Abstract
Autonomous soaring capability has the potential to significantly increase time aloft for fixed-wing UAVs. In this paper, we introduce ArduSoar, the first soaring controller integrated into a major autopilot software suite for small UAVs. We describe ArduSoar from the algorithmic standpoint, outline its integration with the ArduPlane autopilot, discuss parameter tuning for it, and conduct a series of flight tests on real sUAVs that show ArduSoar's robustness even in highly non-ideal atmospheric conditions.
Introduction
Fixed-wing small Unmanned Aerial Vehicles (sUAVs) are strictly limited by their battery life or fuel capacity. While birds and glider pilots have long used thermals—rising columns of warm air—to stay aloft for hours without flapping or engines, bringing this capability to autonomous drones is difficult. The challenges are twofold: sensing invisible, chaotic air movements and operating within the strict hardware constraints of low-power flight controllers like the Pixhawk. ArduSoar addresses these by providing a computationally efficient, integrated solution for autonomous thermal detection and exploitation.
Methods
ArduSoar is integrated into the ArduPlane firmware and operates in a four-stage cycle: detection, identification, exploitation, and exit.
The system uses a Netto Variometer approach to isolate the vertical movement of air by subtracting the aircraft's natural sink rate (the polar curve) from its total specific energy. To identify the thermal's center, a simplified 4-variable Extended Kalman Filter (EKF) runs at 5Hz, estimating thermal strength, radius, and position relative to the aircraft. This EKF accounts for wind drift, ensuring the drone stays within the rising air mass.
A key design choice was the "Fixed Radius Strategy." While dynamic radius optimization is theoretically better, the authors found that using a fixed, small loiter radius (e.g., 15m) provided much greater robustness on resource-constrained hardware where EKF estimates can become noisy.
Results
The system was validated through high-fidelity simulations and extensive real-world flight tests in the US Pacific Northwest. Using a Parkzone Radian Pro sailplane, the team successfully exploited thermals in 21 separate flights.
The flight data demonstrates the drone's ability to "pounce" on lift encountered during a standard mission. The aircraft successfully enters a helical climb, gaining significant altitude without motor power. The controller proved versatile enough to exploit orographic lift (updrafts from terrain) despite being modeled for thermal columns. In one instance, the drone maintained flight for over 30 minutes with the motor off for the majority of the duration.
Conclusion and Future Work
ArduSoar demonstrates that a reactive, model-based controller can effectively extend sUAV endurance using standard, low-cost hardware. Current limitations include a lack of active exploration—the drone only exploits thermals it happens to fly through—and the requirement for manual tuning of the airframe's polar curve. Future research will focus on deliberate exploration strategies and automating the calibration process to make autonomous soaring more accessible to a wider range of platforms.
Reference: Tabor, S., Guilliard, I., & Kolobov, A. (2018). ArduSoar: an Open-Source Thermalling Controller for Resource-Constrained Autopilots. arXiv:1802.08215v2 [cs.RO].
Summary updated