Abstract
The intrinsic magnetic order and large topological-magnetic gap of $MnBi_2Te_4$ provide a unique platform for exploring exotic quantum states, including the axion insulator and Chern insulator phases. Realizing and manipulating these phases requires precise control over the electric field across the thin film, typically achieved through a dual-gate architecture. In this work, we demonstrate dual-gate tuning of $MnBi_2Te_4$ thin films grown via molecular beam epitaxy (MBE) on $SrTiO_3(111)$ substrates. By utilizing the substrate as a bottom-gate dielectric and an $AlO_x$ layer for the top gate, we achieved independent control of carrier density and displacement fields. At 20 mK and under a 9T magnetic field, the films exhibited an inverse gate-voltage dependence of Hall and longitudinal resistivities, signaling the presence of a Chern insulator phase. While the Hall resistivity reached $0.8 h/e^2$, full quantization was likely hindered by bulk carriers from secondary phases. This study establishes a foundation for electrically tunable topological quantum devices.
Introduction
$MnBi_2Te_4$ has emerged as a "rising star" in condensed matter physics, representing the first known intrinsic magnetic topological insulator. Unlike previous systems that required extrinsic magnetic doping to induce the Quantum Anomalous Hall Effect (QAHE), $MnBi_2Te_4$ possesses stoichiometric magnetic order, potentially allowing for more robust topological states.
To fully harness the potential of this material for dissipationless quantum electronics, researchers must be able to manipulate its topological phases using external electric fields. This necessitates a dual-gate device structure to independently tune the chemical potential and the vertical displacement field. Historically, $MnBi_2Te_4$ has been grown on sapphire substrates; however, sapphire’s insulating nature precludes its use as a bottom-gate dielectric. $SrTiO_3$ (STO) offers a compelling alternative due to its massive dielectric constant at cryogenic temperatures, but maintaining high film quality on STO has remained a significant challenge.
Experimental Methods
To address these challenges, high-quality $MnBi_2Te_4$ thin films were grown on $SrTiO_3(111)$ substrates using Molecular Beam Epitaxy (MBE). The crystalline integrity of the films was monitored in-situ via Reflection High-Energy Electron Diffraction (RHEED) and ex-situ through Atomic Force Microscopy (AFM) and X-ray Diffraction (XRD). Angle-Resolved Photoemission Spectroscopy (ARPES) was employed to verify the electronic band structure.
The dual-gate devices were fabricated by using the STO substrate itself as the bottom-gate dielectric, while a 40-nm-thick $AlO_x$ layer, deposited via atomic layer deposition, served as the top-gate dielectric. Magneto-transport measurements were conducted in a dilution refrigerator at a base temperature of 20 mK, with magnetic fields reaching up to 9 Tesla.
Results and Discussion
The Chern Insulator Phase
The primary evidence for the Chern insulator phase lies in the gate-dependent transport data. Under a high magnetic field (9T), where the $MnBi_2Te_4$ layers are forced into a ferromagnetic alignment, the researchers observed a characteristic "inverse" dependence: as the gate voltage tuned the system toward the topological gap, the Hall resistivity ($\rho_{yx}$) increased while the longitudinal resistivity ($\rho_{xx}$) decreased. This behavior is a hallmark of a Chern insulator, where the transport is dominated by dissipationless chiral edge states.
Dual-Gate Tuning and Phase Transitions
The dual-gate configuration allowed for the mapping of the material's phase space as a function of both top-gate ($V_{tg}$) and bottom-gate ($V_{bg}$) voltages. The results demonstrated that the electric field effectively penetrates the entire thin film, enabling the independent adjustment of the total carrier density ($n$) and the vertical displacement field ($D$).
At a critical magnetic field of $\mu_0H_{cr} = 6.17 T$, the system undergoes a quantum phase transition from a dissipative state to the topological Chern insulator state. Near this transition, the scaling behavior of the resistivity followed a power law with an exponent $\kappa \approx 0.3$, consistent with observations in other magnetic topological insulator systems, though the specific value suggests the presence of some degree of disorder.
Challenges in Quantization
Despite the clear signature of the Chern insulator phase, the maximum Hall resistivity observed was $0.8 h/e^2$, falling short of the ideal quantized value of $1.0 h/e^2$. Structural analysis via Scanning Transmission Electron Microscopy (STEM) and Scanning Tunneling Spectroscopy (STS) revealed the presence of "secondary phases"—specifically $Bi_2Te_3$ quintuple layers interspersed within the $MnBi_2Te_4$ septuple layers. These secondary phases introduce a high density of bulk carriers that provide a parallel conduction path, effectively "shorting out" the perfectly quantized edge transport.
Conclusion
This work successfully demonstrates the realization of a Chern insulator phase in MBE-grown $MnBi_2Te_4$ thin films using a dual-gate STO-based architecture. While the presence of secondary phases currently limits perfect quantization, the ability to independently tune the top and bottom gates marks a significant milestone. Future efforts focusing on optimizing the STO surface preparation to eliminate structural defects will be critical for reaching the full quantization required for axion insulator physics and the development of next-generation topological transistors.
Summary updated