The performance of SiPM-based gamma-ray detector (GRD) of GECAM-C

Dali Zhang, Chao Zheng, Jia-Cong Liu, Zhenghua An, Chenwei Wang, Xiang-Yang Wen, Xinqiao Li, Xilei Sun, Ke Gong, Yaqing Liu, Xiao-Jing Liu, S. Yang, Wen-Xi Peng, Rui Qiao, D. Y. Guo, Peiyi Feng, Yan-Qiu Zhang, W. C. Xue, Wenjun Tan, Ce Cai, Shuo Xiao, Qi-Bin Yi, Yanbing Xu, Gao Min, Jinzhou Wang, Dongjie Hou, Yue Huang, Xiaoyun Zhao, Xiang Ma, Ping Wang, Xiao‐Bo Li, Peng Zhang, Zhen Zhang, Yanguo Li, Hui Wang, X. H. Liang, Yuxi Wang, Bing Li, Jianying Ye, Shijie Zheng, L. M. Song, Fan Zhang, Gang Chen, S. L. Xiong

TL;DR

GECAM-C (the High Energy Burst Searcher) successfully demonstrates that Silicon Photomultiplier (SiPM)-based detectors can thrive in the harsh radiation environment of space. By optimizing operating voltages and implementing adaptive temperature compensation, the mission achieved a tenfold improvement in detector stability compared to its predecessor, GECAM-B, paving the way for long-term multi-messenger astronomy.

What Problem Does This Paper Address?

In the era of multi-messenger astronomy, catching the electromagnetic counterparts of gravitational waves (GWs) and fast radio bursts (FRBs) requires constant, all-sky gamma-ray monitoring. Traditional detectors often use bulky Photomultiplier Tubes (PMTs), but modern missions are shifting toward Silicon Photomultipliers (SiPMs) because they are compact, lightweight, and operate at low voltages.

However, SiPMs have a major Achilles' heel: they are highly sensitive to temperature fluctuations and radiation damage. In orbit, high-energy particles cause "dark current" to grow, which increases electronic noise and can eventually blind the detector. The GECAM-B mission, launched in 2020, saw its SiPM performance degrade rapidly due to these factors. This paper evaluates how GECAM-C (launched in July 2022) addressed these challenges through hardware and software refinements.

Methods

GECAM-C employs 12 Gamma-Ray Detectors (GRDs) using two types of scintillating crystals: Lanthanum Bromide ($LaBr_3$) for high-speed timing and Sodium Iodide ($NaI(Tl)$) for broad-spectrum sensitivity.

To solve the degradation issues seen in previous missions, the team implemented three key strategies:

  1. Voltage Optimization: They reduced the SiPM bias voltage to slow down the growth of radiation-induced dark current. To maintain signal strength, they compensated for the lower SiPM gain by increasing the gain of the pre-amplifiers.
  2. Adaptive Temperature Compensation: SiPM gain changes with temperature. The team developed an "Adaptive Voltage Supply" that uses a Look-Up Table (LUT) to automatically adjust the bias voltage in real-time as the satellite moves through different thermal environments.
  3. In-Flight Calibration: Since on-ground calibration shifts once in space, the team used intrinsic radioactive lines (like the 37.4 keV line from $^{138}La$ in the $LaBr_3$ crystals) and activated lines (like the 191 keV line in $NaI$) to calibrate the energy scale while in orbit.

Datasets

The paper relies on two primary data sources:

  • On-Ground Calibration: Conducted at the Hard X-ray Calibration Facility (HXCF) at the National Institute of Metrology in China, using monochromatic X-ray beams (5–140 keV) and radioactive sources like $^{22}Na$ and $^{241}Am$.
  • In-Flight Performance Data: Real-world telemetry from the SATech-01 satellite, including background spectra and SiPM current measurements collected during the commissioning phase (starting August 2022). This was compared directly against the historical performance data of GECAM-B.

