High- Q enstatite microwave/terahertz dielectric ceramics modulated by phase transition and lattice distortion

Yutian Lu, Weijia Guo, Chongyang Zhang, Hui Zhang, Zhenxing YueJournal of Advanced Ceramics 2025 · DOI

Introduction

The rapid advancement of 5G and 6G telecommunication technologies necessitates the development of new dielectric materials capable of operating at extreme frequencies. These systems, shifting from microwave into millimeter-wave and terahertz (THz) bands, require materials with low relative permittivity ($\epsilon_r$) to minimize signal delay and ultra-low dielectric loss (high $Q \times f$ values) to prevent signal degradation. Silicate ceramics are promising due to their stable covalent bonds, yet few achieve the "ultrahigh" $Q \times f$ benchmark of $\ge 200,000$ GHz. This study explores how germanium substitution in magnesium silicate (enstatite) ceramics triggers structural changes that optimize performance across both microwave and THz spectra.

Structural Evolution and Phase Transition

The researchers synthesized MgSi$_{1-x}$Ge$_x$O$_3$ (MSG$x$) ceramics, varying $x$ from 0 to 0.6. A critical finding was the phase transition induced by substituting smaller Si$^{4+}$ ions with larger Ge$^{4+}$ ions. At $x = 0.2$, the crystal structure shifts from clinoenstatite ($P2_1/c$) to orthoenstatite ($Pbca$).

Structural evolution of MSGx ceramics showing the phase transition from clinoenstatite ($P2_1/c$) to orthoenstatite ($Pbca$) and the resulting lattice distortion.

This transition changes the cation state from "compressed" to a "rattle" state, significantly reducing bond strain. Furthermore, lattice distortion peaks at $x = 0.5$, providing a structural mechanism to tune the quality factor.

Microwave vs. Terahertz Dielectric Performance

The dielectric properties exhibit a notable divergence between microwave and terahertz bands. In the microwave range, performance peaks at $x = 0.5$ (MgSi$_{0.5}$Ge$_{0.5}$O$_3$), achieving an ultrahigh $Q \times f$ of 259,300 GHz and $\epsilon_r = 7.21$.

However, in the terahertz band, higher germanium concentrations ($x \ge 0.4$) lead to an anomalous increase in permittivity and a decrease in the quality factor. Terahertz time-domain spectroscopy (THz-TDS) revealed that this degradation is caused by the emergence of new polar phonon modes.

Dielectric properties in the terahertz band, highlighting the emergence of new polar phonon modes at higher germanium concentrations which impact the loss tangent.

Consequently, the optimal composition for THz applications is MgSi$_{0.7}$Ge$_{0.3}$O$_3$ ($x = 0.3$), which maintains excellent properties ($\epsilon_r = 7.02, Q \times f = 191,300$ GHz) without the interference of these phonon modes.

Conclusion and Future Outlook

This research demonstrates that controlled lattice distortion and phase transitions are powerful tools for engineering high-performance silicate ceramics. While the MSG$x$ series shows great promise for 6G hardware, challenges remain regarding the temperature coefficient of resonant frequency ($\tau_f$), which is currently $-65.02$ ppm/°C for the $x=0.5$ composition. Future work will focus on co-doping strategies to achieve near-zero $\tau_f$ while preserving ultrahigh quality factors, paving the way for commercial implementation in next-generation mobile communication systems.

Summary updated

Abstract

The rapid development of fifth-/sixth-generation telecommunication technologies has increased the demand for silicate ceramic materials with low permittivity and low dielectric loss. However, few silicate ceramics with ultrahigh <i>Q</i>×<i>f</i> values (≥ 200,000 GHz) have been developed to date. In this study, a slight substitution of Ge<sup>4+</sup> ions in MgSi<sub>1−<i>x</i></sub>Ge<sub><i>x</i></sub>O<sub>3</sub> (MSG<i>x</i>, <i>x</i> = 0 to 0.6) ceramics caused a phase transition from clinoenstatite (<i>x</i> = 0) to orthoenstatite (<i>x</i> = 0.2), and the <i>Q</i>×<i>f </i>value increased from 70,600 GHz to 148,800 GHz. Following the phase transition, the cations change from a “compressed” state to a “rattle” state, and the lattice distortion continues to rise with <i>x</i>, resulting in the optimal microwave dielectric properties (<i>ε</i><sub>r</sub> = 7.21, <i>Q</i>×<i>f </i>= 259,300 GHz) of the MgSi<sub>0.5</sub>Ge<sub>0.5</sub>O<sub>3</sub> ceramics. Significant discrepancies in the dielectric properties are found in the microwave and terahertz bands. There is an anomalous increase in <i>ε</i><sub>r</sub> and a decrease in the <i>Q</i>×<i>f </i>value in the terahertz band, which is due to the change in polar phonon modes revealed by the terahertz time-domain spectra. Consequently, MgSi<sub>0.7</sub>Ge<sub>0.3</sub>O<sub>3</sub> ceramics display superior dielectric properties, with <i>ε</i><sub>r</sub> = 7.02, <i>Q</i>×<i>f </i> = 191,300 GHz in the terahertz band. These novel materials have the potential to serve as promising dielectric materials for future microwave or terahertz mobile communication systems.
BibTeX
@article{lu2025high,
  author = {Yutian Lu and Weijia Guo and Chongyang Zhang and Hui Zhang and Zhenxing Yue},
  title = {{High- <i>Q</i> enstatite microwave/terahertz dielectric ceramics modulated by phase transition and lattice distortion}},
  journal = {Journal of Advanced Ceramics},
  year = {2025},
  doi = {10.26599/jac.2025.9221053},
}
Figure