Abstract
This paper explores the effects of different contents of silicone defoamer on the coagulation time and compressive strength of building phosphogypsum. Using Origin software, the researchers processed experimental data to verify a non-linear Gaussian fitting equation, establishing a mathematical framework for material optimization.
Introduction
The production of wet phosphoric acid generates approximately 4.5 tons of phosphogypsum (PG) waste for every ton of phosphate produced. While PG has potential as a building material, its high porosity—caused by organic impurities and trapped air bubbles—weakens its structural integrity. This study focuses on PG from Yunnan, China, aiming to reduce porosity and enhance strength using silicone defoamers to make it a viable alternative to traditional construction materials.
Methodology
The researchers employed a multi-step experimental approach:
- Preprocessing: Raw PG was sieved and washed to remove soluble organic impurities.
- Chemical Modification: 0.35% citric acid was added as a habit modifier, and $Ca(OH)_2$ was used to neutralize the mixture to a pH of ~7.
- Thermal Treatment: The mixture was baked at 140°C for 3.5 hours.
- Additive Testing: Varying concentrations of silicone defoamer (0% to 1.0%) were added to the PG paste.
- Mathematical Modeling: Origin software was used to perform non-linear Gaussian fitting to derive equations modeling the relationship between silicone content, strength, and setting times.
Key Results and Discussion
Compressive Strength Optimization
The study identified a non-linear, bell-shaped relationship between silicone content and compressive strength. The researchers identified an optimal dosage of approximately 0.39% to 0.4%.
At the optimal 0.4% dosage, compressive strength peaked at 12.9 MPa, representing a 70% improvement over the control group's 7.6 MPa. This is attributed to the "bubble-breaking" mechanism: silicone molecules spread over internal liquid bubbles and rupture them, significantly reducing the porosity of the final block.
Setting Time and Retardation
Silicone also acted as a mild retarder, prolonging the setting time by reducing the hydration reaction rate. This is beneficial for construction, providing more time for pouring and shaping.
The longest initial setting time (20 min) and final setting time (34 min) were achieved at the 0.4% dosage level. The high correlation of the Gaussian models ($R^2$ up to 0.987) demonstrates that material performance can be precisely engineered and predicted.
Conclusion
While the study successfully models the optimization of Yunnan phosphogypsum, the researchers note that regional variations in PG impurities may require adjustments to the Gaussian parameters for other sources. Future work should investigate the long-term durability and weathering of these silicone-enhanced materials. Nonetheless, the use of non-linear fitting provides a robust method for transforming industrial waste into high-quality building components.
Summary updated