Key Insights and Ideas

  • The "Lower is Better" Voltage Strategy: The most significant insight is that operating SiPMs at a lower bias voltage—while boosting the electronic gain downstream—is a winning trade-off for longevity. It drastically reduces the rate at which radiation damage manifests as noise.
  • Orbit Matters: GECAM-C flies at a lower altitude (500 km) and higher inclination (97.4°) than GECAM-B. This orbit results in a significantly lower simulated radiation dose (95.8 rad/year vs. 724.8 rad/year), which contributes to the improved performance.
  • Smart Power Management: To protect the sensors, GECAM-C uses a dedicated strategy where most detectors are turned off when passing through high-latitude regions or the South Atlantic Anomaly (SAA), where particle flux is highest, while leaving one detector (GRD01) on to monitor the environment.

Key Results

  • Superior Stability: The SiPM current growth rate for GECAM-C is only 0.046 $\mu$A/day, nearly ten times slower than GECAM-B’s rate of 0.429 $\mu$A/day.
  • Lower Noise: The noise growth rate was reduced to 0.025 keV/day, compared to 0.1 keV/day for the previous mission.
  • Energy Resolution: In-flight performance met expectations, with an energy resolution of approximately 21% at 37.4 keV for $LaBr_3$ detectors and 11% at 191 keV for $NaI$ detectors.
  • Dynamic Range: The dual-channel readout successfully covers an energy range from 6 keV up to 6 MeV, making it capable of detecting both faint transients and extremely bright bursts like the "brightest of all time" GRB 221009A.

Limitations and Future Work

While the initial results are excellent, the authors note that SiPM performance will inevitably deteriorate over the long term due to cumulative radiation. The current bias voltage LUT is designed to be updatable via ground command to adapt to this evolution.

Future work will focus on the joint observation capabilities of GECAM-B and GECAM-C to improve localization accuracy for gamma-ray bursts. Additionally, the data gathered here will serve as a critical reference for upcoming missions like POLAR-2, which will also rely heavily on SiPM technology.

Summary updated

Abstract

As a new member of GECAM mission, the GECAM-C (also called High Energy Burst Searcher, HEBS) is a gamma-ray all-sky monitor onboard SATech-01 satellite, which was launched on July 27th, 2022 to detect gamma-ray transients from 6 keV to 6 MeV, such as Gamma-Ray Bursts (GRBs), high energy counterpart of Gravitational Waves (GWs) and Fast Radio Bursts (FRBs), and Soft Gamma-ray Repeaters (SGRs). Together with GECAM-A and GECAM-B launched in December 2020, GECAM-C will greatly improve the monitoring coverage, localization, as well as temporal and spectral measurements of gamma-ray transients. GECAM-C employs 12 SiPM-based Gamma-Ray Detectors (GRDs) to detect gamma-ray transients . In this paper, we firstly give a brief description of the design of GECAM-C GRDs, and then focus on the on-ground tests and in-flight performance of GRDs. We also did the comparison study of the SiPM in-flight performance between GECAM-C and GECAM-B. The results show GECAM-C GRD works as expected and is ready to make scientific observations.
BibTeX
@inproceedings{zhang2023performance,
  author = {Dali Zhang and Chao Zheng and Jia-Cong Liu and Zhenghua An and Chenwei Wang and Xiang-Yang Wen and Xinqiao Li and Xilei Sun and Ke Gong and Yaqing Liu and Xiao-Jing Liu and S. Yang and Wen-Xi Peng and Rui Qiao and D. Y. Guo and Peiyi Feng and Yan-Qiu Zhang and W. C. Xue and Wenjun Tan and Ce Cai and Shuo Xiao and Qi-Bin Yi and Yanbing Xu and Gao Min and Jinzhou Wang and Dongjie Hou and Yue Huang and Xiaoyun Zhao and Xiang Ma and Ping Wang and Jin Wang and Xiao‐Bo Li and Peng Zhang and Zhen Zhang and Yanguo Li and Hui Wang and X. H. Liang and Yuxi Wang and Bing Li and Jianying Ye and Shijie Zheng and L. M. Song and Fan Zhang and Gang Chen and S. L. Xiong},
  title = {{The performance of SiPM-based gamma-ray detector (GRD) of GECAM-C}},
  booktitle = {Nuclear},
  year = {2023},
  doi = {10.1016/j.nima.2023.168586},
}
Figure