Delay Optimization in Remote ID-Based UAV Communication via BLE and Wi-Fi Switching

Yian Zhu, Ziye Jia, Lei Zhang, Yao Wu, Qiuming Zhu, Qihui Wu

Abstract

The remote identification (Remote ID) broadcast capability allows unmanned aerial vehicles (UAVs) to exchange messages, which is a pivotal technology for inter-UAV communications. Although this capability enhances the operational visibility, low delay in Remote ID-based communications is critical for ensuring the efficiency and timeliness of multi-UAV operations in dynamic environments. To address this challenge, we first establish delay models for Remote ID communications by considering packet reception and collisions across both BLE 4 and Wi-Fi protocols. Building upon these models, we formulate an optimization problem to minimize the long-term communication delay through adaptive protocol selection. Since the delay performance varies with the UAV density, we propose an adaptive BLE/Wi-Fi switching algorithm based on the multi-agent deep Q-network approach. Experimental results demonstrate that in dynamic-density scenarios, our strategy achieves 32.1% and 37.7% lower latency compared to static BLE 4 and Wi-Fi modes respectively.

Introduction

As the density of Unmanned Aerial Vehicles (UAVs) in shared airspace increases, the mandatory Remote Identification (Remote ID or RID) broadcast system faces significant performance challenges, particularly regarding communication latency. Remote ID serves as a "digital license plate," enabling decentralized airspace awareness where drones can detect each other to avoid collisions without centralized infrastructure.

Remote ID-based UAV communication network utilizing BLE and Wi-Fi protocols.

Regulatory bodies like the FAA have designated Bluetooth Low Energy (BLE) and Wi-Fi as the primary broadcast technologies. However, both operate in the congested 2.4 GHz ISM band. In high-density scenarios, frequent packet collisions lead to high latency, which can be detrimental in safety-critical missions. Neither protocol is universally superior: BLE is energy-efficient but prone to congestion, while Wi-Fi handles higher densities better but introduces different timing overheads.

Methodology

To optimize communication delay, this research employs a two-pronged approach:

  1. Mathematical Modeling: The authors utilize the Chinese Remainder Theorem (CRT) to model the alignment of transmitter and receiver on the same frequency channel. Given that both BLE and Wi-Fi involve periodic scanning and broadcasting across multiple channels, CRT helps calculate the probability and timing of successful packet reception. This is combined with a collision model to estimate average delay.
  2. MADQN-BWSA Algorithm: A Multi-Agent Deep Q-Network (MADQN) based switching algorithm was developed to allow UAVs to autonomously select the optimal protocol. Each UAV acts as an independent agent observing its own state (protocol, transmission rate) and the local environment (neighboring drones' distances and protocols). The reward function balances individual delay minimization with global swarm performance to prevent interference-heavy "selfish" choices.

Experimental Setup

The proposed strategy was evaluated using high-fidelity simulations in a 3D airspace containing 10 UAVs flying at altitudes between 30m and 120m. The horizontal airspace size was varied from 100m² (high density) to 10,000m² (low density) to test the algorithm's adaptability. The simulation environment was implemented in Python 3.9 using TensorFlow 2.10.

Results and Discussion

A key finding of this study is the existence of a "crossover point" in protocol performance relative to UAV density. As shown in the figure below, Wi-Fi consistently achieves lower latency in high-density environments (airspace sizes under 1,000m²). Conversely, in low-density environments (over 1,500m²), BLE 4 becomes the more efficient choice.

Comparison of average delay between BLE 4 and Wi-Fi across different airspace sizes.

The MADQN-BWSA strategy effectively navigates this trade-off. In dynamic-density scenarios, the switching strategy achieved 32.1% lower latency than static BLE 4 and 37.7% lower latency than static Wi-Fi. Furthermore, the algorithm demonstrated superior stability and faster convergence compared to other reinforcement learning baselines like MADDPG.

Conclusion and Future Work

This research demonstrates that adaptive protocol switching can significantly enhance the reliability of Remote ID systems. Future work will explore the integration of BLE 5, which offers improved range and throughput. Additionally, incorporating hardware switching overhead and energy consumption into the optimization model will provide a more comprehensive solution for real-world UAV deployments. Scaling the approach to "massive" density scenarios involving hundreds of drones remains a key area for further investigation.

Summary updated

Abstract

The remote identification (Remote ID) broadcast capability allows unmanned aerial vehicles (UAVs) to exchange messages, which is a pivotal technology for inter-UAV communications. Although this capability enhances the operational visibility, low delay in Remote ID-based communications is critical for ensuring the efficiency and timeliness of multi-UAV operations in dynamic environments. To address this challenge, we first establish delay models for Remote ID communications by considering packet reception and collisions across both BLE 4 and Wi-Fi protocols. Building upon these models, we formulate an optimization problem to minimize the long-term communication delay through adaptive protocol selection. Since the delay performance varies with the UAV density, we propose an adaptive BLE/Wi-Fi switching algorithm based on the multi-agent deep Q-network approach. Experimental results demonstrate that in dynamic-density scenarios, our strategy achieves 32.1% and 37.7% lower latency compared to static BLE 4 and Wi-Fi modes respectively.
BibTeX
@misc{zhu2025delay,
  author = {Yian Zhu and Ziye Jia and Lei Zhang and Yao Wu and Qiuming Zhu and Qihui Wu},
  title = {{Delay Optimization in Remote ID-Based UAV Communication via BLE and Wi-Fi Switching}},
  year = {2025},
  eprint = {2506.07715},
  archivePrefix = {arXiv},
  url = {https://arxiv.org/abs/2506.07715},
}
Figure