Using Dual Microresonant Cavity and Plasmonic Effects to Enhance the Photovoltaic Efficiency of Flexible Polymer Solar Cells

Wenfei Shen, Guoqing Zhao, Xiaolin Zhang, Fanchen Bu, Jungheum Yun, Jianguo TangNanomaterials 2020 · DOI

TL;DR

Researchers have developed a novel approach to boost the efficiency of flexible polymer solar cells (PSCs) by combining a specially engineered transparent electrode with plasmonic nanoparticles. This dual strategy significantly enhances light absorption in the thin active layer, leading to a 36.27% increase in power conversion efficiency while maintaining the crucial flexibility of the devices.

What Problem Does This Paper Address?

Flexible polymer solar cells (PSCs) offer exciting possibilities for portable and wearable electronics due to their lightweight and bendable nature. However, achieving high power conversion efficiency (PCE) in these devices has been a significant challenge. This is primarily due to the thinness of the photoactive polymer layer, which limits light absorption. Traditional transparent conductive electrodes (TCEs), like indium tin oxide (ITO), often suffer from reduced conductivity and optical transparency when deposited on flexible polymer substrates, or require high processing temperatures that damage the polymer. While oxide-metal-oxide (OMO) structures have shown promise, further improvements in light harvesting are needed to bridge the efficiency gap between flexible and rigid solar cells.

Methods

The core innovation lies in a multi-pronged approach:

  • Optimized OMO Electrodes: The researchers developed ultrathin, highly transparent, and conductive ZnO/Ag$_{(O)}$/ZnO electrodes. The key here is the introduction of a small amount of oxygen during the silver deposition, which allows for the formation of a continuous silver film at a lower thickness. This "oxygen-doped" silver layer (Ag$_{(O)}$) leads to improved transmittance and lower sheet resistance compared to electrodes with pure silver.
  • Plasmonic Nanoparticles: To further enhance light absorption within the thin active layer, silver nanoparticles encapsulated in silica (Ag@SiO$_{2}$-NPs) were synthesized and incorporated into the photoactive blend. These nanoparticles leverage localized surface plasmon resonance (LSPR) to scatter and concentrate light, effectively increasing the light path and absorption within the active material.
  • Dual Enhancement Strategy: The combination of the OMO electrode and the Ag@SiO$_{2}$-NPs creates a synergistic effect. The OMO electrode acts as a microresonant cavity, trapping light within the active layer. Simultaneously, the plasmonic nanoparticles further enhance light absorption through LSPR. This dual approach aims to maximize light harvesting without compromising the flexibility of the device.
  • Device Fabrication and Characterization: Flexible PSCs were fabricated using an inverted device structure. The performance of devices with varying OMO electrode configurations and Ag@SiO$_{2}$-NP concentrations was systematically studied using current density-voltage (J-V) measurements, external quantum efficiency (EQE) spectra, and photoluminescence (PL) spectroscopy.

Datasets

Not discussed in the paper. The study focuses on experimental fabrication and characterization of solar cell devices.

Key Insights and Ideas

  • Oxygen Doping for Better Electrodes: Introducing a small amount of oxygen during silver deposition in OMO electrodes is a simple yet effective way to achieve continuous, ultrathin metallic films with superior optical and electrical properties. This is crucial for flexible substrates.
  • Synergy of Microcavity and Plasmonics: The combination of the OMO electrode (acting as a microresonant cavity) and plasmonic nanoparticles (Ag@SiO$_{2}$-NPs) creates a powerful synergy for light trapping and absorption. This dual approach is more effective than either method alone.
  • SiO$_{2}$ Encapsulation is Key: Encapsulating silver nanoparticles in SiO$_{2}$ prevents direct contact with the photoactive layer, thereby avoiding exciton quenching and degradation of photovoltaic performance, while still allowing plasmonic effects to enhance light absorption.
  • PL Spectroscopy as a Verification Tool: Photoluminescence (PL) measurements of the active layer with and without nanoparticles confirmed that the Ag@SiO$_{2}$-NPs indeed enhance light absorption, as evidenced by increased PL intensity.

