Image Sensing Technology. Experimental Mobile Video Communication using PHS.

Satoshi Miyaji, Osamu Sugimoto, Shuichi Matsumoto, Fumihide Kojima, Katsuyoshi Sato, Masayuki Fujise, Ren Togo, Hideo KitajimaThe Journal of The Institute of Image Information and Television Engineers 2002 · DOI

Abstract

Real-time video communication was tested in a mobile environment using PHS and a very low bit-rate video codec. A vehicle equipped with PHS and the codec performed video communication with an indoor system while running along a given course. The communication protocols were PIAFS 32k (actually 29.2 kb/s) and UDP/IP. How throughput and picture quality were affected by the speed of the vehicle and how the electromagnetic-field intensity fluctuated with vehicle movement were measured. Results from this experiment revealed parameters of the video coding and packetizing ideal for use in mobile communication. The experiments showed that PHS could provide real-time mobile video communication at low to middle speeds within a service area.

Introduction

In the early 2000s, the transition from voice-only cellular to real-time mobile video was a significant technical challenge. This study explores the feasibility of streaming video through a 29.2 kb/s PHS (Personal Handy-phone System) connection while in motion. While modern 4K streaming is ubiquitous, this research captures the foundational work required to optimize ultra-low bit-rate communication in fluctuating wireless environments.

Problem Statement

The primary challenge was maintaining real-time video over UDP/IP in a mobile environment characterized by signal fluctuations, multipath fading, and handovers. Unlike TCP-based applications like web browsing, real-time video cannot rely on retransmissions without introducing unacceptable latency. The researchers aimed to determine if the circuit-switched PHS protocol could provide the necessary stability for a moving vehicle to maintain a video call.

Experimental Methodology

Field tests were conducted at the Yokosuka Research Park (YRP) using a vehicle equipped with a PHS terminal and a specialized hardware video encoder.

Experimental route and mobile system configuration

The experimental setup involved a car driving an 800-meter loop at speeds ranging from stationary to 30 km/h. The system utilized a proprietary ultra-low bit-rate codec (18.4 kb/s for video, 5.3 kb/s for audio).

The protocol stack used for the mobile video communication experiment

The protocol stack encapsulated the video and audio data in UDP/IP, then PPP, and finally transmitted it via the PIAFS (PHS Internet Access Forum Standard) protocol. Researchers manipulated the packet sending interval (60ms, 150ms, 240ms) and the I-frame interval (3s vs. 10s) to observe their effects on performance.

Key Insights

  • PIAFS Robustness: As a circuit-switched protocol, PIAFS handles error correction at the link layer, effectively "hiding" wireless errors from the upper UDP/IP layers. This makes it more robust for real-time applications than standard cellular protocols of that era.
  • The Speed Paradox: Throughput at 10 km/h was often superior to stationary performance. Moving through "dead spots" caused by multipath fading averages out signal quality, whereas a stationary terminal in a null point suffers continuous poor signal.
  • Overhead Constraints: Frequent small packets (60ms interval) led to excessive overhead from UDP/IP/PPP headers, consuming too much of the limited 29.2 kb/s bandwidth and causing congestion.
  • Error Recovery: A 3-second I-frame interval was identified as the optimal balance for mobile recovery. While 10-second intervals are more efficient, they result in long recovery times after handover-induced errors.

Results

The system achieved IP-layer throughput of approximately 24–25 kb/s with 150ms or 240ms packet intervals, representing high efficiency relative to the 29.2 kb/s physical limit. Packet loss was negligible at the 150ms interval across all speeds. The study concluded that a 150ms packet interval and a 3-second I-frame interval provided the best balance for mobile video communication.

Conclusion

The experiments demonstrated that PHS could support real-time mobile video communication at low to middle speeds. By optimizing packetizing and coding parameters, researchers proved that even very low bit-rate channels could handle the demands of mobile multimedia, paving the way for future 3G and 4G developments.

Summary updated

Abstract

Real-time video communication was tested in a mobile environment using PHS and a very low bit-rate video codec. A vehicle equipped with PHS and the codec performed video communication with an indoor system while running along a given course. The communication protocols were PIAFS 32k (actually 29.2 kb/s) and UDP/IP. How throughput and picture quality were affected by the speed of the vehicle and how the electromagnetic-field intensity fluctuated with vehicle movement were measured. Results from this experiment revealed parameters of the video coding and packetizing ideal for use in mobile communication. The experiments showed that PHS could provide real-time mobile video communication at low to middle speeds within a service area.
BibTeX
@article{miyaji2002image,
  author = {Satoshi Miyaji and Osamu Sugimoto and Shuichi Matsumoto and Fumihide Kojima and Katsuyoshi Sato and Masayuki Fujise and Ren Togo and Hideo Kitajima},
  title = {{Image Sensing Technology. Experimental Mobile Video Communication using PHS.}},
  journal = {The Journal of The Institute of Image Information and Television Engineers},
  year = {2002},
  doi = {10.3169/itej.56.455},
}
Figure