Introduction
While Electric Vehicles (EVs) are celebrated for eliminating tailpipe emissions, they face a significant environmental challenge: tire wear. EVs are typically heavier than internal combustion engine vehicles due to substantial battery packs, and their electric motors deliver instant, high torque. This combination accelerates tire abrasion, making tire wear particles (TWP) a leading source of microplastics in the environment.
Current mitigation strategies, such as new tire materials or speed restrictions, often yield marginal benefits or compromise the driving experience. This research proposes a novel hardware-software hybrid control strategy designed to reduce tire emissions by up to 60% while maintaining vehicle stability and performance.
Methodology
Dual-Profile Axles and the Bicycle Model
The proposed approach utilizes a non-uniform tire configuration: "hard" tires (characterized by low wear but lower traction) are installed on the front axle, while "soft" tires (high wear, high traction) are placed on the rear axle.
To analyze the resulting dynamics, the researchers employed a standard 2D bicycle model. This framework accounts for longitudinal and lateral forces, yaw rate, and slip ratio—the discrepancy between wheel speed and actual vehicle speed.
Mathematical analysis indicated that placing hard tires on the front axle is critical. Since steering is the primary mechanism for lateral control, the system can apply steering corrections to compensate for reduced front-axle grip. Placing hard tires on the rear would lead to inherent instability during maneuvers.
Control Algorithm and Optimization
The core of the system is a two-step control scheme:
- Reference Modeling: The system simulates how a "base" vehicle equipped with four high-performance tires would respond to driver inputs.
- Greedy Search Optimization: A greedy local search algorithm determines the optimal torque distribution between axles and calculates a small steering correction ($\Delta\sigma$). This ensures the low-wear vehicle follows the reference trajectory while minimizing total tire particle emissions.
Curvilinear Coordinates
To evaluate the model on complex road geometries, the researchers implemented a curvilinear coordinate system. This tracks the vehicle's position ($n$) and progress ($s$) relative to the road's centerline, rather than a fixed global grid.
Results and Discussion
Emission Reductions and Performance
Simulations demonstrated significant environmental gains. In straight-line scenarios, tire particle emissions were reduced by 48% to 61%. In curved path tests, reductions ranged from 46% to 63%. Crucially, in standard driving conditions (up to 120 km/h), the vehicle's trajectory and acceleration remained virtually indistinguishable from a high-performance base vehicle.
The optimization revealed that minimizing emissions does not necessarily mean zeroing torque on high-wear tires. Due to the non-linear (quadratic) nature of tire emission curves, an optimal distribution exists where both axles share the load to minimize the aggregate particle count.
Safety Considerations
The primary trade-off identified is in extreme safety scenarios. In emergency braking tests, the stopping distance for the low-wear configuration increased by approximately 10% compared to the base vehicle. This is a direct consequence of the lower peak friction coefficient of the hard tires.
Conclusion and Future Work
The proposed control strategy offers a viable path toward sustainable EV operation by significantly extending tire life and reducing microplastic pollution without sacrificing daily drivability. However, the 10% increase in stopping distance necessitates further integration with Advanced Driver Assistance Systems (ADAS).
Future research will explore Reinforcement Learning to enable the controller to adapt to real-time changes in tire characteristics caused by temperature, road surface variations, and aging, thereby enhancing the system's robustness across diverse driving environments.
Summary updated