Abstract
We have measured the dynamics of individual magnetic fluxoids entering and leaving photolithographically patterned thin film rings of the underdoped high-temperature superconductor ${\mathrm{Bi}}_{2}{\mathrm{Sr}}_{2}{\mathrm{CaCu}}_{2}{\mathrm{O}}_{8+\ensuremath{\delta}},$ using a variable sample temperature scanning superconducting quantum interference device microscope. These results can be qualitatively described using a model in which the fluxoid number changes by thermally activated nucleation of a Pearl vortex in, and transport of the Pearl vortex across, the ring wall.
Introduction: The Problem of Magnetic Noise
In the world of superconductors, magnetic flux is not a continuous fluid; it exists in discrete, quantized packets called fluxoids. Understanding how these fluxoids move is critical for both fundamental physics and practical engineering. Fluxoid motion creates "magnetic noise," which is a major hurdle for sensitive devices like SQUIDs and qubits used in quantum computing.
While fluxoid quantization has been known for decades, the specific dynamics—how and why a fluxoid decides to jump into or out of a ring—remained poorly understood for high-temperature superconductors. This study aims to bridge this gap by studying simple rings made of underdoped BSCCO, a material where the magnetic field penetrates deeply, making the physics of individual fluxoids easier to isolate and model.
Experimental Methodology: Scanning SQUID Microscopy
The research team employed a variable temperature scanning SQUID microscope. This instrument uses a Superconducting Quantum Interference Device (SQUID) as an ultra-sensitive magnetic probe that scans over a sample to create a magnetic map. The samples consisted of rings with diameters of 40, 60, and 80 $\mu$m fabricated from 300 nm thick films of Bi₂Sr₂CaCu₂O₈₊δ (BSCCO).
As shown in Figure 1, the microscope successfully imaged rings containing anywhere from 1 to 10 fluxoids. The spatial profile of the flux signal changes with temperature, reflecting the temperature dependence of the superconducting penetration depth.
Observing the Hop: Telegraph Noise
Near the superconducting transition temperature ($T_c$), the system becomes unstable. By positioning the SQUID probe directly over a ring, the researchers observed the signal jump back and forth between two values (e.g., $N=0$ and $N=1$). This "telegraph noise" allowed them to measure the exact rate at which fluxoids were hopping.
This time-series data (Figure 6) reveals that the transitions are thermally activated. A fluxoid requires a kick of heat energy to overcome an energy barrier to enter or exit the ring. The switching frequency was found to oscillate perfectly with the applied magnetic field, peaking whenever the field is exactly halfway between two quantized states.
The Pearl Vortex Mechanism
The paper proposes that a fluxoid enters a ring by first nucleating as a Pearl vortex at the edge of the ring, then traveling across the width of the ring wall into the center hole. In thin films, these vortices have a characteristic penetration depth ($\Lambda$) that follows a $(1 - t^4)^{-1}$ temperature dependence.
The measured transition rates (ranging from 1 to 100,000 jumps per second) fit this theoretical model remarkably well. The researchers extracted the energy required to nucleate a vortex ($E_v \approx 6 \times 10^{-14}$ erg) and the attempt frequency ($\nu_0 \approx 10^8$ Hz), both of which were within a factor of two of theoretical predictions—a high degree of accuracy for such complex materials.
Conclusion and Future Outlook
This work provides a direct visualization and quantitative description of fluxoid dynamics in high-temperature superconductors. While the current model works well near $T_c$, the authors noted divergence at lower temperatures, likely due to complex interactions between moving vortices and existing supercurrents or material inhomogeneities.
Future studies could look at even smaller "mesoscopic" rings where quantum tunneling, rather than thermal hopping, might become the dominant mechanism. Such research would be a major step toward understanding and mitigating decoherence in superconducting quantum circuits.
Summary updated