A Cross-Layer Scheme for Handover in 802.16e Network with F-HMIPv6 Mobility

Yi Zheng, Yong Zhang, Yinglei Teng, Mei Song

Introduction

In mobile networking, a "handover" occurs when a mobile station (MS) moves from the coverage area of one base station (BS) to another. For time-sensitive applications like VoIP or streaming, this transition must be nearly instantaneous to avoid service disruption.

The challenge in 802.16e (Mobile WiMAX) networks is that handovers occur at two distinct levels: the Link Layer (Layer 2/L2), which handles the physical connection to the base station, and the Network Layer (Layer 3/L3), which handles IP address registration and routing. Traditionally, these layers operate sequentially—L3 doesn't start its work until L2 is finished. This "stop-and-wait" approach creates a cumulative delay that can cause dropped packets or noticeable lag.

Network architecture showing different handover types (Intra-MAP, Inter-MAP, and Layer 2) in an 802.16e environment with F-HMIPv6.

The Cross-Layer Handover Scheme (CLHS)

To address these latencies, this paper proposes the Cross-Layer Handover Scheme (CLHS). This scheme optimizes the interaction between the 802.16e MAC layer and the Fast Handover for Hierarchical MIPv6 (F-HMIPv6) protocol by bridging the gap between L2 and L3 signaling.

Key Technical Innovations

  • Message Fusion: Correlated messages are combined to reduce overhead. For instance, the L2 neighbor advertisement (MOB_NBR-ADV) is modified to carry L3 network information, effectively eliminating the need for separate L3 router solicitation messages (RtSol/RtAdv).
  • Signaling Interleaving: Instead of waiting for the L2 handover to complete, the MS sends the L3 Fast Binding Update (FBU) simultaneously with the L2 Handover Indication (MOB_HO_IND).
  • Optimized Network Entry: The scheme incorporates a fast network entry procedure that skips redundant steps like contention-based ranging and re-authorization, which are typically the most time-consuming parts of a standard 802.16e handover.
The standard IEEE 802.16e Layer 2 handover procedure, illustrating the sequential steps from topology acquisition to network re-entry.
  • Hierarchical Management: By utilizing a Mobility Anchor Point (MAP), the system distinguishes between "micro-mobility" (moving between base stations in the same subnet) and "macro-mobility," reducing the signaling load on the core network.

Performance Evaluation

The authors evaluated CLHS using extensive simulations in Matlab, modeling the network environment based on IEEE 802.16e PHY/MAC parameters and Poisson distributions for specific delays like Duplicate Address Detection (DAD).

Key Results

The simulation results compared the proposed CLHS against the conventional IETF-proposed FMIPv6 scheme:

  • Handover Latency: CLHS consistently outperformed the standard. For a 20ms frame duration, CLHS reduced handover latency from approximately 1050ms down to roughly 650ms.
  • Service Disruption Time: This is where the scheme provides the most benefit. In a standard setup with a 20ms frame duration, the disruption time was nearly 280ms. Under the proposed CLHS, this was slashed to approximately 60ms.
  • Efficiency: Because CLHS requires fewer total messages to be exchanged over the air, it reduces signaling overhead, which is critical for preserving bandwidth in busy cellular sectors.

Conclusion and Future Work

The CLHS demonstrates that parallelism and cross-layer information sharing can significantly improve mobile network performance. While the current study assumes the target base station is already selected, future research should extend the cross-layer concept to cover the entire handover procedure, including pre-handover triggers and real-world hardware validation to account for physical layer interference and unpredictable network congestion.

Summary updated

Abstract

IEEE802.16e is the major global cellular wireless standard that enables low-cost mobile Internet application. However, existing handover process system still has latency affects time-sensitive applications. In this paper, the handover procedures of 802.16e and Fast Handover for Hierarchical MIPv6 (F-HMIPv6) are reconstructed to achieve a better transmission performance. The concept of cross layer design is adopted to refine the existing handover procedure specified in 802.16e MAC layer and F-HMIPv6. More specifically, layer2 and layer3 signaling messages for handover are analyzed and combined/interleaved to optimize the handover performance. Extensive simulations show that the proposed scheme in this paper is superior to the other scheme proposed by IETF.
BibTeX
@article{zheng2009cross,
  author = {Yi Zheng and Yong Zhang and Yinglei Teng and Mei Song},
  title = {{A Cross-Layer Scheme for Handover in 802.16e Network with F-HMIPv6 Mobility}},
  journal = {Commun. Netw.},
  year = {2009},
  doi = {10.4236/cn.2009.11005},
}
Figure