Abstract
Keyhole porosity is a key concern in laser powder-bed fusion (LPBF), potentially impacting component fatigue life. However, the dynamics of keyhole porosity formation, i.e., keyhole fluctuation, collapse and bubble growth and shrinkage, remain unclear. Using synchrotron X-ray imaging we reveal keyhole and bubble behaviours, quantifying their formation mechanisms. The findings support the hypotheses that: (i) keyhole porosity can initiate not only in unstable, but also transition keyhole regimes, created by high laser power-velocity conditions, causing fast radial keyhole fluctuations (~ 10 kHz); (ii) transition regime collapse tends to occur part way up the rear-wall; and (iii) immediately after keyhole collapse, the bubble grows as pressure equilibrates then shrinks due to metal-vapour condensation. Concurrent with condensation, hydrogen diffusion into the bubble slows the shrinkage and stabilises the bubble size. The physics revealed here can guide the development of real-time monitoring and control systems for keyhole porosity.
Introduction
Laser Powder Bed Fusion (LPBF) is a transformative metal additive manufacturing technology. However, the formation of keyhole porosity remains a significant barrier to its widespread adoption in safety-critical applications, such as aerospace and medicine. These pores, which result from the collapse of the vapor-filled keyhole, act as stress concentrators that reduce fatigue life. While it is established that unstable keyholes lead to porosity, the high-speed dynamics of keyhole fluctuation and the subsequent lifecycle of the resulting bubbles have been difficult to observe. This study utilizes ultra-high-speed synchrotron X-ray imaging to map these phenomena and provide a physical framework for understanding pore formation.
Methods
The experimental setup involved in situ synchrotron X-ray imaging at the Advanced Photon Source, Argonne National Laboratory. Imaging was performed at 50,000 frames per second using a custom In Situ Optical Process Replicator (ISOPR). The study focused on Al7A77, a high-strength aluminum alloy, and compared it with Ti-6Al-4V, Inconel 718, and SS304. An automated image processing pipeline, utilizing K-means clustering and Kalman filtering, was developed to segment and track bubbles. Theoretical modeling combined the Rayleigh-Plesset equation with metal-vapor condensation and gas diffusion kinetics to describe bubble evolution.
Keyhole Regimes and Universal Scaling
The research identifies three distinct keyhole regimes based on stability: quasi-stable (Regime I), transition (Regime II), and unstable (Regime III). A critical insight is the identification of the transition regime, where pores "pinch off" from the mid-rear wall rather than the bottom.
As shown in Figure 3b, the front wall angle ($\theta$) follows a universal scaling law across different materials when plotted against the normalized enthalpy product ($\Delta H/h_m \cdot L^*_{th}$). This relationship allows for the prediction of keyhole morphology across a wide range of processing conditions and materials.
Pore Formation Mechanisms
The study reveals that keyhole fluctuations occur at frequencies around 10 kHz in the transition regime. The lifecycle of a pore is characterized by three stages:
- Explosive Growth: Rapid expansion immediately following collapse as internal pressure equalizes.
- Condensation-Driven Shrinkage: The bubble shrinks as metal vapor inside the cavity condenses.
- Hydrogen Stabilization: The diffusion of hydrogen into the bubble slows its shrinkage, stabilizing its size before it is trapped by the solidification front.
Bubbles in the transition regime (Regime II) typically initiate at the mid-rear wall and exhibit higher migration speeds (avg. 2.4 m/s) compared to those in the unstable regime (Regime III), which form at the bottom and move more slowly (avg. 1.0 m/s).
Conclusion
By quantifying the high-frequency dynamics of the keyhole and the stabilizing role of hydrogen, this research provides a roadmap for mitigating porosity in LPBF. The identified 10 kHz signatures and universal scaling laws offer a foundation for developing real-time monitoring and closed-loop control systems to ensure the structural integrity of 3D-printed metal components.
Summary updated