Abstract
A TiN/Al2O3 protective film layer was alternately deposited on the surface of sintered Neodymium Iron Boron (NdFeB) permanent magnet by magnetron sputtering technology, and the effect of different cycles on the surface morphology and microstructure of the protective film was studied. At the same time, the protective performance of protective film was explored for the NdFeB permanent magnet in NaCl solution. The results show that the increase in the number of film layers contributes to the continuous improvement of the quality of each film layer, the nucleation rate of the top film increases, the grains are refined, the surface density of the film layer continues to increase, and the stress of defects in the film layer is also easier to be released across the interface. The process of alternately depositing the film layer effectively prevents the appearance of through holes in the film layer, and has a good protection effect on the NdFeB permanent magnet substrate.
Introduction
Neodymium Iron Boron (NdFeB) magnets are critical components in modern technology, essential for electric vehicle motors and aerospace sensors. However, they are highly susceptible to corrosion due to their complex multi-phase microstructure, which facilitates local galvanic cells. While physical vapor deposition (PVD) of materials like Titanium Nitride (TiN) is a common solution, single-layer films often contain microscopic "pinholes" or through-holes that allow corrosive agents to bypass the shield. This study investigates a multilayer "sandwich" approach using alternating TiN and Al2O3 layers to block these pathways and enhance the magnet's environmental stability.
Methodology
Researchers employed magnetron sputtering to deposit alternating nanometer-scale layers of TiN and Al2O3 onto commercial 45H NdFeB magnets. The experimental design varied the number of bilayer cycles ($n$) from 2 to 20. Substrates were polished to a mirror finish and ultrasonically cleaned to ensure maximum adhesion. The resulting films were characterized using Field Emission Scanning Electron Microscopy (FESEM) for surface morphology and X-ray Diffraction (XRD) for crystal structure analysis. Corrosion resistance was evaluated via potentiodynamic polarization in a 3.5% NaCl solution, simulating a harsh marine environment.
Results and Discussion
The "Reset" Effect and Grain Refinement
A key insight from the study is the "reset" effect of multilayering. In a single thick layer, defects can grow continuously from the substrate to the surface. In a multilayer system, the interface between TiN and Al2O3 interrupts this growth, effectively "plugging" holes from the previous layer. XRD data revealed that as the number of cycles increased to 20, the TiN grain size refined from 38.8 nm to 29.8 nm, resulting in a significantly denser and more compact film. Furthermore, the interfaces in this structure allow internal stress to be released across boundaries, leading to a smoother surface.
Electrochemical Performance
The 20-cycle TiN-topped film demonstrated superior protective performance, achieving a protective efficiency of 91.9%. The self-corrosion current density—a measure of the material's degradation rate—was reduced by an order of magnitude compared to the bare magnet (from $2.17 \times 10^{-4}$ A/cm² to $1.76 \times 10^{-5}$ A/cm²). Additionally, the corrosion potential shifted positively by 50.92 mV, indicating enhanced resistance to the onset of corrosion. Crucially, the PVD process did not degrade the magnetic properties of the NdFeB substrate.
Conclusion
The alternating deposition of TiN and Al2O3 layers effectively mitigates the formation of through-holes in protective coatings for NdFeB magnets. The multilayer structure improves corrosion resistance through grain refinement, increased surface density, and better stress management. While the electrochemical benefits are clear, future research should address the mechanical durability and long-term environmental stability of these coatings in industrial applications.
Summary updated