Abstract
The dicarbonyls glyoxal (Gly) and methylglyoxal (Mgly) are recognized as important precursors of secondary organic aerosols (SOAs) through atmospheric heterogeneous processes. This study conducted field measurements at a receptor site in the Pearl River Delta (PRD) region, applying an observation-based photochemical box model to investigate their production, evolution, and contribution to SOA formation. By coupling the Master Chemical Mechanism (MCM v3.2) with heterogeneous processes—including reversible partitioning and irreversible uptake—the model significantly improved its predictive accuracy. Results indicate that without these processes, models overpredict Gly and Mgly by factors of 3.3 and 3.5. Heterogeneous processes were found to contribute ~62% to the daytime destruction of these species and explain ~21% of the total SOA mass in the PRD region.
Introduction: The Missing Sink in SOA Modeling
Secondary Organic Aerosols (SOAs) are pivotal factors in climate change, atmospheric visibility, and human health. However, their formation mechanisms remain a major source of uncertainty in atmospheric science. Two small dicarbonyl molecules, glyoxal (Gly) and methylglyoxal (Mgly), are known "building blocks" for SOA.
Standard chemical models have historically struggled with these species, consistently overpredicting their concentrations in the atmosphere. This discrepancy suggests that models treating these dicarbonyls solely as gas-phase entities are missing critical interactions. This research hypothesizes that "heterogeneous sinks"—where these gases are absorbed and react on the surface or within the volume of existing particles—are the missing link.
Methods and Study Site
The study utilized high-resolution field measurements combined with advanced photochemical modeling.
Field Campaign
Measurements were conducted at the Heshan "supersite" in the Pearl River Delta (PRD), China. The team collected hourly data on 44 volatile organic compound (VOC) species, trace gases (NOx, O3, CO), and meteorological parameters during January 2017.
Modeling Framework
The researchers employed a Photochemical Box Model (PBM) coupled with the Master Chemical Mechanism (MCM v3.2). The innovation lay in the "Improved Module," which integrated:
- Reversible partitioning into aerosol aqueous phases.
- Irreversible volume reactions (e.g., ammonium-catalyzed reactions).
- Irreversible surface uptake, accounting for gas molecules sticking to aerosol surfaces.
Key Insights: Bridging the Gap
The Particle as a Sponge
The most striking result was the model's performance shift. Without accounting for heterogeneous processes, the model overpredicted Gly and Mgly by factors of 3.3 and 3.5, respectively. As shown in Figure 6, incorporating these sinks (Scenario 4) brought the simulated mixing ratios into close alignment with real-world observations. This confirms that aerosols act as a massive "sink," scrubbing these gases from the air significantly faster than photolysis or gas-phase oxidation alone.
Anthropogenic Drivers
In the polluted PRD environment, anthropogenic aromatics like toluene and xylenes are the dominant precursors for Gly and Mgly. This differs from pristine environments where biogenic isoprene typically dominates. Specifically, toluene and m,p-xylene contributed approximately 43% to Gly and 56% to Mgly formation.
Impact on SOA Formation
The study quantified the contribution of these heterogeneous pathways to total SOA mass. It was found that:
- Daytime Dominance: Heterogeneous processes accounted for ~62% of the total destruction of Gly and Mgly during the day.
- SOA Contribution: The heterogeneous uptake of these two molecules explains approximately 21% of the total SOA mass in the PRD region.
- Source Attribution: While o-xylene was a top contributor to traditional gas-particle partitioning (~29%), toluene and m,p-xylene were the primary drivers for SOA formed via heterogeneous pathways.
Conclusion and Future Directions
This research highlights that even small, simple molecules can have a disproportionately large impact on air quality when they transition from the gas to the particle phase. However, limitations remain. The study focused on winter conditions; summer's higher temperatures and different VOC profiles might shift these chemical budgets. Furthermore, the "stickiness" (uptake coefficient) of these gases remains a subject of debate, and future 3D modeling should account for complex aerosol morphology, such as organic coatings that might limit gas diffusion.
Summary updated