Energy Buffer-Aided Wireless-Powered Relaying System for Self-Sustainable Implant WBAN

Ting Ning, Can Lin, Guofa Cai, Kengyuan Xie, Jiguang He, Chongwen Huang, Mérouane DebbahIEEE Open J. Commun. Soc 2024 · DOI

Introduction

Wireless Body Area Networks (WBANs) are a cornerstone of modern personalized healthcare, enabling continuous monitoring via implantable sensors. However, these devices face two critical challenges: energy scarcity and signal attenuation. Implant batteries are inherently small and difficult to replace without invasive surgery. Furthermore, the human body acts as a "lossy" medium, significantly weakening signals sent from deep-tissue implants to external access points (APs).

While Wireless Power Transfer (WPT) offers a solution for recharging, traditional "harvest-then-transmit" protocols are highly sensitive to wireless channel fluctuations. This paper proposes a self-sustainable communication architecture that utilizes a dual-mode wearable relay equipped with an energy buffer to mitigate these issues and ensure reliable data transmission.

System Architecture and Transmission Protocol

The proposed system consists of an off-body Access Point (D), a wearable relay device (R), and an implantable sensor (S). The communication process is structured into a three-phase transmission cycle:

  1. Phase I (Downlink): The AP broadcasts radio-frequency (RF) signals. The wearable relay harvests this energy, storing it in a Secondary Energy Buffer (SEB), while simultaneously transferring power wirelessly to the implant.
  2. Phase II (Uplink 1): The implant uses its harvested energy to transmit data to the wearable relay.
  3. Phase III (Uplink 2): The wearable relay utilizes its stored energy (from the SEB) to decode and forward the data to the AP.
Figure 1: System model of the proposed energy buffer-aided wireless-powered relaying system, illustrating energy and information flows.

The core innovation is the management of the wearable's energy buffer. The authors evaluate two primary transmission policies:

  • Best-Effort Policy (BEP): The relay transmits whenever any energy is available, dynamically adjusting power levels.
  • On-Off Policy (OOP): The relay only initiates transmission once the energy buffer reaches a predefined threshold, ensuring sufficient power for high-quality links.

Analytical Framework and Insights

To evaluate performance, the authors developed a mathematical framework using continuous state space Markov chains to model the energy buffer's behavior. This allowed for the derivation of exact outage probabilities and throughput metrics. The study utilized Monte Carlo simulations with realistic WBAN parameters, including Nakagami-$m$ fading for off-body links and log-normal fading for in-body paths.

The Buffer as a "Shock Absorber"

A key insight is that the energy buffer decouples the energy harvesting process from data transmission. By storing energy, the system can survive "deep fades"—temporary drops in signal strength—by relying on the buffer's reserves. This significantly reduces data transmission outages compared to traditional buffer-less systems (BLP).

Policy Performance and Safety

Both BEP and OOP demonstrate clear superiority over buffer-less benchmarks. BEP is particularly effective when harvesting rates are low, as it avoids the "dead time" required to reach high thresholds in OOP. However, OOP can be optimized by finding a "Goldilocks" threshold that balances transmission power and frequency. Crucially, the energy levels required for these operations remain well within Specific Absorption Rate (SAR) safety limits for human tissue.

Conclusion

The introduction of an energy buffer in wearable relays provides a robust pathway toward self-sustainable WBANs. By smoothing out the volatility of harvested RF energy, the system achieves higher throughput and lower outage rates. Future research will look to address the non-linear nature of RF-to-DC conversion and extend the model to multi-user scenarios with mobile subjects.

Summary updated

BibTeX
@article{ning2024energy,
  author = {Ting Ning and Can Lin and Guofa Cai and Kengyuan Xie and Jiguang He and Chongwen Huang and Mérouane Debbah},
  title = {{Energy Buffer-Aided Wireless-Powered Relaying System for Self-Sustainable Implant WBAN}},
  journal = {IEEE Open J. Commun. Soc.},
  year = {2024},
  doi = {10.1109/ojcoms.2024.3385369},
}
Figure