Abstract
Wireless control systems (WCSs) often have to operate in dynamic environments where the network traffic load may vary unpredictably over time. The sampling in sensors is conventionally time triggered with fixed periods. In this context, only worse-than-possible quality of control (QoC) can be achieved when the network is underloaded, while overloaded conditions may significantly degrade the QoC, even causing system instability. This is particularly true when the bandwidth of the wireless network is limited and shared by multiple control loops. To address these problems, a flexible time-triggered sampling scheme is presented in this work. Smart sensors are used to facilitate dynamic adjustment of sampling periods, which enhances the flexibility and resource efficiency of the system based on time-triggered sampling. Feedback control technology is exploited for adapting sampling periods in a periodic manner. The deadline miss ratio in each control loop is maintained at/around a desired level, regardless of workload variations. Simulation results show that the proposed sampling scheme is able to deal with dynamic and unpredictable variations in network traffic load. Compared to conventional time-triggered sampling, it leads to much better QoC in WCSs operating in dynamic environments.
Introduction
In modern industrial automation, Wireless Control Systems (WCSs) offer significant advantages in terms of deployment flexibility and cost-effectiveness. However, these systems typically rely on shared, bandwidth-limited communication mediums like ZigBee. Traditional WCS designs employ fixed-rate, time-triggered (TT) sampling. This rigid approach fails to account for dynamic network conditions: underloaded networks result in wasted potential for higher precision, while overloaded networks lead to packet delays and losses that can destabilize the control loop.
System Architecture
The proposed system model consists of multiple independent control loops sharing a common wireless network. Each loop comprises a smart sensor, a controller, and an actuator managing a physical process. The presence of "disturbing nodes"—devices that generate non-control traffic—further complicates the network environment by introducing unpredictable interference and congestion.
Flexible Time-Triggered (FTT) Sampling Scheme
To overcome the limitations of fixed sampling, this research introduces a Flexible Time-Triggered (FTT) sampling scheme. The core innovation is the use of a secondary feedback loop to manage the sampling period ($h$) itself.
Key Components:
- Deadline Miss Ratio (DMR): The system monitors the ratio of control commands that fail to reach the actuator before the next sampling period begins. This metric serves as a proxy for network health, capturing both latency and packet loss.
- PID-Based Adaptation: A Proportional-Integral-Derivative (PID) controller, implemented within the smart sensor, dynamically adjusts the sampling period. If the DMR exceeds a target threshold (indicating congestion), the PID increases the sampling period to reduce traffic. Conversely, if the DMR is low, the period is decreased to improve control precision.
- Parameter Synchronization: When the sampling period is adjusted, the controller's internal parameters must be updated to maintain mathematical consistency. The current period is "piggybacked" onto data packets to ensure the controller and sensor remain synchronized.
Results and Discussion
The FTT scheme was evaluated against conventional TT sampling using Matlab/TrueTime simulations. Two primary scenarios were tested:
- Network Reconfiguration: When the number of active control loops was doubled, the fixed TT system became unstable due to massive packet collisions. The FTT system successfully adapted by increasing sampling periods, maintaining stability across all loops.
- Radio Interference: Under heavy traffic from disturbing nodes, the FTT system maintained a stable DMR (targeted at 10%), resulting in significantly smoother motor control and reduced jitter compared to the fixed-rate baseline.
Conclusion
The flexible time-triggered sampling scheme provides a robust mechanism for WCSs to operate in unpredictable environments. By treating network resource management as a control problem, the system achieves a "network-aware" state that balances control performance with resource availability. Future work will explore more advanced adaptation techniques, such as fuzzy logic, and validation on physical hardware.
Summary updated