Polarforming Design for Movable Antenna Systems

Zijian Zhou, Jingze Ding, Rui Zhang

TL;DR

This paper introduces a novel communication framework that combines Movable Antennas (MA) with Polarforming (reconfigurable polarization). By jointly optimizing an antenna's physical position and its electromagnetic polarization state, the researchers demonstrate significant improvements in data rates and signal reliability compared to traditional fixed-position or fixed-polarization systems.

What Problem Does This Paper Address?

In the quest for higher data rates, wireless researchers have traditionally focused on "spatial degrees of freedom"—using multiple antennas (MIMO) or, more recently, Movable Antennas (MA) that can physically shift to find the "sweet spot" in a local multi-path environment.

However, most MA research overlooks polarization. When a signal travels from a transmitter to a receiver, its polarization can rotate or become distorted (depolarization). If the receiver’s antenna isn't perfectly aligned with the incoming wave's polarization, significant signal power is lost. Existing solutions often use expensive dual-polarized antennas with two full radio frequency (RF) chains. This paper addresses the challenge of achieving high-performance polarization control (Polarforming) using low-cost hardware while simultaneously leveraging the spatial benefits of movable antennas.

Methods

The authors propose a Single-Input Single-Output (SISO) system where both the transmitter and receiver antennas are equipped with:

  1. Stepper Motors: To move the antenna within a 2D square region.
  2. Phase Shifters (PS): To control the phase difference between two orthogonal antenna elements (Vertical and Horizontal), allowing the system to synthesize any polarization state (linear, circular, or elliptical).

The Optimization Challenge

The goal is to maximize the achievable rate by jointly optimizing four variables: the 2D positions ($x, y$) and the polarization phase shifts ($\theta, \phi$) at both ends. This results in a non-convex optimization problem with highly coupled variables—a mathematical nightmare.

The Solution: SCA-based Alternating Optimization

To solve this, the authors developed an algorithm based on Successive Convex Approximation (SCA).

  • Alternating Optimization: The algorithm fixes the receiver's parameters to optimize the transmitter's, then swaps.
  • Surrogate Functions: Because the objective function is "bumpy" and non-linear (due to the trigonometric terms in the channel model), they use a second-order Taylor expansion to create a "surrogate" quadratic function. This surrogate provides a smooth, concave lower bound that is much easier to optimize iteratively.
  • Curvature Bound: They derive a specific mathematical bound ($\delta$) to ensure the approximation remains "globally conservative," guaranteeing that the algorithm consistently moves toward a maximum.

Datasets

As is standard for theoretical physical-layer communications research, the paper does not use a static dataset. Instead, it employs Monte Carlo simulations with 10,000 independent channel realizations. The channels are modeled using a Rician fading model that accounts for both a dominant line-of-sight path and multiple scattered paths.

Key Insights and Ideas

  • Synergy of DoFs: The "aha moment" is that spatial and polarization degrees of freedom are complementary. While moving the antenna helps navigate the "fading" of the signal power in space, polarforming ensures that whatever power is captured is actually "aligned" with the antenna hardware.
  • Cost-Effective Design: By using a single phase shifter rather than two full RF chains (as in Dual-Polarized Antennas), the authors achieve "Polarforming" gains with significantly lower hardware complexity and power consumption.
  • Robustness to Rician Fading: The study finds that as the line-of-sight (LoS) component becomes stronger, the benefit of moving the antenna decreases (because the "sweet spot" is less localized), but the benefit of polarforming remains high because the dominant path still needs precise polarization alignment.

Key Results

  • Performance Superiority: The proposed MA-PF (Movable Antenna + Polarforming) scheme consistently outperformed all benchmarks, including fixed-position antennas and antennas with fixed polarization (like linear or circular).
  • Fast Convergence: The SCA-based algorithm is highly efficient, typically reaching a maximum achievable rate within just 6 iterations.
  • Spatial Scaling: The gains of the MA-PF system increase as the "moving region" for the antenna grows, proving that the system effectively harvests spatial diversity.
  • Multipath Resilience: As the number of signal paths increases, the MA-PF system shows a steady increase in the achievable rate, whereas fixed systems plateau much earlier.

Limitations and Future Work

  • SISO Limitation: This study focuses on a single antenna at each end. Extending this to MIMO systems (multiple movable antennas) would introduce significant complexity regarding antenna spacing and mutual interference.
  • CSI Requirements: The model assumes "perfect channel state information" (CSI). In a real-world scenario, the channel must be estimated while the antenna is moving, which is a significant practical hurdle.
  • Mechanical Latency: The paper does not account for the time it takes for a stepper motor to physically move the antenna. In fast-fading environments, the "sweet spot" might move faster than the motor can react.

Future research could explore deep reinforcement learning to predict optimal positions and polarizations in real-time, bypassing the need for complex iterative optimization.

Summary updated

Abstract

Polarforming has emerged as a promising technique to enable the antenna to shape its polarization into a desired state for aligning with that of the received electromagnetic (EM) wave or reconfiguring that of the transmitted EM wave. In this letter, we investigate polarforming design for the movable antenna (MA)-enabled communication system. Specifically, we consider a single-input single-output (SISO) system with reconfigurable antenna position and polarization to leverage both spatial and polarization degrees of freedom (DoFs). First, we present a polarized channel model and characterize the channel response as a function of antenna positions and polarforming phase shifts. To maximize the achievable rate of the proposed system, we then develop a successive convex approximation (SCA)-based optimization algorithm by iteratively optimizing the antenna positions and phase shifts at both the transmitter and receiver. Furthermore, simulation results demonstrate the performance gains of the proposed system over conventional systems in mitigating channel depolarization and adapting to channel fading.
BibTeX
@article{zhou2025polarforming,
  author = {Zijian Zhou and Jingze Ding and Rui Zhang},
  title = {{Polarforming Design for Movable Antenna Systems}},
  journal = {IEEE Wireless Communications Letters},
  year = {2025},
  doi = {10.1109/lwc.2025.3622756},
}
Figure