Hydrogen absorption in Ti–Zr–Ni quasicrystals and 1/1 approximants

J.y. Kim, Richard G. Hennig, V. T. Huett, P. C. Gibbons, K. F. KeltonJournal of Alloys and Compounds 2005 · DOI

TL;DR

This paper investigates the hydrogen storage potential of Ti-Zr-Ni quasicrystals and their crystalline approximants. The authors present pressure-composition isotherm (p-c-T) measurements, revealing that these materials can absorb significant amounts of hydrogen at relatively low temperatures and pressures, with the quasicrystal phase maintaining its integrity after limited cycling.

What Problem Does This Paper Address?

The quest for efficient and practical hydrogen storage materials is a critical challenge for the widespread adoption of hydrogen as a clean energy carrier. While many metal hydrides exist, they often suffer from drawbacks like high operating pressures, high temperatures for hydrogen release, or degradation over time. Ti-based quasicrystals, particularly Ti-Zr-Ni alloys, have emerged as promising candidates due to their ability to store large quantities of hydrogen reversibly at low temperatures and pressures. However, a detailed understanding of their hydrogen absorption behavior, specifically the equilibrium vapor pressure and the underlying site energies for hydrogen, is crucial for evaluating their technological viability. This paper aims to provide this missing information by measuring p-c-T isotherms and analyzing the hydrogen site energies in Ti-Zr-Ni quasicrystals and their related crystalline phases.

Methods

The researchers employed a computer-controlled apparatus to measure pressure-composition isotherms (p-c-T) for hydrogen absorption in Ti-Zr-Ni quasicrystals and a 1/1 crystalline approximant. Key experimental details include:

  • Sample Preparation: Samples were plasma-etched to remove surface barriers and then coated with a thin layer of palladium (Pd) to facilitate hydrogen diffusion.
  • p-c-T Measurement: Measurements were conducted in an evacuated chamber (volume 78.73 cc) with hydrogen gas introduced. Equilibrium pressure was defined as a change of less than 0.05 Torr over 1 hour. Temperatures ranged from 200 to 400°C.
  • Hydrogen Concentration Determination: The hydrogen-to-host metal atom ratio (H/M) was calculated from both pressure changes and weight gain measured by a micro-balance.
  • Site Energy Analysis: A model was used to relate the normalized hydrogen concentration (x) to the hydrogen pressure and site energies (Δμᵢ). Non-linear least squares fitting of the experimental p-c-T curves was performed to determine these site energies.
  • Structural Characterization: Transmission Electron Microscopy (TEM) and X-ray Diffraction (XRD) were used to analyze the morphology, structure, and phase transformations of the samples.

Datasets

Not discussed in the paper. The study relies on experimental measurements rather than pre-existing datasets.

Key Insights and Ideas

  • No Clear Pressure Plateau in Quasicrystals: Unlike many conventional metal hydrides, the Ti-Zr-Ni quasicrystals do not exhibit a distinct pressure plateau in their p-c-T curves. Instead, the equilibrium vapor pressure remains low until a certain hydrogen concentration (H/M ≈ 1) and then increases sharply. This suggests a more complex distribution of hydrogen binding sites compared to simple phase transitions.
  • Structural Similarity Between Quasicrystal and Approximant: The p-c-T curves for the quasicrystal and its 1/1 crystalline approximant show similar trends, hinting at structural similarities that influence hydrogen absorption behavior. The approximant, however, shows a "hint" of a pressure plateau, suggesting a more ordered structure.
  • Hydrogen Cycling Maintains Integrity: A crucial finding for practical applications is that the Ti-Zr-Ni quasicrystals can undergo limited hydrogen absorption-desorption cycles without transforming into powder. This indicates good structural stability.
  • Pd Addition Enhances Absorption Rate: Adding a small amount of palladium (Pd) to the quasicrystals significantly increases the hydrogen absorption rate, suggesting improved diffusion kinetics.
  • Hydride Phase Formation at Higher Temperatures: Above 400°C, the quasicrystal phase can transform into a hydride phase, which is undesirable for maintaining the quasicrystalline structure for storage. However, annealing above 638°C can reform the quasicrystal phase.

Key Results

  • The Ti-Zr-Ni quasicrystals can absorb hydrogen to a maximum H/M ratio of nearly 2.
  • The equilibrium vapor pressure remains below 5 Torr for H/M < 1 in the quasicrystal.
  • Analysis of the p-c-T data suggests one prominent site energy for hydrogen (Δμ₁ ≈ -0.187 eV) with a FWHM of 0.05 eV in the quasicrystal, and a broader secondary peak.
  • The 1/1 crystalline approximant also shows a similar primary site energy (Δμ₁ ≈ -0.187 eV) but with a narrower distribution, indicating more homogeneous site chemistry.
  • Limited hydrogen cycling experiments demonstrated that the quasicrystal maintained its integrity, with 96% of absorbed hydrogen being desorbed and re-absorbed with minimal change in the p-c-T curve.

Limitations and Future Work

  • Reproducibility at Lower Temperatures: Measurements at lower temperatures (e.g., 250°C) were not reproducible, possibly due to slow hydrogen diffusion or incomplete removal of surface oxide layers.
  • Limited Cycling: While promising, the hydrogen cycling experiments were limited. Further studies are needed to assess long-term cycling stability and performance under more realistic operating conditions.
  • Hydride Phase Formation: The transformation to a hydride phase at temperatures above 400°C needs to be managed for practical applications.
  • Future Work: The authors suggest continued study for the potential use of Ti-Zr-Ni quasicrystals in energy storage applications, implying further optimization and characterization are warranted. The findings provide valuable structural information that supports this ongoing research.

Summary updated

BibTeX
@article{kim2005hydrogen,
  author = {J.Y. Kim and Richard G. Hennig and V. T. Huett and P. C. Gibbons and K. F. Kelton},
  title = {{Hydrogen absorption in Ti–Zr–Ni quasicrystals and 1/1 approximants}},
  journal = {Journal of Alloys and Compounds},
  year = {2005},
  doi = {10.1016/j.jallcom.2005.02.089},
}
Figure