MOSCAB: A geyser-concept bubble chamber to be used in a dark matter search

The Moscab Collaboration, A. Antonicci, M. Ardid, R. Bertoni, G. Bruno, N. Burgio, Gianfranco Caruso, Daniele Cattaneo, F. Chignoli, M. Clemenza, Massimo Corcione, L. Cretara, D. Cudy, I. Felis, M. Frullini, W. Fulgione, M. T. Lucchini, L. Manara, Matteo Maspero, Antonio Papagni, M. M. Perego, R.b. Podviyanuk, A. Pullia, Alessandro Quintino, N. Redaelli, Elisa Ricci, A. Santagata, Domenico G. Sorrenti, L. Zanotti

Abstract

The MOSCAB experiment (Materia OSCura A Bolle) uses the "geyser technique", a variant of the superheated liquid technique of extreme simplicity. Operating principles of the new dark matter detector and technical solutions of the device are reported in detail. First results obtained in a series of test runs taken in laboratory demonstrate that we have successfully built and tested a geyser-concept bubble chamber that can be used in particle physics, especially in dark matter searches, and that we are ready to move underground for extensive data taking.

Introduction

The search for Weakly Interacting Massive Particles (WIMPs)—a leading candidate for dark matter—requires detectors that are both incredibly sensitive and capable of ignoring "noise" from common background radiation like beta and gamma rays.

Traditional bubble chambers are excellent at this; they use superheated liquids that only boil (forming a bubble) when hit by a heavy particle like a WIMP or a neutron, while remaining "blind" to lighter particles. However, standard bubble chambers are mechanically complex. They require pistons to reset the pressure after every event, and these moving parts can introduce dust or micro-fractures that act as false trigger sites. The MOSCAB collaboration seeks to eliminate this complexity using the "geyser technique."

Methods and Experimental Setup

The core of MOSCAB is a quartz vessel containing a target liquid (perfluoropropane, $C_3F_8$) and a buffer liquid (propylene glycol).

Schematic of the MOSCAB detector showing the target liquid, buffer liquid, and the geyser-concept cooling/heating zones.

The Geyser Mechanism

The target liquid is kept in a superheated, metastable state. When a particle interacts with a nucleus, it creates a tiny vapour bubble. This bubble rises through the liquid, pushing some of the target liquid up into a cooled "neck" area—resembling a geyser. Once the vapour reaches the cooled top portion of the device, it condenses back into liquid and falls back down. This resets the detector to its initial state automatically without any mechanical pumps or pistons.

Instrumentation and Control

The team uses a suite of sensors to monitor the chamber, including stereo cameras to capture bubble formation and hydrophones to record acoustic signatures. Thermal stability is maintained within $0.05^\circ C$ via a sophisticated water bath and recirculating thermostats.

Results and Discussion

The team conducted 56 test runs totaling approximately 400 hours of "live time." They used an AmBe (Americium-Beryllium) neutron source to simulate the nuclear recoils expected from WIMPs and collected background data to measure cosmic ray impact.

A captured image from the MOSCAB detector showing a bubble event (circled in red) within the target liquid.

Key Findings

  • Simplicity and Stability: By removing moving parts, the researchers avoided "particulate detachment" that usually plagues bubble chambers by triggering false positives.
  • Detection Threshold: At a superheat degree ($\Delta T$) of roughly $9^\circ C$, the detector reached an energy threshold of approximately 10 keV, the "sweet spot" needed to look for low-mass WIMPs.
  • Surface Quality: The team discovered that using flame-polished quartz significantly reduced "wall events" (bubbles forming at the edges of the container rather than in the liquid).

Conclusion and Future Work

The MOSCAB experiment has successfully demonstrated a 2-liter scale geyser-concept detector. While surface-level tests were limited by cosmic ray background, the next phase involves moving to the INFN Gran Sasso Laboratory, where the mountain overhead will shield the detector. Future work will focus on 3D event reconstruction to exclude wall-related noise and refining acoustic analysis to distinguish alpha particles from nuclear recoils.

Summary updated

Abstract

The MOSCAB experiment (Materia OSCura A Bolle) uses the "geyser technique", a variant of the superheated liquid technique of extreme simplicity. Operating principles of the new dark matter detector and technical solutions of the device are reported in detail. First results obtained in a series of test runs taken in laboratory demonstrate that we have successfully built and tested a geyser-concept bubble chamber that can be used in particle physics, especially in dark matter searches, and that we are ready to move underground for extensive data taking.
BibTeX
@article{collaboration2017moscab,
  author = {The MOSCAB Collaboration and A. Antonicci and M. Ardid and R. Bertoni and G. Bruno and N. Burgio and Gianfranco Caruso and Daniele Cattaneo and F. Chignoli and M. Clemenza and Massimo Corcione and L. Cretara and D. Cudy and I. Felis and M. Frullini and W. Fulgione and M. T. Lucchini and L. Manara and Matteo Maspero and Antonio Papagni and M. M. Perego and R.B. Podviyanuk and A. Pullia and Alessandro Quintino and N. Redaelli and Elisa Ricci and A. Santagata and Domenico G. Sorrenti and L. Zanotti},
  title = {{MOSCAB: A geyser-concept bubble chamber to be used in a dark matter search}},
  journal = {The European Physical Journal C},
  year = {2017},
  doi = {10.1140/epjc/s10052-017-5313-8},
}
Figure