Scalable Self-Adaptive Synchronous Triggering System in Superconducting Quantum Computing

Lihua Sun, Futian Liang, Jin Lin, Cheng Guo, Yu Xu, Sheng‐Kai Liao, Cheng-Zhi Peng

Abstract

Superconducting quantum computers (SQC) require precise, synchronous operation of digital-to-analog converter (DAC) arrays and analog-to-digital converters (ADC) for qubit control and measurement. This paper proposes a scalable, self-adaptive synchronous triggering system designed to ensure synchronized operation across multiple qubits. The system achieves a control signal skew of less than 25 ps. By upgrading the clock architecture, the 250 MHz single-tone phase noise of the DAC was improved by approximately 15 dB, while the phase noise of the 6.25 GHz qubit control signal saw a 6 dB improvement.

Introduction

The manipulation and measurement of qubits in superconducting quantum computers rely on a massive array of microwave pulses. As these systems scale, maintaining synchronization between hundreds of control channels becomes a critical challenge. Two primary hurdles must be overcome: clock skew/phase noise and digital metastability. Clock skew refers to timing differences between signals, while phase noise represents fluctuations that can degrade qubit fidelity. Metastability occurs when a trigger signal arrives too close to a clock edge, causing unpredictable timing jitters.

Illustration of phase jitter and metastability at the clock-trigger interface.

Previous systems exhibited skews around 0.5 ns, which is insufficient for high-precision quantum gates. Furthermore, manual calibration of cable lengths to avoid metastability is not feasible for large-scale processors.

Methodology

The proposed system utilizes a three-pronged approach to achieve ultra-low skew and high signal purity.

High-Performance Clock Tree

The system replaces individual clock generators with a homologous tree-based architecture. A single 10 MHz Rubidium atomic clock serves as the root, fanning out to high-performance generators (HMC7044/7043). This design ensures that all DACs and ADCs share a common, high-stability reference.

Architecture of the homologous clock tree distribution system.

Star-Like Triggering

A master-slave trigger model is implemented to coordinate operations. One Arbitrary Waveform Generator (AWG) acts as the "Master," distributing trigger pulses to "Slave" AWGs via a fan-out buffer. This supports complex "two-level" triggering necessary for qubit reset operations, where measurement data from an ADC informs immediate corrective pulses.

Self-Adaptive FPGA Calibration

To eliminate metastability, the system employs a "self-healing" mechanism using FPGA delay resources (IDELAYE and ODELAYE). The system automatically scans through 512 delay taps to identify the "stable region" where the trigger signal and clock edge are safely separated. Once the stable window is found, the system locks the timing to the center of this region, ensuring robust synchronization without manual intervention.

Experimental Results

The system was benchmarked using 10 AWGs to measure inter-channel synchronization and signal quality.

  • Synchronization Performance: The timing skew between different AWGs was reduced to less than 25 ps, a significant improvement over the previous 500 ps limit.
  • Signal Purity: The 250 MHz DAC phase noise improved by 15 dB. For the 6.25 GHz qubit control signal, a 6 dB improvement in phase noise was observed.
  • Long-term Stability: A 72-hour continuous stress test of the self-adaptive mechanism demonstrated zero synchronization failures, confirming the effectiveness of the metastability mitigation strategy.

Conclusion

The developed scalable, self-adaptive triggering system provides the high-precision timing and signal purity required for next-generation superconducting quantum computers. By combining a homologous clock tree with automated FPGA-based calibration, the system achieves sub-25 ps skew and significantly reduced phase noise. Future work will focus on validating these electronic improvements through direct measurement of qubit gate fidelities in live quantum processors.

Summary updated

Abstract

Superconducting quantum computers (SQC) can solve some specific problems which are deeply believed to be intractable for classical computers. The control and measurement of qubits can't go on without the synchronous operation of digital-to-analog converters (DAC) array and the controlled sampling of analog-to-digital converters (ADC). In this paper, a scalable self-adaptive synchronous triggering system is proposed to ensure the synchronized operation of multiple qubits. The skew of the control signal between different qubits is less than 25 ps. After upgrading the clock design, the 250 MHz single-tone phase noise of DAC has been increased about 15 dB. The phase noise of the 6.25 GHz qubit control signal has an improvement of about 6 dB.
BibTeX
@article{sun2020scalable,
  author = {Lihua Sun and Futian Liang and Jin Lin and Cheng Guo and Yu Xu and Sheng‐Kai Liao and Cheng-Zhi Peng},
  title = {{Scalable Self-Adaptive Synchronous Triggering System in Superconducting Quantum Computing}},
  journal = {IEEE Transactions on Nuclear Science},
  year = {2020},
  doi = {10.1109/tns.2020.2986260},
}
Figure