Evaluation of separation effect of Oil Mist Separator based on extinction method

Guangyao Lin, Zhen Liu, Zhongli Ji, Fei HuE3S 2025 · DOI

Abstract

Natural gas as a kind of clean and green energy, in the process of gas storage reservoirs using large compressors to take injection, it is inevitable that the lubricating oil will be brought into the ground, resulting in the destruction of the underground environment. Measurement of lubricant oil mist can provide a theoretical basis for the removal and prevention of oil mist. In order to detect lubricant oil mist concentration online at pressures up to 35 MPa, a high-pressure natural gas oil mist concentration detection device based on the extinction method was designed and constructed. The theoretical model derives the scattering model of lubricant oil droplets under different pressures, clarifies the extinction effect of gas medium absorption, and uses a beam-focused non-parallel optical path to replace the traditional parallel optical path model. The actual industrial test results show that the program realizes the online detection under high pressure, and the error of the test results compared with the offline results is within 5%.

Introduction

In the natural gas industry, massive compressors are used to inject gas into underground storage reservoirs. During this process, mechanical shear and high temperatures cause lubricating oil to break up into a fine "oil mist." If this mist isn't filtered out, it can contaminate and damage the underground environment.

While Oil Mist Separators are used to clean the gas, monitoring their effectiveness in real-time is incredibly difficult. Most sensors fail at the high operational pressures (up to 35 MPa) required for injection. At these pressures, the refractive index of the gas changes significantly, causing light beams to deflect and distort, which renders standard optical sensors inaccurate. This paper tackles the challenge of creating a reliable, high-pressure, online extinction-based sensor.

Methodology

The authors utilized the Light Extinction Method, which is based on the Lambert-Beer law—measuring how much light is lost as it passes through a medium to determine the concentration of particles.

Experimental System Design

Schematic of the high-pressure oil mist detection system including the optical cell, filters, and dilution bypass. Source, p. 3

Schematic of the high-pressure oil mist detection system including the optical cell, filters, and dilution bypass.

Key technical innovations include:

  • Non-Parallel Optical Path: Instead of a standard parallel beam, the team designed a beam-focused, converging optical path using a double spherical lens. This design compensates for the beam shift and diameter changes caused by the high-pressure gas's refractive index.
  • Advanced Scattering Models: To accurately model how oil droplets interact with light, the researchers used Mie scattering theory and the Geometrical Optics Approximation (GOA). Droplets involve complex internal reflections and refractions; the authors used the Debye Series Expansion (DSE) to account for these effects.
  • Gas Medium Correction: They used Differential Optical Absorption Spectroscopy (DOAS) to calculate and subtract the extinction effect caused by the high-pressure gas itself.
  • Dilution System: Because oil mist concentrations can exceed limits, they implemented a clean gas bypass to dilute samples for accurate sizing.

Results and Discussion

The device successfully operated at 35 MPa, a significantly higher pressure than standard optical monitors. One of the biggest hurdles at these pressures is that the gas becomes dense enough to act like a lens, bending light beams. The researchers used a non-parallel converging path to "trap" the transmitted light at a fixed position regardless of these refractive changes.

Experimental results showing transmission concentration ($C_m$) tracking the calibration benchmark of 782 mg/m³.

As shown in the experimental results, the transmission concentration ($C_m$) closely tracked the calibration concentration of 782 mg/m³, demonstrating the system's reliability over multiple test runs. The online measurement error was within 5% when compared to offline sampling results. The researchers also identified that while turbulence and temperature inhomogeneities cause signal fluctuations ("light flickering"), these variations do not significantly impact the mean value of the concentration, validating the stability of the extinction method for industrial use.

Conclusion

Researchers have developed a novel online monitoring system capable of measuring lubricating oil mist in natural gas pipelines at extreme pressures up to 35 MPa. By combining a non-parallel optical path design with advanced light-scattering models, the system achieves an impressive accuracy of within 5% compared to traditional offline methods. Future work may explore how this optical geometry performs across a wider range of gas compositions and atmospheric environments.

Summary updated

Abstract

Natural gas as a kind of clean and green energy, in the process of gas storage reservoirs using large compressors to take injection, it is inevitable that the lubricating oil will be brought into the ground, resulting in the destruction of the underground environment. Measurement of lubricant oil mist can provide a theoretical basis for the removal and prevention of oil mist. In order to detect lubricant oil mist concentration online at pressures up to 35 MPa, a high-pressure natural gas oil mist concentration detection device based on the extinction method was designed and constructed. The theoretical model derives the scattering model of lubricant oil droplets under different pressures, clarifies the extinction effect of gas medium absorption, and uses a beam-focused non-parallel optical path to replace the traditional parallel optical path model. The actual industrial test results show that the program realizes the online detection under high pressure, and the error of the test results compared with the offline results is within 5%.
BibTeX
@inproceedings{lin2025evaluation,
  author = {Guangyao Lin and Zhen Liu and Zhongli Ji and Fei Hu},
  title = {{Evaluation of separation effect of Oil Mist Separator based on extinction method}},
  booktitle = {E3S},
  year = {2025},
  doi = {10.1051/e3sconf/202562801019},
}
Figure