qCDC: Metastability-Resilient Synchronization FIFO for SFQ Logic

Gourav Datta, Haolin Cong, Souvik Kundu, Peter A. Beerel

Abstract

Digital Single-Flux Quantum (SFQ) logic is a leading candidate for ultra-low-power, exascale supercomputing, operating at frequencies in the tens of GHz. However, the high-speed nature of SFQ introduces significant timing challenges, particularly metastability during clock domain crossing (CDC). This paper proposes a metastability-resilient synchronization FIFO that employs a multi-DRO (Destructive Read-Out) architecture to mitigate timing errors. By capturing data pulses twice, the design masks metastability-induced delays, achieving a 1000x reduction in logical error rates at 30 GHz with only a 7.5% increase in circuit area.

Introduction: The SFQ Timing Challenge

As traditional CMOS technology approaches physical scaling limits, Single-Flux Quantum (SFQ) logic has emerged as a high-performance alternative. SFQ circuits utilize magnetic flux pulses rather than voltage levels, enabling operation at extremely high frequencies. However, distributing a perfectly synchronized clock across a large-scale SFQ chip is impractical. Consequently, systems must rely on multiple independent clock domains, necessitating robust Clock Domain Crossing (CDC) mechanisms.

Metastability occurs when a data pulse arrives too close to a clock pulse, violating setup time requirements. In SFQ logic, this manifests as a significant increase in "clock-to-Q" delay, where the output pulse is produced much later than nominal. This temporal uncertainty can lead to system-wide failures if the receiving domain misses or misinterprets the delayed data.

Clock-to-Q delay as a function of input pulse arrival time relative to the clock, illustrating the metastability window in SFQ logic.

Proposed Methodology

The researchers developed a Metastability-Resilient SFQ CDC FIFO inspired by the classic two-flip-flop synchronizer but optimized for pulse-based logic. The core of the design is a Multi-DRO Synchronization scheme. Instead of a single storage element, the FIFO uses a sequence of Destructive Read-Out (DRO) elements.

This architecture enables Delay Masking: if the first stage experiences a metastability-induced delay, the subsequent stage acts as a safety net, capturing the late pulse and re-aligning it with the receiver's clock. Asynchronous Muller C-elements are employed to manage handshaking between stages, ensuring data integrity. The design was validated using JSIM simulations targeting the SFQ5EE fabrication process.

Experimental Results

The proposed design was benchmarked against a standard baseline FIFO. Key metrics included logical error rate (LER), area overhead, and operational robustness at high frequencies.

Simulations at 30 GHz demonstrated a 1000x reduction in LER compared to the baseline. Furthermore, the proposed design exhibited superior robustness; while the baseline FIFO failed at specific tight timing intervals at 30 GHz and 50 GHz, the resilient design remained fully functional.

Comparison of baseline and proposed FIFO designs across different clock frequencies and data arrival times.

The hardware cost for this increased reliability is minimal. For a 10-stage FIFO, the proposed design requires only a 7.5% increase in Josephson Junction (JJ) area. The latency trade-off is also negligible, adding only a single extra clock cycle compared to the non-resilient version.

Conclusion

The developed synchronization FIFO provides a critical building block for reliable, high-speed SFQ systems. By addressing metastability as a temporal delay problem and implementing architectural redundancy through multi-DRO stages, the design achieves massive gains in reliability with minimal area and latency overhead. Future work will focus on extending this architecture to multi-bit synchronization and further characterizing the metastability windows of SFQ elements across various fabrication processes.

Summary updated

Abstract

Digital single-flux quantum (SFQ) technology promises to meet the demands of ultra low power and high speed computing needed for future exascale supercomputing systems. The combination of ultra high clock frequencies, gate-level pipelines, and numerous sources of variability in SFQ circuits, however, make low-skew global clock distribution a challenge. This motivates the support of multiple independent clock domains and related clock domain crossing circuits that enable reliable communication across domains. Existing J-SIM simulation models indicate that setup violations can cause clock-to-Q increases of up to 100%. This paper first shows that naive SFQ clock domain crossing (CDC) first-in-first-out buffers (FIFOs) are vulnerable to these delay increases, motivating the need for more robust CDC FIFOs. Inspired by CMOS multi-flip-flop asynchronous FIFO synchronizers, we then propose a novel 1-bit metastability-resilient SFQ CDC FIFO that simulations show delivers over a 1000 reduction in logical error rate at 30 GHz. Moreover, for a 10-stage FIFO, the Josephson junction (JJ) area of our proposed design is only 7.5% larger than the non-resilient counterpart. Finally, we propose design guidelines that define the minimal FIFO depth subject to both throughput and burstiness constraints.
BibTeX
@misc{datta2019qcdc,
  author = {Gourav Datta and Haolin Cong and Souvik Kundu and Peter A. Beerel},
  title = {{qCDC: Metastability-Resilient Synchronization FIFO for SFQ Logic}},
  year = {2019},
  eprint = {1910.04907},
  archivePrefix = {arXiv},
  url = {https://arxiv.org/abs/1910.04907},
}
Figure