Multi-robot deployment from LTL specifications with reduced communication

Marius Kloetzer, Xu Chu Ding, Călin Belta

Multi-robot Deployment From LTL Specifications with Reduced Communication

Abstract

In this paper, we develop a computational framework for fully automatic deployment of a team of unicycles from a global specification given as an LTL formula over some regions of interest. Our hierarchical approach consists of four steps: (i) the construction of finite abstractions for the motions of each robot, (ii) the parallel composition of the abstractions, (iii) the generation of a satisfying motion of the team; (iv) mapping this motion to individual robot control and communication strategies. The main result of the paper is an algorithm to reduce the amount of inter-robot communication during the fourth step of the procedure.

Introduction

Multi-robot coordination often relies on Linear Temporal Logic (LTL) to define complex mission requirements, such as sequencing visits to specific regions while avoiding others. Traditional methods typically employ a "parallel composition" of robot movements, treating the entire team as a single synchronized system. While mathematically rigorous, this approach suffers from state-space explosion and a heavy "communication tax"—robots must frequently synchronize at every region boundary, leading to inefficient, jerky movements and high battery consumption. This research proposes a middle ground: allowing robots to move independently and asynchronously, synchronizing only when strictly required by the mission logic.

Hierarchical Framework

The proposed framework follows a four-step hierarchical process to bridge high-level logic with low-level robot control:

  1. Abstraction: The continuous 2D environment is partitioned into convex triangular cells. The complex kinematics of unicycle-type robots are simplified into transition systems where movements are modeled as transitions between adjacent cells.
  2. Global Planning: Model checking tools are used to find a "satisfying run"—a sequence of movements for the entire team that fulfills the LTL specification.
Triangular partition of the environment into 40 regions (c1 to c40).

Communication Reduction

The core contribution of this work is an algorithm that minimizes synchronization points. By default, a global plan requires robots to synchronize at every cell transition. The authors introduce a heuristic algorithm that distinguishes between Weak Synchronization (ensuring a state is eventually reached by all) and Strong Synchronization (ensuring simultaneous entry into a state).

The algorithm iteratively removes synchronization requirements and uses a "test feasibility" procedure to check if unsynchronized interleavings could violate the LTL mission. This leverages the fact that many LTL specifications are "stutter-invariant," meaning the exact timing of internal boundary crossings often does not impact the overall logic. Robots only broadcast a "ready" signal when they hit a critical logic gate identified by the algorithm.

Product automaton illustrating state transitions and potential synchronization points.

Case Study and Results

The framework was evaluated using a case study of three unicycle robots in a 40-region environment tasked with a complex "visit and avoid" mission. Key results include:

  • Communication Efficiency: The algorithm reduced synchronization requirements from every cell transition to just two weak synchronization moments for the entire infinite mission.
  • Computational Speed: While initial global planning took approximately 100 minutes, the communication reduction phase was completed in just 30 seconds.
  • Qualitative Improvement: Robots exhibited smoother trajectories as they were no longer forced to stop and wait at every region boundary.

Conclusion and Future Work

This framework successfully decouples robot movements where logic permits, significantly reducing communication overhead. While the current algorithm is a heuristic, it provides a practical solution to the communication tax in formal multi-robot deployment. Future work will address the heuristic's optimality, extend the approach to heterogeneous teams, and incorporate stochastic models to handle environmental uncertainty and sensor noise.

Summary updated

Abstract

In this paper, we develop a computational framework for fully automatic deployment of a team of unicycles from a global specification given as an LTL formula over some regions of interest. Our hierarchical approach consists of four steps: (i) the construction of finite abstractions for the motions of each robot, (ii) the parallel composition of the abstractions, (iii) the generation of a satisfying motion of the team; (iv) mapping this motion to individual robot control and communication strategies. The main result of the paper is an algorithm to reduce the amount of inter-robot communication during the fourth step of the procedure.
BibTeX
@misc{kloetzer2011multi,
  author = {Marius Kloetzer and Xu Chu Ding and Călin Belta},
  title = {{Multi-robot deployment from LTL specifications with reduced communication}},
  year = {2011},
  eprint = {1108.3240},
  archivePrefix = {arXiv},
  url = {https://arxiv.org/abs/1108.3240},
}

Loading related content...

Figure