Abstract
This letter presents a measurement campaign carried out in an FR2 urban outdoor environment in a live experimental network deployment. The radio propagation analysis from a physical perspective at 26 GHz is essential for the correct deployment and dimensioning of future communication networks. This study performs a walk test emulating realistic conditions under which a pedestrian may be affected, summarizing and evaluating some of the typical effects encountered in a communications scenario such as penetration losses in a building, losses due to vegetation or the human body, or diffraction/scattering propagation around corners in street canyon-like environments. The operational conditions of the 5G network, the urban micro-cell scenario, and the use of omnidirectional antennas on the UE side validate the channel conditions from a perspective closer to a realistic scenario for a pedestrian within a FR2 live network.
Introduction
As 5G deployments expand into the millimeter-wave (mmWave) spectrum, specifically Frequency Range 2 (FR2), network engineers face significant challenges. High-frequency signals at 26 GHz are highly susceptible to blockage by common urban obstacles such as buildings, vegetation, and even the human body. While theoretical models provide a baseline, there is a critical need for empirical data from live, operational networks to understand how these signals behave in real-world pedestrian scenarios. This study addresses this gap by characterizing large-scale attenuation in a realistic "street canyon" environment.
Methodology
The researchers conducted a comprehensive "walk test" in the Sydhavnen district of Copenhagen, a residential area with 25-meter-tall buildings and narrow avenues.
Key aspects of the experimental setup included:
- Live Network Environment: Measurements were taken using a commercial-grade Ericsson AIR 5322 base station operating in the 26 GHz (n258) band.
- Pedestrian Emulation: A Rohde & Schwarz TSME6 radio scanner was carried at a height of 1.7 meters, moving at a typical walking speed of 1.5 m/s.
- Omnidirectional Reception: Unlike studies using directional antennas, this campaign employed an omnidirectional antenna at the receiver to capture the full multipath environment experienced by a typical user.
- Data Processing: To isolate large-scale effects, the measured Reference Signal Received Power (RSRP) was spatially averaged over 40 wavelengths ($40\lambda$), smoothing out rapid small-scale fading fluctuations.
Key Insights and Results
Building Penetration and Outdoor-to-Indoor (O2I) Coverage
One of the most significant findings concerns the difficulty of providing indoor coverage from outdoor mmWave base stations. The study found that standard double-glazed windows introduce a median penetration loss of approximately 20–22 dB.
This high level of attenuation often pushes the indoor signal strength near or below the sensitivity limits of typical consumer devices, confirming the "low-loss" building models defined in 3GPP TR38.901.
Path Loss and Corner Propagation
In Non-Line-of-Sight (NLoS) conditions along the main avenues, the path loss exponent ($n$) was calculated to be 3.822, aligning well with standard 3GPP models. However, turning a corner into a side street caused a dramatic signal drop. The analysis suggests that diffraction—the bending of waves around the corner—is the dominant propagation mechanism in these scenarios, rather than scattering from nearby surfaces.
Environmental and Human Factors
- Vegetation: Foliage impact is highly seasonal. A single tree with leaves caused an average loss of 5.9 dB, which decreased to 2.3 dB in winter after the leaves had fallen.
- Human Blockage: The impact of the human body is context-dependent. In Line-of-Sight (LoS) conditions, a person blocking the path causes ~6 dB of loss. In NLoS environments, this loss drops to ~2 dB because the receiver relies on multipath signals arriving from multiple directions.
Conclusion and Future Work
The measurement campaign validates that while 26 GHz signals are highly sensitive to the local environment, existing 3GPP models are reasonably accurate for network planning if environmental specifics are accounted for. Future research should explore how these large-scale effects interact with the dynamic beam-tracking and beamforming algorithms used in commercial handsets, as the use of omnidirectional antennas in this study represents a baseline scenario for multipath reception.
Summary updated