Hybrid Gripper with Passive Pneumatic Soft Joints for Grasping Deformable Thin Objects

Ngoc-Duy Tran, Hoang-Hiep Ly, Xuan-Thuan Nguyen, Thi-Thoa Mac, Anh Nguyen, Tung D. Ta

Introduction

Grasping thin, deformable objects—such as a single sheet of paper or a piece of fabric—is a persistent challenge in robotics. Traditional rigid grippers, while precise, often struggle to manipulate flat items without sliding or causing damage. Conversely, soft grippers offer high adaptability but frequently lack the structural integrity required for heavier tasks. This paper introduces a hybrid robotic gripper designed to bridge this gap by mimicking the passive adaptability of human fingers.

Design and Methodology

The proposed gripper features a two-fingered design where each finger consists of a rigid proximal link and a distal "fingertip" link. The innovation lies in the passive pneumatic soft joint connecting these links.

A soft silicone ring (Shore 25A) is wrapped around a revolute joint. This ring contains a concentric cavity that can be pressurized between 0 and 150 kPa. To prevent outward expansion (ballooning), a layer of fabric is bonded to the ring's exterior, forcing it to compress the joint inward when pressurized. This mechanism allows for precise, real-time control over joint stiffness. While the joint's compliance is pneumatic, the gripper's primary actuation is driven by a standard Nema17 stepper motor.

Experimental Evaluation

The researchers evaluated the gripper's performance through joint stiffness characterization and practical grasping trials. The primary test involved picking up a 0.5mm thick sheet of paper from a flat surface. Additionally, the gripper's versatility was tested against a diverse set of everyday objects, including PET bottles, water-filled cups, paper rolls, and electronic accessories.

Results and Discussion

The hybrid gripper demonstrated significant advantages over conventional designs. By allowing the fingertip to bend backward upon contact—mimicking the human distal interphalangeal (DIP) joint—the gripper increases its contact surface area and frictional force without complex sensors.

Comparison of human and robotic grasping of thin objects, alongside demonstrations of the gripper's versatility with various household items.

Key findings include:

  • Efficiency: The gripper required only 5mm of closing travel to achieve a 90% success rate in grasping paper, representing an 8x improvement in efficiency compared to the 40mm required by a rigid gripper.
  • Success Rate: At 110 kPa, the gripper maintained a 90% success rate for paper regardless of the approach angle.
  • Versatility: The system successfully handled various items, achieving over 80% success for toilet paper rolls and mobile chargers. It faced minor challenges with extremely smooth, sharp-edged objects like glue sticks, where success rates reached 70%.

Conclusion

This research presents a viable hybrid approach to robotic manipulation, combining the strength of rigid components with the tunable compliance of soft pneumatic joints. By replicating human-like passive adaptability, the gripper excels at picking up thin objects with minimal movement. Future work will focus on miniaturizing the pneumatic rings and implementing autonomous stiffness control using visual or tactile feedback.

Summary updated

BibTeX
@inproceedings{tran2025hybrid,
  author = {Ngoc-Duy Tran and Hoang-Hiep Ly and Xuan-Thuan Nguyen and Thi-Thoa Mac and Anh Nguyen and Tung D. Ta},
  title = {{Hybrid Gripper with Passive Pneumatic Soft Joints for Grasping Deformable Thin Objects}},
  booktitle = {IEEE International Conference on Robotics and Automation},
  year = {2025},
  doi = {10.1109/icra55743.2025.11127915},
}
Figure