Analecta of structures formed during the 28 June 1992 Landers-Big Bear, California earthquake sequence

A.m. Johnson, Robert W. Fleming, Kenneth M. Cruikshank, S.y. Martosudarmo, Norman Johnson, K. M. Johnson, Wei WeiAntarctica 1997 · DOI

Abstract

The 1992 Landers-Big Bear earthquake sequence provided a unique opportunity to study the complex structural manifestations of major strike-slip faulting. This paper synthesizes high-resolution field mapping and photogeologic analysis to demonstrate that faults are not simple lines but broad belts of shear zones. Key findings include the identification of hierarchical splintering, block rotations, and the role of surface guide fractures in reflecting deep-seated crustal mechanics.

Introduction

In classical seismology, faults are often idealized as simple lines on a map. However, this abstraction fails to explain the distributed damage and complex ground deformation observed after real events. The 1992 Landers earthquake revealed that strike-slip faults are not simple planar cracks but complex "belts of shear zones" up to 500 meters wide. This study addresses the gap between theoretical fault models and field reality, focusing on "distributed deformation"—where the Earth doesn't just snap in one place but "splinters" across a broad zone. Understanding these structures is vital for engineers designing infrastructure near fault lines and for geologists modeling the physics of earthquake propagation.

Methods

The researchers employed a "multi-scale" mapping approach to capture the full spectrum of deformation:

  • High-Resolution Field Mapping: Total station theodolites were used to map fractures at 1:200 and 1:500 scales, capturing details down to a few centimeters.
  • Photogeologic Analysis: 1:6000 scale aerial photographs taken at low sun angles were analyzed to identify regional patterns and vertical offsets.
  • Mechanical Modeling: Rheological models, specifically the "angle of dilatancy," were applied to translate surface crack orientations into a mathematical understanding of the stress state at depth.
  • Comparative Analogs: Parallels were drawn between earthquake ruptures and the slower, more observable deformation seen in large landslides.

The primary dataset consists of original, high-resolution mapping of the ~80 km Landers rupture zone, including detailed plates for the Johnson Valley, Homestead Valley, Emerson, and Kickapoo fault zones.

Key Insights and Structural Observations

The Landers rupture demonstrated several critical deviations from idealized fault models:

  • Faults as Belts, Not Lines: Ruptures manifest as "belts of shear zones" (50–500m wide). While most offset may occur on a main fault at the edge of the belt, significant deformation is distributed across the entire width.
  • Surface Fractures as "Guides": Surface cracks are often "guide fractures"—secondary features like en echelon tension cracks that mirror primary movement occurring kilometers below.
  • The Rotating Block: The entire Landers rupture forms a 60° arc. The authors propose that a massive "Landers-Big Bear block" with a 70–80km radius rotated counterclockwise during the event.
  • Hierarchical Splintering: Fault zones exhibit a fractal-like hierarchy. For example, an 800m fault element is often composed of 250m segments, which are themselves made of 25m elements.
Map of the Landers rupture zone showing the complex fault network and proposed block rotation.

Results

The team documented massive lateral shifts of up to 400 cm and vertical uplifts of 1 meter at tectonic ridges. Specific structures identified include:

  • Tectonic Ridges: Tortoise Hill was identified as a "push-up" structure that grew during the quake, characterized by "spines" of rock thrusting upward at varying rates.
  • Duplex Structures: At "releasing steps" (fault jogs), complex networks of smaller faults—duplex structures—allow the crust to pull apart, forming new basins.
  • Angle of Dilatancy: By measuring tension cracks oriented at 30°–35° to the fault walls, researchers calculated a 30° angle of dilatancy, providing a quantitative measure of how the crust expands during failure.

Discussion and Future Work

The study proves that wide shear belts are not merely a "soil effect," as these structures persist even through solid granitic bedrock. However, photogeologic mapping remains limited by lighting conditions, potentially missing fractures without vertical offset.

A major remaining challenge is reconciling surface geometry with depth. While surface features suggest shear belts extending 1.5–2.5 km down, seismological data indicates that "flower structures" (the branching of faults near the surface) might reach depths of 10 km. Future research must integrate high-resolution surface maps with deep-crustal geophysical data to create a comprehensive 3D model of earthquake failure.

Summary updated

BibTeX
@inproceedings{johnson1997analecta,
  author = {A.M. Johnson and Robert W. Fleming and Kenneth M. Cruikshank and S.Y. Martosudarmo and Norman Johnson and K. M. Johnson and Wei Wei},
  title = {{Analecta of structures formed during the 28 June 1992 Landers-Big Bear, California earthquake sequence}},
  booktitle = {Antarctica},
  year = {1997},
  doi = {10.3133/ofr9794},
}
Figure