300-GHz-band wireless communication using a low phase noise photonic source

Li Yi, Kenta Iwamoto, Takahisa Yamamoto, Fumiya Ayano, Antoine Rolland, Naoya Kuse, M. E. Fermann, Y. Li, Tadao Nagatsuma

Abstract

The implementation of advanced multi-level modulation schemes such as quadrature phase-shift keying (QPSK) is crucial to further boost terahertz (THz) communications speed beyond conventional on–off keying. However, carrier phase noise reduction in the THz range remains a critical challenge. This paper presents a low phase-noise photonic source based on a stimulated Brillouin scattering (SBS) optical fiber cavity applied to a 300-GHz-band QPSK wireless communication link. Utilizing this source, a data rate of 15 Gbaud was achieved at the forward-error-correction (FEC) limit with a transmit power of approximately −36 dBm. The SBS-based source demonstrates superior performance over conventional optical frequency comb generator (OFCG)-based sources in terms of phase noise, optical carrier-to-noise ratio, and bit error rate.

Introduction: The Phase Noise Challenge in THz Communications

To achieve wireless data rates exceeding 100 Gbit/s, researchers are targeting the Terahertz (THz) band, specifically the 300 GHz range, which offers vast available bandwidth. While simple on-off keying (OOK) has been the standard, reaching higher spectral efficiency requires multi-level modulation schemes like Quadrature Phase Shift Keying (QPSK).

The primary obstacle for QPSK at these frequencies is phase noise. In both electronic and photonic systems, phase instability scales poorly as frequencies are multiplied to reach the THz regime. High phase noise "smears" the signal constellation, making it difficult for receivers to distinguish between symbols, as illustrated in the theoretical models of BPSK and QPSK constellations.

Impact of phase noise on BPSK and QPSK constellations.

Methodology: SBS-Based Photonic Source

The proposed solution utilizes a photonic source based on Stimulated Brillouin Scattering (SBS) within an optical fiber cavity. This process leverages the "noise-cleaning" properties of the SBS effect, where a physical interaction between light and acoustic waves creates a narrow-band Stokes wave. This wave acts as a natural filter, significantly narrowing the linewidth of the lasers used.

The system employs two independent continuous-wave (CW) lasers locked to different modes of the SBS cavity. This locking mechanism ensures that the relative frequency difference between the two lasers—which determines the 300 GHz carrier frequency—remains extremely stable. These "cleaned" optical signals are then mixed in a Uni-Traveling-Carrier Photodiode (UTC-PD) to generate the THz electrical signal.

Photonic generation of THz signals using dual-laser mixing.

Key Results and Performance Comparison

The SBS-based source was compared against a standard Optical Frequency Comb Generator (OFCG). Key findings include:

  • Phase Noise Reduction: The source achieved a phase noise of −90 dBc/Hz at a 10 kHz offset at 300 GHz. Unlike traditional frequency multiplication, the SBS approach does not suffer from quadratic noise scaling with frequency.
  • Improved Power Efficiency: The SBS source provided a Carrier-to-Noise (C/N) ratio approximately 8 dB higher than the OFCG source. This efficiency stems from the SBS system concentrating pump energy into the two required optical tones, whereas OFCGs waste energy on unused comb lines.
  • High Data Rates: The experimental link successfully transmitted 15 Gbaud (30 Gbit/s) at the FEC-limited condition with a very low transmit power of −36 dBm.
  • Sensitivity: At 5 Gbaud, the SBS source reached the FEC limit at −45 dBm transmit power, outperforming the OFCG source which required −42 dBm.

Conclusion and Future Outlook

The application of an SBS-based photonic source represents a significant step toward high-speed, low-noise THz wireless links. While the current transmitter demonstrates exceptional performance, future work will focus on upgrading the receiver with similar low-noise technology to eliminate the current electronic local oscillator bottleneck. Additionally, packaging the fiber cavity to mitigate environmental sensitivities (vibration and temperature) will be essential for practical deployment. The success with QPSK suggests that even higher-order modulations, such as 32 QAM, may be achievable with this technology.

Summary updated

Abstract

Abstract The implementation of advanced multi-level modulation schemes such as quadrature phase-shift keying (QPSK) in contrast to the conventional on–off keying is crucial to further boost the terahertz (THz) communications speed. Thereby, carrier phase noise reduction in the THz range is one of the key goals that need to be urgently achieved. In this paper, the photonic-based THz sources and the phase noise problem are briefly summarized. Then, a low phase-noise photonic source based on the stimulated Brillouin scattering (SBS) optical fiber cavity is first applied for a 300-GHz-band QPSK wireless communication link. The highest data rate at forward-error-correction limited condition was 15 Gbaud utilizing the SBS-based photonic source with a small transmit power of ~ −36 dBm. Its transmission characteristics are evaluated and compared with the conventional optical frequency comb generator (OFCG)-based source at 5 Gbaud. The proposed SBS-based photonic source has been proven to offer better performances than the OFCG-based source with respect to the phase noise, optical carrier to noise ratio, and bit error rate in communications.
BibTeX
@article{yi2020ghz,
  author = {Li Yi and Kenta Iwamoto and Takahisa Yamamoto and Fumiya Ayano and Antoine Rolland and Naoya Kuse and M. E. Fermann and Y. Li and Tadao Nagatsuma},
  title = {{300-GHz-band wireless communication using a low phase noise photonic source}},
  journal = {International Journal of Microwave and Wireless Technologies},
  year = {2020},
  doi = {10.1017/s175907872000029x},
}
Figure