Experimental analysis and research on the effect of long-term vibration on the performance of vehicle carbon canisters

Xiaohong Yu, Liu Yiyao, Tao Chen, Hua ZhaoE3S 2024 · DOI

TL;DR

Long-term vehicle vibration causes carbon canisters to shed internal powder, which clogs air pathways and increases flow resistance. While this aging reduces the canister's total storage capacity, it surprisingly lowers evaporative emissions during short-term parking by making it harder for fuel vapors to "leak" out—a finding that suggests engine control units (ECUs) need smarter, adaptive strategies to manage canisters as they age.

What Problem Does This Paper Address?

Vehicle carbon canisters are the unsung heroes of emissions control, tasked with capturing volatile organic compounds (VOCs) that evaporate from the fuel tank. As environmental regulations like Euro 7 and China 6 become increasingly stringent, the durability of these components over a vehicle's lifetime (often 160,000 km or more) is under the microscope.

The challenge is that canisters live in a harsh environment. Constant vibration from the road and engine can physically degrade the activated carbon pellets inside. While we know canisters "age," there is little public research on how specific vibration patterns affect their internal structure and, consequently, their ability to adsorb and desorb fuel vapors. The authors aim to bridge this gap by simulating 144,000 km of road vibration to see exactly how a canister’s performance shifts over time.

Methods

The researchers developed a sophisticated vibration test bench to simulate real-world driving conditions. Key aspects of their approach include:

  • Multi-Axis Simulation: They tested vibration in three directions (XYZ), identifying that the forward/backward (X-axis) motion of the vehicle is the most damaging to the canister's internal structure.
  • Accelerated Aging: To simulate 144,000 km of driving without waiting years, they used a 60-hour high-frequency sweep (5-60 Hz). By increasing the frequency while maintaining amplitude, they achieved a 30x acceleration factor compared to actual driving.
  • Powder Capture: They installed 10 μm and 250 μm filters to catch and weigh the "carbon powder precipitation"—the tiny fragments of carbon that break off during vibration.
  • Performance Benchmarking: They measured flow resistance (pressure drop), butane loading capacity, and conducted 48-hour Diurnal Breathing Loss (DBL) tests both before and after the vibration aging.

Datasets

As an experimental study, the "dataset" consists of primary data collected from three different types of experimental carbon canisters (labeled A, B, and C). These canisters shared the same main carbon component but featured different proportions of structural additives (5, 10, and 15 parts, respectively) to test how different formulations handle mechanical stress.

Key Insights and Ideas

  • The "Clogging" Effect: Vibration doesn't just break the carbon; it redistributes the resulting dust. This dust settles into the voids between larger pellets, significantly increasing flow resistance.
  • Directional Sensitivity: The study found that longitudinal vibration (X-axis) caused the most significant powder loss (up to 71 mg in one sample), likely due to the specific orientation of the carbon beds relative to vehicle acceleration and braking.
  • The DBL Paradox: Perhaps the most surprising insight is that "aged" canisters performed better in 48-hour DBL tests. Because the internal pathways were partially clogged with powder, it became physically harder for adsorbed fuel vapor to diffuse out of the canister into the atmosphere.
  • Capacity vs. Resistance Trade-off: While aging makes the canister more "leak-proof" during parking, it also reduces its total adsorption capacity and makes it harder for the engine to "purge" (clean) the canister during driving.

Key Results

  • Physical Degradation: Canister B showed the highest sensitivity, losing 71 mg of powder after the first 20 hours of vibration.
  • Flow Resistance: Aging increased flow resistance across all samples. For example, at a flow rate of 90 L/min, the pressure drop increased by roughly 10-20% depending on the canister type.
  • Capacity Loss: The ultimate adsorption capacity for fuel vapor decreased after aging. The number of cycles required to reach a stable state dropped from ~30 cycles to ~20 cycles, indicating a loss of active surface area.
  • Emission Reduction (Short-term): In the 48-hour DBL test, the aged canisters showed lower mg-level emissions than the new ones. However, the authors warn that if the canister were to reach full saturation, the aged version would fail much sooner and more catastrophically than a new one.

Limitations and Future Work

The authors acknowledge a critical caveat: their DBL results apply to unsaturated canisters. In a real-world scenario where a vehicle is parked for a very long time or the purge system is inefficient, the reduced capacity of an aged canister would eventually lead to "breakthrough" (saturation), causing a spike in emissions.

Future research is suggested to investigate how this shed carbon powder affects the engine itself, as the dust could potentially be sucked into the intake manifold, affecting combustion or damaging sensitive valves. Additionally, the authors recommend that automotive engineers develop adaptive ECU purge strategies that can detect increased flow resistance and adjust the cleaning cycle as the canister ages.

Summary updated

Abstract

The long-term vibration of the carbon canister during vehicle operation can lead to changes in its performance, thereby affecting its performance on evaporation emissions. A vibration test bench simulating vehicle vibration characteristics is used to simulate the working state of the carbon canister under actual driving conditions, analyze the amount of carbon powder precipitation and flow resistance changes in the canister after long-term operation, and compare the adsorption and desorption performance of the canister before and after aging and their effect on the evaporative emissions. The results showed that the carbon canister will produce carbon powder precipitation after being continuously subjected to the forward and backward vibration of the vehicle. This leads to a decrease in the ultimate adsorption and desorption capacity of the aged carbon canister for fuel vapor, with a more significant decrease in adsorption capacity. However, in the 2-day Diurnal Breathing Loss(DBL) test, due to the increase in flow resistance of the aged carbon canister, it is more difficult for the adsorbed fuel vapor to diffuse outward. For the unsaturated carbon canister, fuel leakage and evaporative emissions can be reduced. In evaporative emission management, it is necessary to adjust the control strategy reasonably based on the working status of the carbon canister.
BibTeX
@inproceedings{yu2024experimental,
  author = {Xiaohong Yu and Liu Yiyao and Tao Chen and Hua Zhao},
  title = {{Experimental analysis and research on the effect of long-term vibration on the performance of vehicle carbon canisters}},
  booktitle = {E3S},
  year = {2024},
  doi = {10.1051/e3sconf/202452201007},
}
Figure