Abstract
Walking balance is central to independent mobility, and falls due to loss of balance are a leading cause of death for people 65 years of age and older. Bipedal gait is typically unstable, but healthy humans use corrective torques to counteract perturbations and stabilize gait. Exoskeleton assistance could benefit people with neuromuscular deficits by providing stabilizing torques at lower-limb joints to replace lost muscle strength and sensorimotor control. However, it is unclear how applied exoskeleton torques translate to changes in walking kinematics. This study used musculoskeletal simulation to investigate how exoskeleton torques applied to the ankle and subtalar joints alter center of mass kinematics during walking. We first created muscle-driven walking simulations using OpenSim Moco by tracking experimental kinematics and ground reaction forces recorded from five healthy adults. We then used forward integration to simulate the effect of exoskeleton torques applied to the ankle and subtalar joints while keeping muscle excitations fixed based on our previous tracking simulation results. Exoskeleton torque lasted for 15% of the gait cycle and was applied between foot-flat and toe-off during the stance phase, and changes in center of mass kinematics were recorded when the torque application ended. We found that changes in center of mass kinematics were dependent on both the type and timing of exoskeleton torques. Plantarflexion torques produced upward and backward changes in velocity of the center of mass in mid-stance and upward and smaller forward velocity changes near toe-off. Eversion and inversion torques primarily produced lateral and medial changes in velocity in mid-stance, respectively. Intrinsic muscle properties reduced kinematic changes from exoskeleton torques. Our results provide mappings between ankle plantarflexion and inversion-eversion torques and changes in center of mass kinematics which can inform designers building exoskeletons aimed at stabilizing balance during walking.
Introduction
Walking is a constant act of falling and recovering. For the elderly or those with neuromuscular deficits, the ability to generate the "corrective torques" needed to maintain balance is often compromised, leading to life-threatening falls. While ankle exoskeletons show promise in assisting gait, we lack a clear understanding of the "input-output" relationship: if a device applies a specific burst of torque at the ankle, how exactly does the whole body’s center of mass (COM) respond? This paper seeks to provide a comprehensive "map" of how specific ankle exoskeleton torques—plantarflexion, inversion, and eversion—alter a walker's COM motion.
Methods
The researchers employed a two-step musculoskeletal simulation approach using OpenSim Moco based on a dataset of 5 healthy individuals walking at 1.25 m/s.
- Tracking Simulation: High-fidelity, muscle-driven simulations of "normal" walking were created by tracking experimental motion capture, ground reaction forces, and EMG data.
- Perturbation Simulation: Using forward integration, pulses of exoskeleton torque (lasting 15% of the gait cycle) were applied to the ankle and subtalar joints at different time points between foot-flat and toe-off.
A key technical contribution is the comparison between muscle-driven and torque-driven models. In the muscle-driven model, muscles possess intrinsic properties (like the force-velocity relationship) that can physically "resist" the exoskeleton's perturbation, whereas torque-driven models treat muscles as ideal torque generators.
Key Results and Insights
The study revealed that the timing of a torque pulse is critical. For example, applying plantarflexion torque during mid-stance pushes the COM backward and upward, whereas applying it near toe-off produces a forward velocity change.
- The "Muscle Buffer": Intrinsic muscle properties act as a mechanical buffer, reducing COM velocity changes by nearly a factor of two compared to models without them. This suggests designers must account for the user's anatomy.
- Directional Decoupling: Inversion and eversion torques primarily affected medio-lateral (side-to-side) velocity with minimal impact on forward/backward motion, making them "cleaner" tools for lateral balance control than plantarflexion.
- Center of Pressure (COP): Exoskeleton torques generally shifted the COP in the opposite direction of the COM motion (e.g., eversion shifted the COP medially, pushing the COM laterally).
Discussion and Future Work
While providing a vital roadmap for balance-stabilizing wearable robots, the study has limitations. The simulations used fixed muscle excitations, meaning they did not account for active neural reflexes or voluntary balance strategies. Future research will explore different walking speeds and the inertial effects of physical exoskeleton mass. These mappings can eventually be used to train neural network-based controllers for real-time, human-in-the-loop balance assistance.
Summary updated