Introduction
As the demand for high-speed broadband explodes, service providers are looking toward Fixed Wireless Access (FWA) at millimeter-wave (mm-wave) frequencies like 28 GHz as a cost-effective alternative to laying fiber-optic cables. However, mm-wave signals are notoriously fragile; they are easily blocked by walls, glass, and foliage.
While previous research has measured "penetration loss" (how much the signal dims when it goes through a wall), most studies lacked high-resolution data on delay spread (how much the signal echoes over time) and angular spread (the directions from which the signal arrives). These statistics are vital for engineers designing the beamforming algorithms that allow 5G base stations to "track" and maintain a solid connection with indoor receivers. This paper characterizes how 28 GHz signals penetrate from outdoors to indoors, quantifying power loss alongside critical temporal and spatial statistics across different building types.
Methods and Measurement Campaign
The researchers conducted a measurement campaign on the University of Southern California (USC) campus using a high-performance real-time channel sounder operating at 27.85 GHz with a 400 MHz bandwidth. This setup can measure path loss up to 169 dB, allowing it to detect very faint signals deep within buildings. Instead of traditional rotating horn antennas, the team utilized 8x2 phased arrays to steer beams electronically in microseconds, enabling directionally resolved measurements in dynamic environments.
Two distinct environments were tested to evaluate the impact of construction materials:
- Single Family Unit (SFU): A two-story, wood-frame house typical of California construction.
- Multi-Story Building (MSB): A brick building surrounded by heavy foliage.
The resulting datasets include omnidirectional and directional Power Delay Profiles (PDPs), mapping signal strength relative to time and arrival angle for 17 RX locations in the SFU and 12 in the MSB.
Key Insights
- Construction Material Impact: The building material is the primary driver of signal quality. Wood-frame houses are significantly more "transparent" to 28 GHz signals than brick buildings.
- The Window Factor: In the wood-frame house, loss varied significantly (from 1 dB to 21.5 dB) depending on whether the receiver was directly behind a window or shielded by a wall.
- Temporal Consistency: In the SFU, the RMS delay spread was remarkably similar for both indoor and outdoor locations (~24 ns vs. ~26 ns). This suggests signals penetrate wood structures relatively cleanly without excessive internal bouncing.
- The "Hallway Effect": In the brick MSB, the strongest signals often reflected off other structures and entered through hallways or distant openings rather than the nearest window, leading to much higher delay spreads.
Results
The measurement campaign quantified the substantial difference in penetration loss between the two building types. The mean excess penetration loss for the wood-frame SFU was 10.6 dB, whereas the brick MSB showed a much higher loss of 22.7 dB.
For the SFU, the outdoor path loss averaged 127.8 dB, while the indoor path loss averaged 138.4 dB. While mean angular spreads were somewhat similar, the range of values varied significantly indoors, suggesting that indoor antennas require high adaptivity to maintain a stable link.
Limitations and Future Work
The study acknowledges limitations such as the limited variety of buildings tested; modern "green" buildings with metal-coated glass may exhibit higher reflectivity. Additionally, all indoor measurements were taken at a fixed height on the first floor. Future research will involve measurements at different heights and the use of high-resolution parameter extraction algorithms to isolate individual multipath components more precisely.
Summary updated