Abstract
This paper studies an intelligent reflecting surface (IRS)-assisted integrated sensing and communication (ISAC) system, in which one IRS is deployed to not only assist the wireless communication from a multi-antenna base station (BS) to a single-antenna communication user (CU), but also create virtual line-of-sight (LoS) links for sensing targets at areas with LoS links blocked. We consider that the BS transmits combined information and sensing signals for ISAC. Under this setup, we jointly optimize the transmit information and sensing beamforming at the BS and the reflective beamforming at the IRS, to maximize the IRS's minimum beampattern gain towards the desired sensing angles, subject to the minimum signal-to-noise ratio (SNR) requirement at the CU and the maximum transmit power constraint at the BS. Although the formulated SNR-constrained beampattern gain maximization problem is non-convex and difficult to solve, we present an efficient algorithm to obtain a high-quality solution using alternating optimization and semi-definite relaxation (SDR). Numerical results show that the proposed joint beamforming design achieves improved sensing performance while ensuring the communication requirement as compared to benchmarks without such joint optimization. It is also shown that the use of dedicated sensing beams is beneficial in enhancing the performance for IRS-assisted ISAC.
Introduction
Integrated Sensing and Communication (ISAC) is a cornerstone of 6G technology, aiming to use the same hardware and spectrum for both data transmission and radar-like environmental sensing. However, a major physical hurdle remains: the requirement for Line-of-Sight (LoS) paths. While wireless communication can often thrive on multipath reflections, radar sensing typically requires a direct, unobstructed path to a target. In dense urban environments, buildings and trees often block these paths, creating sensing "dead zones."
This research addresses this by deploying an Intelligent Reflecting Surface (IRS)—a thin sheet of electromagnetic material with software-controlled elements—to create "virtual LoS" links. The challenge lies in jointly steering the beams from the Base Station (BS) and the reflections from the IRS to detect multiple targets hidden behind obstacles while maintaining high-quality user connectivity.
System Model and Methodology
The system model consists of a multi-antenna BS, a single-antenna communication user (CU), and an IRS with a Uniform Linear Array (ULA). The BS transmits a hybrid signal consisting of one information beam and multiple dedicated sensing beams.
To optimize this setup, the researchers formulated a "max-min" optimization problem to maximize the minimum beampattern gain across all potential target angles while satisfying a minimum SNR for the user. Due to the non-convex nature of the problem, an Alternating Optimization (AO) approach was used:
- Transmit Beamforming: Fix the IRS settings and optimize the BS beams using Semi-Definite Relaxation (SDR).
- Reflective Beamforming: Fix the BS beams and optimize the IRS phase shifts using SDR combined with Gaussian randomization.
Key Insights and Results
Numerical results demonstrate that the proposed joint beamforming design significantly outperforms separate optimization benchmarks. A key finding is the necessity of dedicated sensing beams; while information beams can sometimes assist in sensing, dedicated radar pulses provide the extra degrees of freedom needed to cover multiple target angles effectively, especially in random fading environments.
As shown in Figure 3, the IRS successfully forms multiple sharp peaks in its reflective beampattern, precisely targeting the specified sensing angles (e.g., -60°, -30°, 0°, 30°, and 60°) while maintaining the communication link for the CU. The proposed alternating optimization achieves higher beampattern gains at these "worst-case" target angles compared to separate beamforming designs.
The study also quantifies the communication-sensing trade-off: as the user's SNR requirement becomes more stringent, the system is forced to sacrifice sensing gain to ensure the communication link remains stable. However, the joint design remains robust even at high SNR thresholds where separate designs may become infeasible.
Conclusion
This work demonstrates that IRS can effectively extend the reach of ISAC systems by overcoming LoS blockages. By jointly optimizing transmit and reflective beamforming, the system can "see around corners" to detect targets without sacrificing user connectivity. Future research will focus on scaling this framework for multi-user scenarios and adapting to high-speed mobility.
Summary updated