TL;DR
This study uses an airship to profile aerosol properties within the planetary boundary layer, revealing how changes in atmospheric layers (mixing layer, residual layer) impact aerosol hygroscopicity and composition. The findings highlight the crucial role of nitrate in the developing mixing layer and suggest mineral dust and biological material contribute to non-hygroscopic aerosols, offering a more complete picture of atmospheric aerosol behavior.
What Problem Does This Paper Address?
Understanding how aerosols behave in the atmosphere is critical for climate modeling, as they influence cloud formation, solar radiation scattering, and air quality. The planetary boundary layer (PBL), the lowest part of the atmosphere, is particularly dynamic, with distinct layers (like the well-mixed layer and the residual layer) that can have different aerosol populations. Previous studies often focused on either ground-based measurements or broad airborne surveys, making it challenging to capture the vertical variations and the evolution of aerosol properties within these distinct PBL layers. This paper aims to bridge this gap by providing detailed vertical profiles of aerosol hygroscopicity and composition, specifically examining how these properties change as the mixing layer develops and interacts with the residual layer.
Methods
The researchers employed an airship (Zeppelin NT) as a platform for airborne measurements, allowing for detailed vertical profiling. Key instruments included:
- White-light humidified optical particle spectrometer (WHOPS): This novel instrument was used to measure hygroscopic growth factors (GF) for dry particle diameters of 300 and 500 nm at 95% relative humidity. This allowed for the characterization of how much particles swell in humid conditions.
- Aerosol Mass Spectrometer (AMS): This instrument provided information on the non-refractory chemical composition of the aerosols.
- Aethalometer: This instrument measured equivalent black carbon (eBC) concentrations.
The study also utilized ground-based measurements from Hygroscopicity Tandem Differential Mobility Analyzers (HTDMAs) for comparison. The data analysis involved calculating the hygroscopicity parameter (κ) using the k-Köhler theory, which links particle composition to their water uptake.
Datasets
The study utilized data collected during the PEGASOS field campaigns in 2012, specifically from flights conducted in the Po Valley, Italy, and near Cabauw, Netherlands. Ground-based data from the San Pietro Capofiume (SPC) and Monte Cimone (MTC) sites in Italy, and the Cabauw Experimental Site for Atmospheric Research (CESAR) in the Netherlands were also used.
Key Insights and Ideas
- Layered Atmosphere, Layered Aerosols: The distinct vertical layers within the PBL (newly forming mixing layer, residual layer, and fully developed mixing layer) host aerosols with measurably different hygroscopic properties and chemical compositions. This underscores the importance of vertical profiling.
- Nitrate's Hygroscopic Power: A high nitrate fraction (around 20%) in the newly developing mixing layer was strongly correlated with enhanced hygroscopic growth. This suggests nitrate plays a significant role in aerosol water uptake in these early-morning conditions.
- Non-Hygroscopic Contributors: For particles that don't readily absorb water (GF < 1.1), mineral dust and biological material are identified as likely contributors, particularly in the size range studied (300-500 nm).
- External Mixing is Common: The aerosol population was generally found to be externally mixed, meaning particles of similar size had different chemical compositions and thus varying hygroscopic behaviors.
Key Results
- Po Valley Campaign (Italy):
- The newly forming mixing layer showed a high nitrate fraction (20-22%) and high hygroscopicity (κ ≈ 0.34).
- The residual layer had a low nitrate fraction (~5%) and lower hygroscopicity (κ ≈ 0.19).
- After full mixing, hygroscopicity values became similar across altitudes (κ ≈ 0.18-0.21).
- A significant fraction of particles (22% for 500 nm) were non-hygroscopic (GF < 1.1).
- Netherlands Campaign:
- Airmasses sampled were generally in the fully developed mixing layer or entrainment zone, showing less altitude-dependent variation.
- A higher fraction of particles were hygroscopic (GF > 1.5, ~82%) compared to Italy.
- The mean hygroscopicity parameter (κ) measured by WHOPS was 0.28, higher than in the fully mixed layer in Italy.
- Effective Index of Refraction: Values of 1.43 (Italy) and 1.42 (Netherlands) for 500 nm particles were consistent with air masses dominated by organic compounds.
Limitations and Future Work
- HTDMA Artifacts: The study notes potential underestimation of hygroscopic growth factors from HTDMA measurements due to ammonium nitrate evaporation, especially in the Po Valley.
- Limited Size Range: The WHOPS instrument primarily studied particles up to 500 nm, potentially missing the contribution of larger particles (like sea salt or mineral dust) to overall hygroscopicity.
- Ground vs. Air: While ground-based measurements generally agreed with airborne data for the fully developed mixing layer, inferring altitude-specific data from surface measurements was problematic during the early development of the ML.
- Future Work: The authors suggest that future studies should focus on larger particle sizes to capture a more complete picture of aerosol hygroscopicity. They also highlight the utility of such airborne campaigns for understanding aerosol behavior during PBL development.
Summary updated