Key Results

  • Optimized OMO Electrode: The ZnO/Ag$_{(O)}$/ZnO electrode achieved a high average transmittance of 93.67% (400-800 nm) and a low sheet resistance of approximately 10 Ω/sq.
  • Enhanced Short-Circuit Current: The optimized flexible PSC with the dual enhancement strategy achieved a significantly increased short-circuit current density (J$_{sc}$) of 17.98 mA cm$^{-2}$.
  • Improved Power Conversion Efficiency (PCE): The optimized flexible PSC demonstrated an average PCE of 8.04%, representing a 36.27% improvement compared to devices using a conventional ITO electrode.
  • Excellent Rollability: The flexible PSCs utilizing the OMO electrodes maintained over 90% of their performance after 100 bending cycles, showcasing excellent mechanical robustness.

Limitations and Future Work

  • Concentration Optimization: While the study optimized the concentration of Ag@SiO$_{2}$-NPs, the paper notes that higher concentrations can lead to aggregation, potentially disrupting the active layer's nanostructure and decreasing efficiency. Further fine-tuning of NP size and distribution could be explored.
  • Rollability Comparison: While the OMO electrodes showed superior rollability compared to ITO, further long-term studies on the stability of the Ag$_{(O)}$ layer under repeated mechanical stress could be beneficial.
  • Exploration of Other Plasmonic Materials/Structures: The study focused on Ag@SiO$_{2}$-NPs. Future work could investigate other plasmonic materials or nanoparticle geometries to potentially achieve even greater light absorption enhancements.
  • Scalability: While the fabrication methods are described as facile, scaling up the production of these OMO electrodes and NP-infused active layers for commercial applications would be a logical next step.

Summary updated

Abstract

Fabricating polymer solar cells (PSCs) on flexible polymer substrates, instead of on hard glass, is attractive for implementing the advantage and uniqueness of the PSCs represented by mechanically rollable and light-weight natures. However, simultaneously achieving reliable robustness and high-power conversion efficiency (PCE) in such flexible PSCs is still technically challenging due to poor light harvesting of thin photoactive polymers. In this work, we report a facile, effective strategy for improving the light-harvesting performance of flexible PSCs without sacrificing rollability. Very high transparent (93.67% in 400-800 nm) and low sheet resistance (~10 Ω sq<sup>-1</sup>) ZnO/Ag<sub>(O)</sub>/ZnO electrodes were implemented as the flexible substrates. In systematically comparison with ZnO/Ag/ZnO electrodes, small amount of oxygen induced continuous metallic films with lower thickness, which resulted in higher transmittance and lower sheet resistance. To increase the light absorption of thin active layer (maintain the high rollability of active layer), a unique platform simultaneously utilizing both a transparent electrode configuration based on an ultrathin oxygen-doped Ag, Ag<sub>(O)</sub>, and film and plasmonic Ag@SiO<sub>2</sub> nanoparticles were designed for fully leveraging the advantages of duel microresonant cavity and plasmonic effects to enhance light absorbance in photoactive polymers. A combination of the ZnO/Ag<sub>(O)</sub>/ZnO electrode and Ag@SiO<sub>2</sub> nanoparticles significantly increased the short-current density of PSCs to 17.98 mA cm<sup>-2</sup> with enhancing the photoluminescence of PTB7-Th film. The flexible PSC using the optimized configuration provided an average PCE of 8.04% for flexible PSCs, which was increased by 36.27% compared to that of the PSC merely using a conventional transparent indium tin oxide electrode.
BibTeX
@inproceedings{shen2020using,
  author = {Wenfei Shen and Guoqing Zhao and Xiaolin Zhang and Fanchen Bu and Jungheum Yun and Jianguo Tang},
  title = {{Using Dual Microresonant Cavity and Plasmonic Effects to Enhance the Photovoltaic Efficiency of Flexible Polymer Solar Cells}},
  booktitle = {Nanomaterials},
  year = {2020},
  doi = {10.3390/nano10050944},
}
Figure