Cooperative Reflection Design with Timing Offsets in Distributed Multi-RIS Communications

Yaqiong Zhao, Wei Xu, Huan Sun, Derrick Wing Kwan Ng, Xiaohu YouarXiv 2021 · arXiv

TL;DR

Distributed Reconfigurable Intelligent Surfaces (RISs) boost wireless coverage but suffer from timing synchronization errors that degrade performance. This paper introduces a computationally efficient joint optimization algorithm based on the Majorization-Minimization (MM) framework to mitigate these timing offsets, significantly reducing data recovery errors compared to conventional synchronization-blind designs.

What Problem Does This Paper Address?

Reconfigurable Intelligent Surfaces (RISs) use large arrays of low-cost, passive elements to control wireless propagation environments by shifting the phase of incoming signals. Deploying multiple distributed RISs has been shown to outperform a single centralized RIS of the same size.

However, prior research heavily relies on an unrealistic assumption: perfect timing synchronization among all distributed nodes. In practice, because passive RISs lack active RF chains, they cannot estimate or compensate for individual propagation delays across different signal paths. This hardware limitation leads to timing offsets at the receiver, causing severe inter-symbol interference (ISI) and destroying the beamforming gains that RISs are supposed to provide.

This paper addresses the challenge of cooperative reflection design in a multi-RIS downlink system while explicitly accounting for these practical timing synchronization errors.

System model for a multi-RIS-aided system with $K=2$ RISs, where the direct path is blocked.

Methods

The authors formulate an optimization problem to minimize the Mean-Squared Error (MSE) of the recovered data at the destination. The optimization variables are the RIS phase shift matrices ($\mathbf{\Theta}$) and the destination's timing offset equalizer ($\mathbf{G}$). This problem is highly non-convex due to two main factors:

  1. The objective function contains complex fourth-order polynomials.
  2. The passive RIS elements are bound by strict unit-modulus constraints ($|\theta_i| = 1$).

To solve this tractably, the authors propose an alternating optimization algorithm using the Majorization-Minimization (MM) framework. Instead of optimizing the difficult objective directly, the MM approach iteratively optimizes a simpler surrogate function (a lower bound) that mirrors the local behavior of the original problem.

Through clever matrix manipulation and Taylor expansions, the authors derive:

  • A closed-form solution for the destination equalizer ($\mathbf{G}$).
  • A semi-closed-form solution for the RIS phase shifts ($\mathbf{\Theta}$) at each iteration.

This keeps the per-iteration computational complexity low, scaling at $\mathcal{O}((NKL)^3)$, where $N$ is the number of RIS elements, $K$ is the number of RISs, and $L$ is the sequence length.

Datasets

Not discussed in the paper. The authors evaluate their approach exclusively using standard statistical and geometric millimeter-wave channel simulations rather than empirical datasets.

Key Insights and Ideas

  • Destination-Side Compensation is Essential: Because passive RISs cannot process signals to correct timing locally, synchronization errors must be mitigated cooperatively via a smart combination of RIS phase adjustments and destination-side equalization.
  • Taming Fourth-Order Polynomials: The paper demonstrates that complex, non-convex fourth-order polynomial problems can be successfully linearized and bounded using majorization lemmas, making them solvable via closed-form expressions.
  • The Scalability Penalty: As the number of distributed RIS nodes ($K$) grows, the flexibility of the network increases, but so does the impact of timing misalignment. Consequently, the performance gap between synchronization-aware design and naive baselines widens significantly as the network scales.

Key Results

  • Convergence: The proposed algorithm is mathematically proven to be monotonically non-decreasing and guaranteed to converge to a local optimum.
  • Orders-of-Magnitude Improvement: Simulation results show that the proposed design outperforms naive baselines (which assume perfect synchronization) by orders of magnitude in terms of MSE under continuous phase shifts.
  • Robustness to Quantization: In practical deployments, RIS phase shifts are often discrete rather than continuous. The authors tested their algorithm under heavy quantization (e.g., using only $B = 2$ bits) and found that it incurs very limited performance degradation, proving its real-world viability.

Limitations and Future Work

  • Perfect Channel State Information (CSI) Assumption: The algorithm assumes that the equivalent channel gains and timing offsets are already perfectly known via prior estimation. In reality, estimation errors would introduce additional performance degradation.
  • Single-Antenna Constraints: The system model is restricted to a single-antenna source and destination. Extending this framework to multi-antenna (MIMO) setups remains an open and challenging direction for future research.

Summary updated

Abstract

This letter investigates a wireless communication system deploying distributed reconfigurable intelligent surfaces (RISs). Existing works have assumed that perfect timing synchronization is available among all the cooperative RISs. For practical considerations, we first study cooperative reflection design for multi-RIS-aided communication systems taking into account timing synchronization errors. We aim to minimize the mean-squared error of the recovered data in the presence of timing offsets subject to the unit modulus constraints imposed on the phase shifts of the RISs. In order to handle this sophisticated nonconvex problem, we develop a computationally-efficient algorithm based on the majorization-minimization framework where the RIS phase shift matrices and the timing offset equalizer are respectively developed in a semi-closed form and a closed form. Numerical examples validate the improved performance of our proposed design compared with various schemes.
BibTeX
@misc{zhao2021cooperative,
  author = {Yaqiong Zhao and Wei Xu and Huan Sun and Derrick Wing Kwan Ng and Xiaohu You},
  title = {{Cooperative Reflection Design with Timing Offsets in Distributed Multi-RIS Communications}},
  year = {2021},
  eprint = {2107.12717},
  archivePrefix = {arXiv},
  url = {https://arxiv.org/abs/2107.12717},
}
Figure