MIMO-OFDM-Based Wireless-Powered Relaying Communication With an Energy Recycling Interface

Ali A. Nasir, Hoang Duong Tuan, Trung Q. Duong, H. Vincent Poor

Abstract

This paper investigates a wireless-powered relaying multiple-input-multiple-output (MIMO) communication system involving four nodes: an information source, an energy source, a relay, and a destination. By employing Orthogonal Frequency Division Multiplexing (OFDM) and a full-duplexing interface at the relay, the system harvests energy from both a dedicated energy source and its own loop-back transmissions. To address the resulting large-scale nonconvex optimization problem for power allocation, the authors propose a high-efficiency path-following algorithm. This algorithm achieves a computational speedup of over $10^5$ compared to standard solvers, enabling practical online implementation for high-spectral-efficiency communication.

Introduction: The Challenge of Powering the IoT

As the Internet of Things (IoT) and 5G networks expand toward trillions of sensors, traditional battery-based power becomes unsustainable. Wireless Power Transfer (WPT) offers a solution, but efficiency remains a hurdle. This research focuses on Full-Duplex (FD) relaying, where a relay simultaneously receives and transmits data. Typically, the relay's own transmission creates "self-interference" that must be canceled. This paper proposes a paradigm shift: treating this interference as a resource for energy harvesting, known as self-energy recycling.

System Architecture and Energy Recycling

The proposed system consists of four multi-antenna nodes. A relay (R) facilitates communication between a source (S) and a destination (D). To sustain its operation, the relay harvests energy from a nearby dedicated energy source (E) and recycles energy from its own output signal.

The four-node MIMO-OFDM relaying system model featuring self-energy recycling (loop energy).

The communication protocol is divided into two main phases within a time block $T$. In the first half ($T/2$), the source transmits information to the relay. In the second half, the relay forwards this information to the destination while simultaneously harvesting energy from the dedicated source and its own loop-back signal.

Transmission protocol illustrating the division of information and energy transfer phases.

Optimization via Path-Following Algorithm

Optimizing power allocation across thousands of OFDM subcarriers and multiple antennas is a complex nonconvex problem. Standard "black-box" solvers (like CVX) are too slow for real-time wireless environments, often taking over an hour for a single calculation.

The authors developed a path-following algorithm that:

  • Derives Closed-Form Solutions: By replacing nonconvex functions with specific concave/convex approximations, the algorithm finds analytical solutions at each iteration.
  • Achieves Linear Complexity: The computational load grows linearly with the number of subcarriers ($O(KN)$), making it exceptionally fast.
  • Enables Real-Time Processing: The algorithm reduces computation time from roughly 75 minutes to just 0.046 seconds—a $10^5$ speedup.

Key Results and Performance

Numerical simulations using 3GPP IMETRA MIMO channel models and up to 4,096 subcarriers demonstrate the system's effectiveness:

  • Spectral Efficiency: The optimized power allocation significantly outperforms baseline "Equal Power Allocation" strategies.
  • Recycling Gains: Self-energy recycling provides a tangible boost to spectral efficiency, proving that "interference" can indeed be an asset.
  • Robustness: The algorithm remains effective even with imperfect channel state information (CSI), which is common in real-world deployments.

Limitations and Future Directions

While promising, the system currently assumes a dedicated energy source is physically close to the relay, which may not always be feasible. Additionally, the hardware required for simultaneous transmission, reception, and energy harvesting is more complex than standard half-duplex components. Future research could extend this framework to multi-user scenarios or multi-relay networks.

Conclusion

By combining self-energy recycling with a hyper-efficient optimization algorithm, this work provides a viable path for self-sustaining, high-performance relaying in future wireless networks. The massive reduction in computational complexity transforms a theoretical model into a practical solution for online power management in complex MIMO-OFDM systems.

Summary updated

Abstract

This paper considers wireless-powered relaying multiple-input-multiple-output (MIMO) communication, where all four nodes (information source, energy source, relay, and destination) are equipped with multiple antennas. Orthogonal frequency division multiplexing (OFDM) is applied for information processing to compensate the frequency selectivity of communication channels between the information source and the relay and between the relay and the destination as these nodes are assumed to be located far apart from each. The relay is equipped with a full-duplexing interface for harvesting energy not only from the wireless transmission of the dedicated energy source but also from its own transmission while relaying the source information to the destination. The problem of designing the optimal power allocation over OFDM subcarriers and transmit antennas to maximize the overall spectral efficiency is addressed. Due to a very large number of subcarriers, this design problem poses a large-scale nonconvex optimization problem involving a few thousand variables of power allocation, which is very computationally challenging. A novel path-following algorithm is proposed for computation. Based on the developed closed-form calculation of linear computational complexity at each iteration, the proposed algorithm rapidly converges to an optimal solution. Compared to the best existing solvers, the computational complexity of the proposed algorithm is reduced at least 10 <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">5</sup> times, making it very efficient and practical for online computation while existing solvers are ineffective. Numerical results for a practical simulation setting show promising results by achieving high spectral efficiency.
BibTeX
@article{nasir2019mimo,
  author = {Ali A. Nasir and Hoang Duong Tuan and Trung Q. Duong and H. Vincent Poor},
  title = {{MIMO-OFDM-Based Wireless-Powered Relaying Communication With an Energy Recycling Interface}},
  journal = {IEEE Transactions on Communications},
  year = {2019},
  doi = {10.1109/tcomm.2019.2952897},
}
Figure