Abstract
LoRaWAN is one of the most promising standards for long-range sensing applications. However, the high number of end devices expected in at-scale deployment, combined with the absence of an effective synchronization scheme, challenge the scalability of this standard. In this paper, we present an approach to increase network throughput through a Slotted-ALOHA overlay on LoRaWAN networks. To increase the single channel capacity, we propose to regulate the communication of LoRaWAN networks using a Slotted-ALOHA variant on the top of the Pure-ALOHA approach used by the standard; thus, no modification in pre-existing libraries is necessary. Our method is based on an innovative synchronization service that is suitable for low-cost wireless sensor nodes. We modelled the LoRaWAN channel with extensive measurement on hardware platforms, and we quantified the impact of tuning parameters on physical and medium access control layers, as well as the packet collision rate. Results show that Slotted-ALOHA supported by our synchronization service significantly improves the performance of traditional LoRaWAN networks regarding packet loss rate and network throughput.
The Scalability Bottleneck: Pure ALOHA
LoRaWAN is a leading standard for Long Range Wide Area Networks (LPWAN), but it faces a significant scalability challenge. By default, LoRaWAN utilizes Pure ALOHA, a medium access protocol where devices transmit whenever they have data. In dense network deployments, this leads to frequent "collisions" where overlapping packets become unreadable, wasting energy and bandwidth.
While textbook Pure ALOHA has a theoretical maximum throughput of approximately 18%, LoRaWAN’s specific timing requirements—such as mandatory receive windows—actually drop this effective limit even lower. In half-duplex confirmed mode, the effective throughput limit can fall to around 8%.
The Vulnerability Period
A critical insight of this research is that LoRaWAN's vulnerability period is significantly larger than standard Pure ALOHA. Due to the mandatory wait times for receive windows (RX1 and RX2), the vulnerability period is approximately $2 \times (2.2T)$, where $T$ is the packet airtime. This makes standard LoRaWAN much more susceptible to interference than simpler ALOHA implementations.
Proposed Solution: Slotted ALOHA Overlay
To address these inefficiencies, the researchers proposed a Slotted ALOHA (S-ALOHA) overlay. By dividing time into discrete slots and requiring nodes to transmit only at slot boundaries, the vulnerability period is theoretically halved, doubling the potential throughput.
Lightweight Synchronization
The primary challenge for S-ALOHA in LPWANs is maintaining synchronization across thousands of low-cost, battery-powered nodes. The authors developed an innovative "piggybacked" synchronization service:
- Sync via ACK: Nodes synchronize their internal Real-Time Clocks (RTC) using timestamps embedded in standard gateway acknowledgement (ACK) packets.
- Offset Calculation: Nodes calculate the time difference between transmission end and ACK reception, accounting for flight time and standard LoRaWAN RX delays.
- Zero-Modification Design: This logic sits on top of existing LoRaWAN stacks, ensuring compatibility with off-the-shelf commercial gateways and node libraries.
Performance Evaluation
The system was evaluated using both MATLAB simulations for large-scale modeling (up to 1,000 nodes) and real-world deployments of 24 custom-designed end nodes in structural monitoring and supercomputing environments.
Key Results
- Throughput Gains: In high-traffic scenarios, the Slotted LoRaWAN achieved a throughput of 15%, compared to just 2.6% for standard LoRaWAN—a 5.8x improvement.
- Collision Reduction: Real-world tests demonstrated a 26% reduction in packet collisions among the 24 nodes.
- Sync Accuracy: The synchronization service achieved an average error of only 5.37ms, well within the safety margins required for 2-second time slots.
- Hardware Resilience: Analysis showed that even with standard 80ppm crystals, nodes only require re-synchronization every 40 minutes to maintain operational tolerance.
Conclusion and Future Work
The S-ALOHA overlay provides a practical, high-impact upgrade for LoRaWAN scalability without requiring hardware or library overhauls. While current synchronization accuracy is slightly limited by gateway OS jitter (Linux), future implementations using hardware-level GPS timestamping could further refine performance. This approach paves the way for denser, more reliable IoT deployments in congested spectrum environments.
Summary updated