Introduction
Low back pain (LBP) is a pervasive public health challenge, often leading to physical disability and significant economic burdens for both individuals and society. While physical therapy is a cornerstone of LBP management, clinicians currently lack objective tools to monitor patient posture and movement outside of clinical encounters. Standard 3D optical motion capture systems are highly accurate but expensive and confined to laboratories. Portable alternatives, such as Inertial Measurement Units (IMUs), are often rigid and struggle to account for the complex skin-strain dynamics of the human spine.
To bridge this gap, researchers developed "Motion Tape" (MT), a low-profile, wearable sensor. MT is created by spray-coating piezoresistive graphene nanocomposites directly onto commercial kinesiology tape. This "skin-like" sensor moves with the body, providing a disposable and comfortable method for tracking movement. This study evaluates the concurrent validity of MT against gold-standard motion capture and assesses its acceptability among users.
Methods
The study utilized a mixed-methods approach with 10 healthy participants (5 male, 5 female; average age 22.4). Participants were fitted with a 3x2 matrix of MT sensors on their low backs, alongside retroreflective markers for a 16-camera Qualisys 3D optical motion capture system. The protocol included movements in three planes: sagittal (flexion and extension), frontal (lateral bending), and axial (rotation).
Concurrent validity was assessed using cross-correlation coefficients at zero phase shift, comparing MT strain data with kinematic angles derived from a multi-segmental spine model. Following laboratory testing, semi-structured interviews were conducted and analyzed using Rapid Qualitative Analysis (RQA) based on the Technology Acceptance Model (TAM) to identify themes regarding user experience and potential clinical utility.
Results
Visual inspection and statistical analysis confirmed that MT can effectively distinguish between different movement directions based on unique strain "fingerprints" across the sensor matrix.
Concurrent Validity
The sensors demonstrated high correlation with motion capture kinematics, particularly when the tape was in tension. Median cross-correlation values were highest for lateral bending (0.87–0.94) and rotation (0.84–0.93). While flexion also showed strong correlation (0.62–0.93), it presented a 41.7% sensor failure rate because the extreme stretch of the low back during deep bending exceeded the sensor's current electrical capacity.
Technical Insights
- Sensor Dynamics: Performance was superior during stretching (tension) compared to bunching (compression), where signals became noisier. A "rebound effect"—a momentary resistance spike when returning to neutral—was identified as a target for future signal processing improvements.
- Muscle Engagement: Interestingly, some strain increases did not align perfectly with joint angles. Researchers hypothesize that MT may be detecting "muscle engagement" (the physical bulging of muscles under the skin), providing a physiological metric that traditional motion capture cannot detect.
User Acceptability
User feedback was overwhelmingly positive regarding the sensor's physical properties:
- Comfort and Security: 100% of participants found the tape secure and the removal process painless.
- Anatomical Fit: 90% agreed the sensor matrix fit well with their anatomy.
- Future Needs: Despite the enthusiasm, 70% of users expressed concerns about the current wired data acquisition setup, highlighting the necessity for a fully wireless, integrated system for home use.
Conclusion
This preliminary validation confirms that Motion Tape is a viable, acceptable tool for distinguishing and measuring low back movements. While the current prototype requires optimization for high-strain flexion and wireless connectivity, its ability to provide objective movement data in a low-profile format marks a significant step toward remote physical therapy monitoring. Future research will focus on testing the device in "free-living" environments and with populations currently experiencing low back pain.
Originally published in JMIR Rehabilitation and Assistive Technologies (2024;11:e57953).
Summary updated