Density Functional Theory Study of Redox Potential Shifts in LiₓMnyFe₁–yPO₄ Battery Electrodes

Simon Loftager, Steen B. Schougaard, Tejs Vegge, J. M. García‐Lastra

Abstract

Olivine-structured LiMPO₄ materials (M = Mn, Fe, Co, Ni, or mixtures) exhibit higher redox potentials than their layer oxide counterparts. This is due to the so-called inductive effect in the former, where the inner P–O bonds in the phosphate units make the M–O bond weaker than in the latter. A strategy to further increase the redox potentials in the olivines is to mix two metals. Along these lines, Kobayashi et al. have shown experimentally that Mn²⁺–Mn³⁺ and Fe²⁺–Fe³⁺ redox potentials approximately shift 0.1 V upon full substitution of Fe by Mn in LiₓMnyFe₁–yPO₄. Here, through density functional theory calculations, we found that the average metal–oxygen bond lengths (M = Mn, Fe) increase with increasing Mn content, resulting in a decrease in the covalency of the transition-metal–oxygen interaction. The decrease in the covalency can be linked with good qualitative agreement to the experimentally observed M²⁺–M³⁺ voltage-plateau positive shift. Finally, the impact of the Mn-content-dependent voltage plateaus and unit-cell volume on the energy densities of the active compound is discussed.
BibTeX
@article{loftager2018density,
  author = {Simon Loftager and Steen B. Schougaard and Tejs Vegge and J. M. García‐Lastra},
  title = {{Density Functional Theory Study of Redox Potential Shifts in LiₓMnyFe₁–yPO₄ Battery Electrodes}},
  journal = {The Journal of Physical Chemistry C},
  year = {2018},
  doi = {10.1021/acs.jpcc.8b09167},
}

Loading related content...

Figure