High Performance Operation of a Direct-Current and Superconducting Radio-Frequency Combined Photocathode Gun

H. Jia, Tie Li, Ting Wang, Yongkun Zhao, Xinliang Zhang, Haisheng Xu, Zhuang Liu, J. Liu, Liang Lin, Huimin Xie, Liang Feng, Feng Wang, Feng Zhu, Jie Hao, Sheng Quan, K. Liu, Shoudao HuangarXiv 2024 · DOI · arXiv

Abstract

Superconducting radio-frequency (SRF) guns are promising candidates to deliver high brightness continuous-wave (CW) electron beams for new generations of coherent linac light sources, ultrafast electron diffractions, and MeV pulsed beam applications. To solve the compatibility problem of semiconductor photocathodes, a hybrid gun combining a direct-current (DC) gap and an SRF cavity has been developed. The gun, employing $K_2CsSb$ photocathodes driven by a green laser, has been brought into stable CW operation with a dark current below 100 pA, delivering electron beams at an energy gain of 2.4 MeV, an electron bunch charge of 100 pC, and a repetition rate of 1 MHz. A normalized beam emittance of 0.54 mm-mrad has been achieved at the bunch charge of 100 pC and peak current of about 6 A. CW operation at 81.25 MHz repetition rate has also been tested with the maximum average beam current reaching 3 mA.

Introduction: The Challenge of High-Brightness CW Beams

Advanced scientific facilities, such as X-ray Free-Electron Lasers (XFELs) and Energy Recovery Linacs (ERLs), require electron guns capable of continuous-wave (CW) operation at megahertz repetition rates. Traditional "normal conducting" RF guns are limited by excessive heat generation at high duty cycles. While superconducting RF (SRF) guns offer a solution, they face a significant "compatibility problem": the high-efficiency semiconductor photocathodes required for high-brightness beams can contaminate the ultra-clean cryogenic environment of the SRF cavity. Additionally, stray electrons, or dark current, can lead to cryogenic heat loads and radiation damage.

The Hybrid DC-SRF Architecture

To overcome these hurdles, researchers at Peking University developed the DC-SRF-II, a hybrid gun that integrates a 100 kV DC acceleration gap with a 1.3 GHz 1.5-cell SRF cavity.

Schematic of the DC-SRF-II gun (a) and the experimental beamline layout (b), including beam diagnostics (c-e).

In this design, the photocathode is housed within the DC gap, physically separated from the SRF cavity by a short drift tube. This separation protects the sensitive superconducting surfaces from cathode material evaporation and eliminates the need for complex RF choke filters. The system utilizes a $K_2CsSb$ (potassium-cesium-antimonide) photocathode driven by a 515 nm green laser, providing high quantum efficiency and low intrinsic emittance.

Experimental Results and Beam Quality

The DC-SRF-II gun demonstrated exceptional performance during CW operation. A key highlight is the suppression of dark current to less than 100 pA at an accelerating gradient of 22 MV/m—approximately four orders of magnitude lower than state-of-the-art normal-conducting guns like those used at LCLS-II.

The team achieved a normalized beam emittance of 0.54 mm-mrad at a bunch charge of 100 pC. This high beam quality was made possible through precise emittance compensation using two solenoid lenses and active multipole field correction.

Normalized emittance as a function of solenoid field, showing the significant improvement achieved with multipole field correction.

As shown in the figure above, the use of quadrupole and sextupole correction coils to cancel magnetic asymmetries reduced the emittance from ~0.73 mm-mrad to the record 0.54 mm-mrad, aligning the experimental results with theoretical predictions.

Stability and Future Outlook

Long-term stability tests confirmed the robustness of the hybrid design. The $K_2CsSb$ photocathode maintained a quantum efficiency of ~1% for over a month. While the system reached a maximum average current of 3 mA, stable operation at 1 mA was consistently demonstrated.

Future work will focus on addressing cyclic current fluctuations observed during long runs, likely caused by thermal effects or laser drift. Additionally, the researchers plan to characterize the longitudinal phase space of the beam, which is essential for bunch compression to reach the peak currents required for high-power XFEL applications. This successful demonstration of the DC-SRF-II gun marks a significant step toward high-performance, high-repetition-rate electron sources for the next generation of light sources.

Summary updated

Abstract

Superconducting radio-frequency (SRF) guns are promising candidates to deliver high brightness continuous-wave (CW) electron beams for new generations of coherent linac light sources, ultrafast electron diffractions, MeV pulsed beam applications, etc. To solve the compatibility problem of semiconductor photocathodes, a hybrid gun combining a direct-current gap and an SRF cavity has been developed. The gun, employing K2CsSb photocathodes driven by a green laser, has been brought into stable CW operation with a dark current below 100 pA, delivering electron beams at an energy gain of 2.4 MeV, an electron bunch charge of 100 pC, and a repetition rate of 1 MHz. A normalized beam emittance of 0.54 mm-mrad has been achieved at the bunch charge of 100 pC and peak current of about 6 A. CW operation at 81.25 MHz repetition rate has also been tested with the maximum average beam current reaching 3 mA.
BibTeX
@misc{jia2024high,
  author = {H. Jia and Tie Li and Ting Wang and Yongkun Zhao and Xinliang Zhang and Haisheng Xu and Zhuang Liu and J. Liu and Liang Lin and Huimin Xie and Liang Feng and Feng Wang and Feng Zhu and Jie Hao and Sheng Quan and K. Liu and Shoudao Huang},
  title = {{High Performance Operation of a Direct-Current and Superconducting Radio-Frequency Combined Photocathode Gun}},
  year = {2024},
  eprint = {2406.00659},
  archivePrefix = {arXiv},
  url = {https://arxiv.org/abs/2406.00659},
}
Figure