Exploiting Pinching-Antenna Systems in Multicast Communications

Shan Shan, Chongjun Ouyang, Yong Li, Yuanwei Liu

TL;DR

This paper introduces a framework for Pinching-Antenna Systems (PASS) in multicast communications, where antennas can be mechanically moved along long dielectric waveguides to optimize signal delivery. By dynamically repositioning antennas to favor the "worst-case" user, PASS significantly outperforms conventional fixed-antenna systems (including massive MIMO) in maximizing the shared data rate across a service area.

What Problem Does This Paper Address?

In multicast communications, a single message is sent to multiple users simultaneously. The overall transmission rate is bottlenecked by the user with the worst channel conditions—the "weakest link" problem.

Traditional fixed-antenna systems are limited by their geometry; if a user is in a dead zone or far from the array, there is little the system can do beyond digital beamforming. While newer "flexible-antenna" concepts like fluid antennas or movable antennas exist, they are typically confined to very small apertures (a few wavelengths).

The authors address these limitations using PASS, a technology recently proposed by NTT DOCOMO. PASS uses long dielectric waveguides (spanning meters) where low-cost "pinching antennas" (PAs) can be attached at any point. This allows for a massive increase in spatial degrees of freedom, enabling the system to physically move antennas to locations that create the best possible Line-of-Sight (LoS) links for the most disadvantaged users.

Methods

The paper tackles the optimization of "pinching beamforming" (the physical placement of antennas) and "transmit beamforming" (the digital precoding of signals).

  1. Single-Waveguide Scenario:
    • For a single PA and linearly distributed users, the authors derive a closed-form solution for the optimal antenna location. They show this is essentially a Chebyshev center problem, where the optimal spot is the midpoint between the two boundary users.
  2. For multiple PAs, they propose an Element-wise Alternating Optimization (AO) algorithm. This method updates the position of one antenna at a time while keeping others fixed, reducing a complex multi-dimensional search into a series of simple 1D searches.
  3. Multiple-Waveguide Scenario:
    • This involves a joint optimization of digital weights and physical positions.
  4. The authors use a Majorization-Minimization (MM) framework to handle the non-convex objective function. They construct a "surrogate" function that is easier to optimize.
  5. The digital transmit beamformer is solved using Second-Order Cone Programming (SOCP), while the antenna positions are refined through element-wise sequential optimization.

Datasets

The study relies on numerical simulations rather than empirical datasets.

  • Setup: A carrier frequency of 28 GHz (mmWave) with users uniformly distributed in a rectangular service region (up to 50m x 5m).
  • Channel Model: A Line-of-Sight (LoS)-dominant model, which is characteristic of high-frequency bands where PASS is most effective.
  • Evaluation: Results are averaged over 1,000 independent random channel realizations to ensure statistical significance.

Key Insights and Ideas

  • Spatial Flexibility vs. Aperture: Unlike movable antennas that move within a tiny box, PASS antennas move along a "superhighway" (the waveguide). This allows them to mitigate large-scale path loss, not just small-scale fading.
  • The "Worst-User" Savior: In multicast, the "aha moment" is realizing that moving an antenna just a few meters can drastically improve the SNR for the furthest user without significantly hurting others, raising the "floor" of the entire system's performance.
  • Cost-Effectiveness: PASS is presented as a middle ground between simple MIMO and expensive massive MIMO. It achieves massive MIMO-like gains with far fewer RF chains by substituting expensive electronics with mechanical reconfigurability.
  • Unimodality: The authors prove that the per-user rate function in a single-PA PASS is strictly unimodal, which guarantees that their search algorithms will find the optimal location efficiently.

Key Results

  • Superiority over Fixed MIMO: PASS achieves significantly higher multicast rates than conventional fixed-location systems. In some scenarios, PASS provided a rate gain of over 200% compared to traditional MIMO.
  • Scaling with Area: The performance advantage of PASS grows quadratically with the side length of the coverage area. The larger the "room," the more useful it is to be able to move the antennas.
  • Outperforming Hybrid MIMO: Even when compared to hybrid analog-digital MIMO (which has similar hardware costs), PASS consistently wins because physical movement provides better channel reconfiguration than phase shifters alone.
  • Antenna Density: Increasing the number of PAs on a waveguide provides diminishing returns but consistently improves the multicast rate, especially when user density is high.

Limitations and Future Work

  • Mechanical Latency: The paper assumes antennas can be moved to their optimal spots. In practice, mechanical movement is much slower than digital switching. This makes the current PASS model best suited for static or slow-moving users (e.g., fixed wireless access or indoor hotspots).
  • Channel State Information (CSI): The study assumes perfect CSI is available. However, moving an antenna constantly changes the channel, making channel estimation a significant overhead challenge.
  • Hardware Realization: While NTT DOCOMO has prototyped the waveguide, the "pinching" mechanism's precision and the power loss associated with long waveguides are practical hurdles not fully explored here.
  • Future Direction: The authors suggest exploring PASS in Integrated Sensing and Communication (ISAC) and interference management (NOMA) scenarios.

Summary updated

Abstract

The pinching-antenna system (PASS) reconfigures wireless links through pinching beamforming, in which the activated locations of pinching antennas (PAs) along dielectric waveguides are optimized. This article investigates the application of PASS in multicast communication systems, where pinching beamforming is designed to maximize the multicast rate. i) In the single-waveguide scenario, a closed-form solution for the optimal activated location is derived under the assumption of a single PA and linearly distributed users. Based on this, a closed-form expression for the achievable multicast rate is obtained and proven to be larger than that of conventional fixed-location antenna systems. For the general multiple-PA case with arbitrary user distributions, an element-wise alternating optimization (AO) algorithm is proposed to design the pinching beamformer. ii) In the multiple-waveguide scenario, an AO-based method is developed to jointly optimize the transmit and pinching beamformers. Specifically, the transmit beamformer is updated using a majorization-minimization (MM) framework together with second-order cone programming (SOCP), while the pinching beamformer is optimized via element-wise sequential refinement. Numerical results are provided to demonstrate that: i) PASS achieves significantly higher multicast rates than conventional fixed-location antenna systems, particularly when the number of users and spatial coverage increase; ii) increasing the number of PAs further improves the multicast performance of PASS.
BibTeX
@article{shan2025exploiting,
  author = {Shan Shan and Chongjun Ouyang and Yong Li and Yuanwei Liu},
  title = {{Exploiting Pinching-Antenna Systems in Multicast Communications}},
  journal = {IEEE Transactions on Communications},
  year = {2025},
  doi = {10.1109/tcomm.2025.3626012},
}

Loading related content...

Figure