Influence of explosion distance on the dynamic mechanical response of underground fortification

Qiang Lin, Chen Feng, Yongquan Gan, Paul Cheng, Wenjun Jiao, Yilei Zhang, Junfa YuanJournal of Physics Conference Series 2023 · DOI

Abstract

Many key military targets have been moved underground to improve battlefield survivability. To study the influence of explosion distance on the dynamic mechanical response of underground fortification, full-time numerical simulations were conducted using the Continuum-Discontinuum Element Method (CDEM). Four simulations at different explosion distances (5m, 10m, 15m, and 20m) were analyzed for displacement and fracture characteristics. Results show that damage weakens as distance increases; rock penetration volume dropped from 24.78 m³ at 5m to 0 m³ at 20m. Crack evolution follows a four-stage characteristic, with tensile fracture becoming the dominant mode at greater distances.

Introduction

The survivability of critical infrastructure and military assets increasingly depends on deep underground placement. However, the development of earth-penetrating projectiles has necessitated a deeper understanding of how detonation distance—or stand-off distance—affects structural integrity. Traditional continuum-based numerical models often fail to capture the complex transition from solid rock to fragmented debris following an explosion. This study utilizes a hybrid modeling approach to bridge this gap and provide quantitative insights into fortification failure.

Numerical Methodology

The researchers employed the Continuum-Discontinuum Element Method (CDEM), which integrates continuous simulation for solid states with discrete simulation for fragmentation. The model features a 15m wide, 10m high fortification with 1.8m thick concrete walls, embedded within a 200m x 250m rock mass.

Numerical model setup showing the rock mass, explosive location, and underground fortification.

The detonation of TNT was simulated using the Jones-Wilkins-Lee (JWL) equation of state at four distances: 5m, 10m, 15m, and 20m. A "crack ratio" ($\alpha$) was introduced to quantify the extent of damage by measuring the ratio of cracked interfaces to the total interface area.

Results and Discussion

Crack Evolution and Failure Modes

The study identified a distinct four-stage crack evolution process:

  1. Initial Shock: A rapid spike in cracking due to the primary shock wave.
  2. Gas Expansion: Slower growth as explosive gases expand.
  3. Secondary Impact: A second surge caused by collapsed concrete hitting the fortification floor.
  4. Equilibrium: Stabilization of the damage state.

At a distance of 5m, the structure experiences catastrophic failure through a combination of shear and tensile stresses. As shown in the displacement plots, this leads to significant rock penetration into the interior.

Displacement distribution at an explosion distance of 5m, illustrating catastrophic structural collapse and debris penetration.

The Impact of Stand-off Distance

The volume of rock entering the fortification is a critical metric for survivability. At 5m, 24.78 m³ of rock breached the interior. This volume remained relatively stable at 10m but dropped sharply as the distance increased further. At 20m, the rock penetration volume reached 0 m³. While the concrete walls still exhibited tensile cracking at 20m, the structure retained sufficient bearing capacity to prevent a total breach, effectively functioning as a shelter.

Conclusion

The distance of an explosion is a primary determinant of underground fortification survivability. Increasing the stand-off distance from 5m to 20m shifts the failure mode from catastrophic shear-induced collapse to manageable tensile cracking. Future research should extend these findings to 3D models and investigate the protective benefits of steel reinforcement within the concrete walls.

Summary updated

Abstract

Abstract Many key military targets have been moved underground to improve the battlefield survivability. To study the influence of explosion distance on the dynamic mechanical response of underground fortification, the full-time numerical simulation is conducted based on the CDEM numerical method. First, four numerical simulations corresponding to different explosion distances are conducted. Then, the displacement characteristic of underground fortification and rock mass is analyzed. Finally, the fracture characteristic of underground fortification and rock mass is analyzed. The numerical results show that the damage degree of underground fortification and rock mass weakens with the increase of explosion distance. When the distance increases from 5 m to 20 m, the volume of rock entering the underground fortification decreases from 24.78 m 3 to 0 m 3 . The time-history curve of crack ratio has the four-stage characteristic, and it increases rapidly during the explosion initiation process. As the explosion distance increases, the top concrete wall mainly undergoes tensile fracture.
BibTeX
@article{lin2023influence,
  author = {Qiang Lin and Chen Feng and Yongquan Gan and Paul Cheng and Wenjun Jiao and Yilei Zhang and Junfa Yuan},
  title = {{Influence of explosion distance on the dynamic mechanical response of underground fortification}},
  journal = {Journal of Physics Conference Series},
  year = {2023},
  doi = {10.1088/1742-6596/2478/7/072017},
}
Figure