-doping:

  • Lattice Vibration Suppression: Raman spectroscopy revealed that Al/Nd co-doping reduces the vibration strength of A-site cations. Since these vibrations are a major source of intrinsic dielectric loss at microwave frequencies, "quieting" the lattice directly improves the $Q \times f$ value.
  • Oxygen Vacancy Reduction: TSDC analysis provided critical evidence that the BNT-AN series possesses a significantly lower concentration of oxygen vacancies ($V_O^{\bullet \bullet}$) compared to the BNT-A series. By filling structural vacancies and maintaining charge balance, the co-doping strategy suppresses extrinsic losses associated with these defects.

Results and Performance

The Al/Nd co-doping method significantly outperformed simple Al-doping. While BNT-A ceramics showed secondary phases at higher doping levels ($z \ge 1.5$), BNT-AN maintained a stable single-phase tungsten-bronze structure across a wider range.

Optimal microwave dielectric properties were achieved in the BNT-AN sample with $z = 1.25$:

  • Relative Dielectric Constant ($ε_r$): 72.2
  • Quality Factor ($Q \times f$): 16,480 GHz
  • Temperature Coefficient ($τ_f$): +14.3 ppm/℃

As the doping amount $z$ increased up to 1.5, the $Q \times f$ values showed a marked improvement, demonstrating the effectiveness of the co-doping strategy in reducing energy dissipation.

Conclusion

The novel Al/Nd co-doping strategy successfully addresses the performance trade-offs typically seen in BNT ceramics. By simultaneously modulating the crystal structure and suppressing oxygen vacancies, this approach provides a robust pathway for developing high-efficiency dielectric materials essential for 5G telecommunication infrastructure. Future work will focus on optimizing sintering temperatures and further refining the temperature coefficient to achieve near-zero thermal drift.

Summary updated

Abstract

Abstract Low-loss tungsten-bronze microwave dielectric ceramics are a kind of dielectric materials with potential application value for miniaturized dielectric filters and antennas in 5G communication technology. In this work, a novel Al/Nd co-doping method of Ba 4 Nd 9.33 Ti 18 O 54 (BNT) ceramics with a chamical formula of Ba 4 Nd 9.33+ z /3 Ti 18- z Al z O 54 (BNT-AN, 0 ≤ z ≤ 2) was proposed to improve the dielectric properties through structural and defect modulation. Together with Al-doped ceramics (Ba 4 Nd 9.33 Ti 18- z Al 4 z /3 O 54 , BNT-A, 0 ≤ z ≤ 2) for comparison, the ceramics were prepared by solid state method. It is found that Al/Nd co-doping method has a significant effect on improving the dielectric properties compared with Al doping. As the doping amount z increased, the relative dielectric constant ( ε r ) and the temperature coefficient of resonant frequency ( τ f ) of the ceramics decreased, and the Q × f values of the ceramics obviously increased when z ≤ 1.5. Excellent microwave dielectric properties of ε r = 72.2, Q × f = 16480 GHz, and τ f = +14.3 ppm/℃ were achieved in BNT-AN ceramics with z = 1.25. Raman spectroscopy and thermally stimulated depolarization current (TSDC) technique were firstly combined to analyze the structure and defects in the dielectric ceramics. It is shown that the improvement on Q × f values were origined from the decrease in the strength of the A -site cation vibration and the concentration of oxygen vacancies ( V ö ), demonstrating the effect and mechanism underlying for structural and defect modulation on the performance improvement of microwave dielectric ceramics.
BibTeX
@inproceedings{guo2021structure,
  author = {Weijia Guo and Zhiyu Ma and Yu Luo and Yugu Chen and Zhenxing Yue and Longtu Li},
  title = {{Structure, Defects and Microwave Dielectric Properties of Al-Doped and Al/Nd Co-doped Ba4Nd9.33Ti18O54 Ceramics}},
  booktitle = {Research},
  year = {2021},
  doi = {10.21203/rs.3.rs-783511/v2},
}
Figure