Limits on the Universal Method for Matrix Multiplication

Josh Alman

Abstract: In this work, we prove limitations on the known methods for designing matrix multiplication algorithms. Alman and Vassilevska Williams recently defined the Universal Method, which substantially generalizes all the known approaches including Strassen's Laser Method and Cohn and Umans' Group Theoretic Method. We prove concrete lower bounds on the algorithms one can design by applying the Universal Method to many different tensors. Our proofs use new tools for upper bounding the asymptotic slice rank of a wide range of tensors. Our main result is that the Universal method applied to any Coppersmith-Winograd tensor $CW_q$ cannot yield a bound on $\omega$, the exponent of matrix multiplication, better than $2.16805$. By comparison, it was previously only known that the weaker 'Galactic Method' applied to $CW_q$ could not achieve an exponent of $2$. We also study the Laser Method (which is, in principle, a highly special case of the Universal Method) and prove that it is "complete" for matrix multiplication algorithms: when it applies to a tensor $T$, it achieves $\omega = 2$ if and only if it is possible for the Universal method applied to $T$ to achieve $\omega = 2$. Hence, the Laser Method, which was originally used as an algorithmic tool, can also be seen as a lower bounding tool. For example, in their landmark paper, Coppersmith and Winograd achieved a bound of $\omega \leq 2.376$, by applying the Laser Method to $CW_q$. By our result, the fact that they did not achieve $\omega=2$ implies a lower bound on the Universal Method applied to $CW_q$. Indeed, if it were possible for the Universal Method applied to $CW_q$ to achieve $\omega=2$, then Coppersmith and Winograd's application of the Laser Method would have achieved $\omega=2$.

Introduction

Matrix multiplication is a fundamental operation in computer science, underpinning everything from computer graphics to deep learning. For decades, the central quest in theoretical computer science has been to determine the value of $\omega$, the exponent of matrix multiplication. This value represents the smallest constant such that two $n \times n$ matrices can be multiplied in $O(n^\omega)$ time. While the naive algorithm yields $\omega = 3$, and Strassen’s landmark 1969 result proved $\omega < 2.81$, the current best upper bound stands at approximately 2.37.

Since the late 1980s, nearly every improvement to this bound has relied on the "Laser Method" applied to a specific family of mathematical structures known as Coppersmith-Winograd ($CW$) tensors. However, a persistent question remained: are these methods inherently limited? Could a more sophisticated analysis of the same $CW$ tensors eventually prove that $\omega = 2$? This paper by Josh Alman establishes a definitive "speed limit" for this family of techniques, proving that current approaches cannot reach the theoretical ideal of $\omega = 2$ using standard tensors.

The Universal Method and Laser Method Completeness

To establish these limits, the paper utilizes the Universal Method, a theoretical framework that generalizes almost all known approaches to matrix multiplication, including the Laser Method and the Group-Theoretic Method of Cohn and Umans.

A significant contribution of this work is the proof of Laser Method Completeness. While the Laser Method is technically a specialized case of the Universal Method, Alman demonstrates that for the purpose of reaching $\omega = 2$, it is sufficient. Specifically, if the Universal Method can prove $\omega = 2$ using a particular tensor $T$, then the Laser Method can also prove $\omega = 2$ using that same tensor. This result justifies the community's long-standing focus on the Laser Method and allows researchers to use it as a tool for establishing lower bounds.

Technical Innovation: Asymptotic Slice Rank

The core technical innovation involves the use of asymptotic slice rank (denoted as $\tilde{S}(T)$). Slice rank is a measure of a tensor's complexity. Alman establishes a critical link between this complexity and algorithmic efficiency: if a method is to prove a very low value for $\omega$, the tensor it employs must possess a sufficiently high asymptotic slice rank.

To bound these values, the paper introduces three new combinatorial tools (Theorems 4.2, 4.4, and 4.8) to calculate upper bounds on the asymptotic slice rank for various tensors. By demonstrating that these tensors are not "complex" enough, the paper proves they are mathematically incapable of reaching $\omega = 2$ within the Universal Method framework.

Key Results and the 2.16805 Barrier

The paper provides concrete lower bounds for several prominent tensors used in the field:

  • The Coppersmith-Winograd Barrier: The most significant finding is that for any $CW_q$ tensor, the Universal Method cannot achieve $\omega < 2.16805$. This effectively sets a hard floor on the current algorithmic paradigm.
  • Record-Holder Limits: For $CW_5$, the specific tensor used to achieve the current world record, the limit is even more restrictive: $\omega_u(CW_5) \geq 2.21912$.
  • Cyclic Group Tensors: For tensors derived from the cyclic group $C_2$, the method is limited to $\omega \geq 2.17795$.
  • Tightness of Bounds: The author demonstrates that the developed upper bounds on slice rank are "tight," meaning they provide the exact value for these tensors rather than a mere approximation.

Conclusion and Future Directions

These results do not imply that $\omega > 2$ in an absolute sense. Rather, they prove that if $\omega = 2$, the proof will likely require a method or a tensor that falls outside the current "Universal" paradigm.

There remains a gap between the current best upper bound (~2.37) and the lower bounds established here (~2.16). Future research may focus on narrowing this gap or searching for entirely new tensors that lack the structural limitations identified in the $CW$ family. This work serves as a roadmap for the field, indicating exactly where the current tools fail and where new mathematical inventions are required.

Summary updated

Abstract

In this work, we prove limitations on the known methods for designing matrix multiplication algorithms. Alman and Vassilevska Williams recently defined the Universal Method, which substantially generalizes all the known approaches including Strassen's Laser Method and Cohn and Umans' Group Theoretic Method. We prove concrete lower bounds on the algorithms one can design by applying the Universal Method to many different tensors. Our proofs use new tools for upper bounding the asymptotic slice rank of a wide range of tensors. Our main result is that the Universal method applied to any Coppersmith-Winograd tensor $CW_q$ cannot yield a bound on $\omega$, the exponent of matrix multiplication, better than $2.16805$. By comparison, it was previously only known that the weaker `Galactic Method' applied to $CW_q$ could not achieve an exponent of $2$. We also study the Laser Method (which is, in principle, a highly special case of the Universal Method) and prove that it is "complete" for matrix multiplication algorithms: when it applies to a tensor $T$, it achieves $\omega = 2$ if and only if it is possible for the Universal method applied to $T$ to achieve $\omega = 2$. Hence, the Laser Method, which was originally used as an algorithmic tool, can also be seen as a lower bounding tool. For example, in their landmark paper, Coppersmith and Winograd achieved a bound of $\omega \leq 2.376$, by applying the Laser Method to $CW_q$. By our result, the fact that they did not achieve $\omega=2$ implies a lower bound on the Universal Method applied to $CW_q$. Indeed, if it were possible for the Universal Method applied to $CW_q$ to achieve $\omega=2$, then Coppersmith and Winograd's application of the Laser Method would have achieved $\omega=2$.
BibTeX
@inproceedings{alman2021limits,
  author = {Josh Alman},
  title = {{Limits on the Universal Method for Matrix Multiplication}},
  booktitle = {Adv. Math. Commun},
  year = {2021},
  url = {https://openreview.net/forum?id=OJIN67W16J},
}
Figure